4. Reading Sectional Chart

(Refer to Figure 22, area 3.) The vertical limits of that portion of Class E airspace designated as a Federal (Victor) Airway over Magee Airport are

1, 200 feet AGL to 17,999 feet MSL.

(Refer to Figure 26, area 2.) You've been asked to inspect the tower 4 to 5 statute miles northwest of Cooperstown airport (S32). How high must the cloud base be for you to be able to fly the maximum allowable height over the tower?

1,150 ft. AGL

(Refer to Figure 21, area 2.) What's the minimum altitude / lowest elevation of the area depicted by the blue line labeled V15?

1,200 ft. AGL

(Refer to Figure 76) What's the minimum altitude / lowest elevation of the area depicted by the blue line labeled V71?

1,200 ft. AGL

(Refer to FAA-CT-8080-2H, Figure 21) You have been hired to inspect a lighted obstruction 14SM SSW of Minot Airport. What is the highest altitude you can fly your UAS up to?

1,431 AGL

(Refer to FAA-CT-8080-2H, Figure 23, area 3.) What is the height of the lighted obstacle approximately 6 nautical miles southwest of Savannah International?

1,534 feet AGL

(Refer to Figure 80) What is the highest terrain elevation in the general area north of Montrose Rgnl (MTJ)?

11,700 ft. MSL

(Refer to Figure 76) What is the CTAF frequency at Pierre Rgnl airport (PIR)?

122.7

(Refer to Figure 59, area 1.) You're hired to inspect a tower by Lenawee County airport (ADG). Which radio frequency would you tune into to listen to manned aircraft chatter from incoming or outgoing pilots?

122.8

(Refer to FAA-CT-8080-2H, Figure 22, area 2.) At Coeur D'Alene which frequency should be used as a Common Traffic Advisory Frequency (CTAF) to monitor airport traffic?

122.8 MHz

(Refer to Figure 78) What is the UNICOM frequency at Sioux Gateway / Col Day airport (SUX)?

122.95

(Refer to Figure 25, area 2.) The control tower frequency for Addison Airport is

126.0 MHz.

(Refer to Figure 69) What is the ATIS frequency at Corpus Christi Intl airport (CRP), and what is ATIS used for?

126.8, and ATIS is a continuous broadcast of recorded aeronautical information in busier airports

(Refer to Figure 25, area 3.) If the tower at Dallas Executive airport (RBD) is not in operation, which radio frequency should an sUAS pilot tune into to listen to local aircraft chatter?

127.25

(Refer to FAA-CT-8080-2H, Figure 20, area 2.) The elevation of the Chesapeake Regional Airport is

19 feet.

(Refer to Figure 25, area 7.) The Class D airspace overlying McKinney (TKI) is controlled from the surface to

2,900 feet MSL

(Refer to FAA-CT-8080-2H, Figure 23, Area 4) What's the required visibility at Plantation (JYL) airport?

3 SM

(Refer to FAA-CT-8080-2H, Figure 80) What's the minimum visibility required at the area surrounding Crawford airport?

3 SM

(Refer to FAA-CT-8080-2H, Figure 21) There's a cluster of towers 13 statute miles south of Minot Airport. What's the height of the tallest tower?

3,147 ft. MSL

(Refer to FAA-CT-8080-2H, Figure 75) What's the minimum altitude you can fly in the quadrangle surrounding Buckeye Airport (BXK) in order to clear all obstacles in that quadrangle?

3,500 ft. MSL

(Refer to FAA-CT-8080-2H, Figure 20, area 3.) Determine the approximate latitude and longitude of Currituck County Airport.

36°24'N - 76°01'W

(Refer to Figure 25, area 4.) The floor of Class B airspace overlying Hicks Airport (T67) northwest of Fort Worth Meacham International airport (FTW) is

4,000 ft. MSL

(Refer to FAA-CT-8080-2H, Figure 26, area 2.) What is the approximate latitude and longitude of Cooperstown Airport?

47°25'N - 98°06'W

(Refer to FAA-CT-8080-2H, Figure 22, area 3.) Determine the approximate latitude and longitude of Shoshone County Airport.

47°33'N - 116°11'W

(Refer to Figure 78) You're inspecting the towers 5 statute miles east of Onawa airport. What is the lowest height the clouds could be for you to be able to legally inspect the top part of the tower?

792 ft. AGL

(Refer to Figure 20, area 1.) You're hired to inspect a group of structures that are under construction 9 statute miles (SM) south of Norfolk Intl airport. What's the highest you're allowed to fly if inspecting the topmost part of the tower?

