CCNA Group Quiz

How does standby preemption affect the router configured with the highest priority in the HSRP group? (Select two.)

If the active router fails, and preemption is enabled, then it becomes the active router again If the active router fails, and preemption isn't enabled, then it does not becomes the active router again

Which of the following are true regarding using multiple VLANs on a single switch? (Select two.)

Increased Broadcast domains Collision Domains remain the same

Which of the following are reasons to configure VLANs on a switch as opposed to using switches without VLANs? (Select two.)

Increased Security Increased number of Broadcast Domain

Which of the following does not accurately describe the HSRP states?

Learn is when the HSRP router is actively listening for the virtual IP address through hello messages sent by the active router

You have two VLANs and two Cisco 1841 routers as shown in the exhibit.How can you configure HSRP to share the load from the two VLANs? (Select two.)

Router A is the active router for VLAN 2 and the standby router for VLAN 4 Router B is the active router for VLAN 4 and the standby router for VLAN 2

Which of the following protocols provide gateway redundancy? (Select all that apply.)

HSRP and VRRP

You have two switches connected together as shown in the following diagram. How many broadcast domains are there in the network shown?

2 Broadcast Domains

Which of the following is required before you can create an SVI?

A VLAN in the VLAN database

Computers A and B are on the same VLAN and are separated by two switches, as shown in the Exhibit. Computer A sends a frame to Computer B. Which of the following best describes the composition of the frame as it travels from A to B?

Computer A sends a normal frame. The first switch Encapsulates a VLAN ID. The second switch decapsulates the VLAN ID. Computer B recieves a normal frame.

You have configured inter-VLAN routing on a Catalyst 3550 switch. Hosts belonging to VLAN 2 cannot contact servers belonging to VLAN 3. To troubleshoot the issue, you enter the show ip route command and receive the output as shown in the exhibit.Which of the following may be true? (Select two.)

The VLAN 2 interface is not enabled The VLAN 2 interface does not have an IP address

Which of the following best describes the various HSRP group roles? (Select two.)

The active router forwards traffic destined for the virtual IP address The backup router becomes the active router if the current active router fails.

You have configured inter-VLAN routing on a Catalyst 3550 switch. You enter the show ip route command and receive the output as shown in the exhibit.Which of the following is true? (Select two.)

Traffic sent from VLAN 2 to VLAN 3 will not reach VLAN 3 Interface VLAN 2 is enabled with the no shutdown command