6.3.6 Testout CTI 130

¡Supera tus tareas y exámenes ahora con Quizwiz!

Which of the following are characteristics of coaxial network cable?(Select Two) A) it made of plastic or glass in the center of the cable, B) It has a conductor made from copper in the center of the cable C) It uses two concentric metallic conductors D) it is totally immune to electromagnetic interference E) the conductors within the cable are twisted around each other to eliminate crosstalk.

- It has a conductor made from copper in the center of the cable - It uses two concentric metallic conductors

A tech is replacing a cable modem. The cable from the cable company has an inner solid wire conductor and an outer mesh conductor separated by PVC plastic insulation. Which of the following network cable types is being used? 1)Twisted pair cable 2)Fiber optic cable 3)Coaxial cable 4)Straight- through cable.

3)Coaxial cable

Advantages of using fiber optic cabling for a network(pick two). A- Increase flexibility B- Immunity to electromagnetic interference C- Faster installation D- Lower installation cost E- Greater cable distances w/out a repeater

B- Immunity to electromagnetic interference E- Greater cable distances without a repeater

Which of the following BEST describes the type of cable configuration and the purpose for which it should be used? Look up the image**

Crossover cable configuration used to connect computers directly to one another for networking

What is a major benefit STP provides that UTP does not? 1)Greater resistance to interference 2)Ability to install longer cable lengths 3)lower cost 4)safer for installations in overhead ceiling spaces.

Greater resistance to interference

You are using a crimper to attach an RJ-45 connector to a Cat 6 UTP cable. You need to use the T568A standard to connect the individual wires to the connector. Which wire should be connected to pin 1? 1)Green 2)green w/ white 3)orange w/ white 4)blue

Green with white

A technician must press a cable connector's retaining tab to remove a faulty fiber optic network cable Which of the following connectors does the cable use? 1)RJ45 2)RJ11 3)LC 4)ST

LC

A technician connects two network switches using a twisted pair cable. Neither switch support auto-up-linking. Which of the following identifies the TIA wiring standard required on each end of the cable? 1)both ends must only be T568B 2)one end must be T568A and the other must be T568B 3)both ends must only be T568A

One end must be T568A, and the other must be T568B

You are installing networking cable in the air space between the ceiling and the roof of a building. Which type of should you use? 1)Plenum 2)PVC 3)Multi-mode fiber 4)STP

Plenum

A technician is running a network above a dropped ceiling that is also used for ventilation. The cable must be twisted pair and must be capable of Gigabit Ethernet speeds.Which of the following cables should be used? 1)Riser-Rated RG-58 2)Plenum-rated CAT-6a 3)Plenum-rated multi-mode fiber 4)Riser-rated CAT-5e

Plenum-rated CAT-6a

A tech is installing a cable modem that supplies internet for a home office. Which of the following cabling types would be used to connect the cable modem to the cable wall outlet? 1)RG6 2)Multi-mode fiber 3)CAT 5e 4)CAT 6a

RG6

Which kind of connector do you use to connect a modem to a standard telephone line? 1)RJ11 2)RG58 3)F-type 4)RJ45

RJ11

Which connector is used with unshielded twisted pair (UTP) cable? 1)BNC 2)DIX 3)AUI 4)RJ45

RJ45

You have recently been called to troubleshoot network connectivity problems at a user's workstation. You found that the network cable runs across high traffic areas on the floor, causing the cable to wear through and break. You have replaced the cable with a plenum-rated and shielded twisted pair cable. You would like to minimize the problem and prevent it from happening again.Which of the following will best protect the cable from further damage?

Run the cable through the ceiling area instead of across the floor

Match the fiber optic cables on the left with the appropriate characteristics on the right 1)Multi-mode 2) Single mode _____Data transfer through the core using more than one light rays. _____The core diameter is around 10 microns _____Cable lengths can extend a great distance _____Cable lengths are limited in distance

_1____Data transfer through the core using more than one light rays. __2___The core diameter is around 10 microns __2___Cable lengths can extend a great distance __1___Cable lengths are limited in distance


Conjuntos de estudio relacionados

SEVERE WEATHER -HOMEWORK NUMBER 2

View Set

Institutional Responsibilities as They Affect Investigators (COI-Basic)

View Set