853 ft. AGL

(Refer to FAA-CT-8080-2H, Figure 23) What's the lower altitude limit of Class E airspace at Statesboro Bulloch County Airport (TBR)?

887 ft. MSL

(Refer to FAA-CT-8080-2H, Sectional Chart Legend) Which is true concerning the blue and magenta colors used to depict airports on Sectional Aeronautical Charts?

Airports with controlled towers are shown in blue.

(Refer to Figure 26, area 4.) You have been hired to inspect the tower under construction at 46.9N and 98.6W, near Jamestown Regional (JMS). What must you receive prior to flying your unmanned aircraft in this area?

Authorization from ATC

(Refer to Figure 26) Which airport is located at approximately 46.93°N latitude and 98.02°'W longitude?

Barnes County

(Refer to Figure 20) You're asked to inspect the high-intensity lighted tower 12 statute miles SE of Lake Drummond. What's the highest you're allowed to fly under Part 107 (as long as you operate within 400 ft. of the tower at all times)?

C) 1,436 ft. AGL

(Refer to Figure 25, area 4.) The airspace directly overlying Fort Worth Meacham International airport (FTW) is

Class D airspace to 3,200 feet MSL.

(Refer to Figure 25, area 8.) What airspace would you be operating in if flying at the maximum allowable altitude while inspecting the towers 9 statute miles SW of Dallas Executive airport (RBD)?

Class E

(Refer to Figure 78) You want to fly as high as allowed under Part 107 over the tower 4 NM NE of Pender Airport. What class airspace would you be operating in at that altitude?

Class E

(Refer to FAA-CT-8080-2H, Figure 21.) What airport is located approximately 47 (degrees) 40 (minutes) N latitude and 101 (degrees) 26 (minutes) W longitude?

Garrison Airport

Which statement about longitude and latitude is true?

Lines of longitude cross the Equator at right angles.

(Refer to FAA-CT-8080-2H, Figure 21, area 2.) Which airport is located at approximately 47°34'30"N latitude and 100°44'00"W longitude?

Makeeff

(Refer to FAA-CT-8080-2H, Figure 78) You're inspecting the railroads from Blencoe to Onawa (about 40 NM SSE of Sioux City). Do you need to request prior airspace authorization?

No, because you're in uncontrolled Class G airspace

(Refer to FAA-CT-8080-2H, Figure 26.) What does the line of latitude at area 4 measure?

The degrees of latitude north and south from the equator.

(Refer to FAA-CT-8080-2H, Figure 20) What does the magenta dashed line labelled 11°W indicate?

The magnetic variation for this area of the Sectional Chart

(Refer to FAA-CT-8080-2H, Figure 20, area 2.) Why would the small flag at Lake Drummond of the sectional chart be important to a remote pilot?

This is a VFR check point for manned aircraft, and a higher volume of air traffic should be expected there.

(Refer to FAA-CT-8080-2H, Figure 20, area 3.) With ATC authorization, you are operating your small unmanned aircraft approximately 4 SM southeast of Elizabeth City Regional Airport (ECG). What hazard is indicated to be in that area?

Unmarked balloon on a cable up to 3,008 feet MSL.

(Refer to FAA-CT-8080-2H, Figure 21, area 3.) Which airport is located at approximately 47°21'N latitude and 101°01'W longitude?

Washburn

(Refer to Figure 78) A railroad company has hired you to inspect its tracks between Hinton and Winnebago. Will you need prior airspace authorization to complete this flight?

Yes, because the tracks pass through Class D controlled airspace.

(Refer to FAA-CT-8080-2H, Figure 23) If you are inspecting the high-intensity lights on top of the towers 5 1/2 nautical miles southwest of Savannah International airport, would you need prior authorization from ATC?

Yes, because you'd be operating in Class C airspace

(Refer to Figure 25, area 4.) You are hired to photograph a home 3 miles northeast of FT Worth Meacham Intl (FTW). Do you need to request ATC permission to fly?

Yes, because you're in Class D airspace.

(Refer to FAA-CT-8080-2H, Figure 21.) One difference between the Minot airport and the Garrison airport is that

the Minot airport has a control tower, but the Garrison airport does not have a control tower

(Refer to FAA-CT-8080-2H, Figure 23.) The flag symbols at Statesboro Bulloch County Airport, Claxton-Evans County Airport, and Ridgeland Airport are

visual checkpoints to identify position for initial callup prior to entering Savannah Class C airspace.