14-16

An administrator issues the ipv6 route 2001:db8:acad:1::/32 gigabitethernet0/0 2001:db8:acad:6::1 100 command on a router. What administrative distance is assigned to this route?

100

Refer to the exhibit. What is the administrative distance value of the route for router R1 to reach the destination IPv6 address of 2001:DB8:CAFE:4::A?

120

Refer to the exhibit. An administrator is attempting to install an IPv6 static route on router R1 to reach the network attached to router R2. After the static route command is entered, connectivity to the network is still failing. What error has been made in the static route configuration?

The interface is incorrect.

What characteristic completes the following statement?When an IPv6 static route is configured, as a backup route to a static route in the routing table, the "distance" command is used with ......

· the "show ipv6 route static" command.

Refer to the exhibit. An administrator is attempting to install a default static route on router R1 to reach the Site B network on router R2. After entering the static route command, the route is still not showing up in the routing table of router R1. What is preventing the route from installing in the routing table?

The next hop address is incorrect.

Refer to the exhibit. How was the host route 2001:DB8:CAFE:4::1/128 installed in the routing table?

The route was manually entered by an administrator.

Refer to the exhibit. A ping from R1 to 10.1.1.2 is successful, but a ping from R1 to any address in the 192.168.2.0 network fails. What is the cause of this problem?

The static route for 192.168.2.0 is incorrectly configured.

What happens to a static route entry in a routing table when the outgoing interface associated with that route goes into the down state?

The static route is removed from the routing table.

What characteristic completes the following statement?When an IPv6 static route is configured, a fully-specified configuration should be used with ......

a directly connected multiaccess network.

What route would have the lowest administrative distance?

a directly connected network

Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5

a static route to the 192.168.10.0/24 network

Which route would have to go down in order for this static route to appear in the routing table? Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5

administrative distance

Which value in a routing table represents trustworthiness and is used by the router to determine which route to install into the routing table when there are multiple routes toward the same destination?

administrative distance

Refer to the graphic. Which command would be used on router A to configure a static route to direct traffic from LAN A that is destined for LAN C?

A(config)# ip route 192.168.4.0 255.255.255.0 192.168.3.2

Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2?

A(config)# no ip route 10.0.0.0 255.0.0.0 172.16.40.2 A(config)# ip route 10.0.0.0 255.0.0.0 192.168.1.2

What is a characteristic of a floating static route?

It is configured with a higher administrative distance than the original dynamic routing protocol has.

Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5How would an administrator test this configuration? Refer to the exhibit. What will router R2 do with a packet destined for 192.168.10.129?

Manually shut down the router interface used as a primary route.

Which route would be used to forward a packet with a source IP address of 192.168.10.1 and a destination IP address of 10.1.1.1?

O 10.1.1.0/24 [110/65] via 192.168.200.2, 00:01:20, Serial0/1/0

Refer to the exhibit. Which static route would an IT technician enter to create a backup route to the 172.16.1.0 network that is only used if the primary RIP learned route fails?

ip route 172.16.1.0 255.255.255.0 s0/0/0 121

A router has used the OSPF protocol to learn a route to the 172.16.32.0/19 network. Which command will implement a backup floating static route to this network?

ip route 172.16.32.0 255.255.224.0 S0/0/0 200

A network administrator configures the interface fa0/0 on the router R1 with the command ip address 172.16.1.254 255.255.255.0 . However, when the administrator issues the command show ip route , the routing table does not show the directly connected network. What is the possible cause of the problem?

The interface fa0/0 has not been activated.

Refer to the exhibit. What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?

ipv6 route 2001:db8:1:4::/64 2001:db8:1:3::2

When would it be more beneficial to use a dynamic routing protocol instead of static routing?

on a network where there is a lot of topology changes

Refer to the exhibit. Which type of IPv6 static route is configured in the exhibit?

recursive static route

On which two routers would a default static route be configured?

stub router connection to the rest of the corporate or campus network edge router connection to the ISP

What characteristic completes the following statement?When an IPv6 static route is configured, it is first necessary to configure ......

the "ipv6 unicast-routing" command.

