CTS1650 (CISCO 1 ch.4 quiz)

A network administrator notices that some newly installed Ethernet cabling is carrying corrupt and distorted data signals. The new cabling was installed in the ceiling close to fluorescent lights and electrical equipment. Which two factors may interfere with the copper cabling and result in signal distortion and data corruption? (Choose two.)

-EMI -RFI​

What are two services performed by the data link layer of the OSI model? (Choose two.)

-It accepts Layer 3 packets and encapsulates them into frames. -It provides media access control and performs error detection.

A network administrator is designing the layout of a new wireless network. Which three areas of concern should be accounted for when building a wireless network? (Choose three.)

-interference -coverage area -security

What are two examples of hybrid topologies? (Choose two.)

-partial mesh -extended star

What are two reasons for physical layer protocols to use frame encoding techniques? (Choose two.)

-to identify where the frame starts and ends -to distinguish data from control information

Refer to the exhibit. The PC is connected to the console port of the switch. All the other connections are made through FastEthernet links. Which types of UTP cables can be used to connect the devices?​

1 - rollover, 2 - straight-through, 3 - crossover

Match the characteristics to the correct type of fiber. (Not all options are used.) 1. Multimode Fiber 2. Single-mode Fiber

1. - generally used with LANs - several paths of light into the fiber - LED as light source 2. - laser as light source - only one ray of light into the fiber - generally used for campus backbone

Which statement describes an extended star topology?

End devices connect to a central intermediate device, which in turn connects to other central intermediate devices.

What is one advantage of using fiber optic cabling rather than copper cabling?

It is able to carry signals much farther than copper cabling.

What is true concerning physical and logical topologies?

Logical topologies refer to how a network transfers data between devices.

Which type of connector does a network interface card use?

RJ-45

As data travels on the media in a stream of 1s and 0s how does a receiving node identify the beginning and end of a frame?​

The transmitting node inserts start and stop bits into the frame.

Refer to the exhibit. What is wrong with the displayed termination?

The untwisted length of each wire is too long.

Why are two strands of fiber used for a single fiber optic connection?

They allow for full-duplex connectivity.

Which layer of the OSI model is responsible for specifying the encapsulation method used for specific types of media?

data link

What is contained in the trailer of a data-link frame?

error detection

Which method of data transfer allows information to be sent and received at the same time?

full duplex

What is the definition of bandwidth?

the amount of data that can flow from one place to another in a given amount of time

Which characteristic describes crosstalk?

the distortion of the transmitted messages from signals carried in adjacent wires

What is indicated by the term throughput?

the measure of the bits transferred across the media over a given period of time

What is a role of the Logical Link Control sublayer?

to mark frames to identify the network layer protocol being carried

What is the function of the CRC value that is found in the FCS field of a frame?

to verify the integrity of the received frame

What technique is used with UTP cable to help protect against signal interference from crosstalk?

twisting the wires together into pairs