What characteristic completes the following statement?When an IPv6 static route is configured, the installation of the route can be verified with ......

the "show ipv6 route static" command.

What two pieces of information are needed in a fully specified static route to eliminate recursive lookups?

the interface ID exit interface the IP address of the next-hop neighbor

What characteristic completes the following statement?When an IPv6 static route is configured, it is possible that the same IPv6 link-local address is used for .....

the next-hop address of two different adjacent routers.

Refer to the exhibit. PC A sends a request to Server B. What IPv4 address is used in the destination field in the packet as the packet leaves PC A?

192.168.12.16

What network prefix and prefix-length combination is used to create a default static route that will match any IPv6 destination?

::/0

Refer to the exhibit. HostA is attempting to contact ServerB. Which two statements correctly describe the addressing that HostA will generate in the process?

A frame with the destination MAC address of RouterA. A packet with the destination IP address of ServerB.

Refer to the exhibit. What will the router do with a packet that has a destination IP address of 192.168.12.227?

Send the packet out the Serial0/0/0 interface.

Refer to the exhibit. The Branch Router has an OSPF neighbor relationship with the HQ router over the 198.51.0.4/30 network. The 198.51.0.8/30 network link should serve as a backup when the OSPF link goes down. The floating static route command ip route 0.0.0.0 0.0.0.0 S0/1/1 100 was issued on Branch and now traffic is using the backup link even when the OSPF link is up and functioning. Which change should be made to the static route command so that traffic will only use the OSPF link when it is up?

Change the administrative distance to 120.

Refer to the exhibit. What routing solution will allow both PC A and PC B to access the Internet with the minimum amount of router CPU and network bandwidth utilization?

Configure a static default route from R1 to Edge, a default route from Edge to the Internet, and a static route from Edge to R1.

Refer to the exhibit. This network has two connections to the ISP, one via router C and one via router B. The serial link between router A and router C supports EIGRP and is the primary link to the Internet. If the primary link fails, the administrator needs a floating static route that avoids recursive route lookups and any potential next-hop issues caused by the multiaccess nature of the Ethernet segment with router B. What should the administrator configure?

Create a fully specified static route pointing to Fa0/0 with an AD of 95.

Refer to the exhibit. Which set of commands will configure static routes that will allow the Park and the Alta routers to a) forward packets to each LAN and b) direct all other traffic to the Internet?

Park(config)# ip route 0.0.0.0 0.0.0.0 192.168.14.1Alta(config)# ip route 10.0.234.0 255.255.255.0 192.168.14.2Alta(config)# ip route 0.0.0.0 0.0.0.0 s0/0/0

Refer to the exhibit. The small company shown uses static routing. Users on the R2 LAN have reported a problem with connectivity. What is the issue?

R1 needs a static route to the R2 LAN.

Refer to the exhibit. Which default static route command would allow R1 to potentially reach all unknown networks on the Internet?

R1(config)# ipv6 route ::/0 G0/1 fe80::2

Refer to the exhibit. Which command will properly configure an IPv6 static route on R2 that will allow traffic from PC2 to reach PC1 without any recursive lookups by router R2?

R2(config)# ipv6 route 2001:db8:10:12::/64 S0/0/0

What are two advantages of static routing over dynamic routing?

Static routing is more secure because it does not advertise over the network. Static routing uses fewer router resources than dynamic routing.

Refer to the exhibit. What would happen after the IT administrator enters the new static route?

The 172.16.1.0 route learned from RIP would be replaced with the 172.16.1.0 static route.

What characteristic completes the following statement?When an IPv6 static route is configured, the next-hop address can be ......

an IPv6 link-local address on the adjacent router.

Refer to the exhibit.What does R1 use as the MAC address of the destination when constructing the frame that will go from R1 to Server B?

f the destination MAC address that corresponds to the IPv4 address is not in the ARP cache, R1 sends an ARP request.

Refer to the exhibit. The network engineer for the company that is shown wants to use the primary ISP connection for all external connectivity. The backup ISP connection is used only if the primary ISP connection fails. Which set of commands would accomplish this goal?

ip route 0.0.0.0 0.0.0.0 s0/0/0 ip route 0.0.0.0 0.0.0.0 s0/1/0 10