HMMS AH-64E

With the TRAIN mode selected and a weapon system is actioned the weapons inhibit field will display _________ .

Training.

During a remote designation employing the AGM-114K the remote designator must be positioned outside of the ± ____ ° safety fan either side of the Gunner-Shot Line (GSL).

± 43 Degrees.

The SAL missile LOBL constraints symbology represents ± _____ degrees and is being driven by the _______ _______ in the crewmembers display.

±20, missile seeker

The missile quantity defaults to ______ for both channels if sufficient missiles are available of the selected warhead.

3

The RF missiles can overheat (OT) if it is radiating (tracking) a target for more than ______ minutes.

3 minutes

To prevent video washout by the missile exhaust the aircraft should be oriented to ______° to ______ ° to the side from which the missile will be launched.

3 to 5 degrees

For an autonomous engagement, the aircraft should be oriented ___º to ___º to the side from which the missile will be launched.

3 to 5 degrees.

The TME allows for thermal management of the missiles by allowing for a cumulative time on of _____ minutes.

30 minutes.

What is the minimum altitude to launch a SAL missile?

32 Feet

The AGM-114R's minimum arming distance is ______ meters.

375 meters

The minimum engagement range to fire an AGM-114K or AGM-114R missile employing the LOBL trajectory is ______ meters with a maximum range of ______ km.

500 Meters / 7.1 kilometers

At a range of ______ to ______ meters, targets are too close for a LOAL engagement and a "NO ACQUIRE" message will be displayed.

500 to 1000 Meters.

When laser designating a 5000 meter target for the AGM-114R missile, the last _____ seconds of the TOF is required to be on the target.

6 seconds. (terminal guidance)

The remote designator should not be displaced more than _____ degrees in azimuth from the launch aircraft to target line.

60 degrees.

When the thrust of the missile exceeds ____ to ____ pounds, the missile will launch from the rail.

600 to 830 Pounds

What are the three LOAL trajectory modes in which the AGM-114R missile can be employed?

DIR, FLAT, and LOFT

In the pre-launch mode, what are the three methods of target handover to the RF missile?

FCR, TADS, and IDM (RFHO).

Which LOAL trajectory should be used to engage a bunker when firing an AGM-114R missile?

FLAT

The AGM-114R missile thrust duration is approximately 2.5 to 3.5 seconds and reaching a maximum velocity of _________.

435 m/s or (845 Knots)

The AGM-114L allowable constraints is ± _____ degrees when tracking the NTS target when the range is less than one kilometer.

5 degrees

What are the normal pylon articulation limits when the missiles or rockets are actioned?

+4º to -15º

What is the RF missile radiation hazard area to be avoided?

1 meter 45º

Doppler Beam Sharpening (DBS) uses a curved trajectory to induce a relative motion for stationary targets (STI) to enhance the probability of detection and tracking between what ranges?

2500 to 8000 Meters.

The Ripple mode, after the primary channel missile is launched the alternate channel missile may be launched after ______ seconds separation.

1.5 Seconds.

3.The fuze contains the ARM/SAFE device that arms the missile when its launch acceleration exceeds approximately ____ g's.

10 g's

In the AUTO power mode the missiles are powered-up at _____ minute intervals.

10.

Five kilometer engagement, the maximum separation between targets should not exceed ______ meters, with an _____ second separation between missile launches.

100 Meters. 8 Seconds.

What is the Tri-Service PRF code range?

1111 through 1788 1st digit ONLY "1" 2nd digit "1 - 7" 3rd & 4th digit "1 - 8"

The AGM-114K2 arms approximately _____ meters from the launching aircraft.

181 meters

With 6 AGM-114L missiles loaded the AUTO power mode selection will power-up _____ RF missiles.

2

When the TADS LOS and the missile seeker LOS differ by more than _____ degrees a BACKSCATTER message will be displayed in the weapons inhibit section of the HAD.

2 Degrees.

What does the message "ALT LAUNCH" mean?

A Rocket Launch is in progress. Missiles are inhibited from firing for 2 seconds.

The ________ _________button is used to maintain the AGM-114R missile in a LOAL flight trajectory.

A: LOBL INHIBIT (L5) (Autonomous mode - DIR/LOFT/FLAT) (Remote mode - DIR only) (LOFT/FLAT locked out for 1.3 seconds when fired remote)

The AGM-114L missile MODE selections are ________ in each crew station.

Common.

What negative factor during target illumination will cause the laser energy to be masked within the target?

Entrapment.

A SAL missile that has not been coded will display an ___ inside the missile icon?

L

Which component of the M299 launcher contains the Training Missile Emulator (TME) which replicates RF missile operation?

Launcher Electronic Assembly

A hang fire will display ______ in the missile icon and the message HANGFIRE will be displayed in the weapon status section of the high action display for six seconds.

MH.

When a M36 training missile is detected all live missile on board the aircraft will display _____ in the missile icon.

NA

When in the training mode all tactical missiles will display ____ inside the missile icon.

NA.

A RF missile that has an over temperature condition will display ____ in the missile icon.

OT.

What inhibits can be overridden, and how is this accomplished?

Performance, 2nd Detent.

The ALT channel selection is only available after a _____ channel has been selected.

Priority channel

The message BACKSCATTER displayed in the weapons inhibit section of the HAD is a safety inhibit and the missile cannot be launched by squeezing the weapons trigger to the second detent. (TRUE/FALSE)?

TRUE.

The three RF missile acquisition modes are ________, ________, and ________.

Terminal Track Acquisition, Pre-Terminal Track Acquisition, and Moving Target Acquisition.

Is the message "BACKSCATTER" a safety or performance inhibit?

SAFETY INHIBIT

What is the primary difference between the SAL and RF missiles?

SAL tracks Laser energy (passive) and the RF tracks reflected RF energy (active). Guidance Section.

The AGM-114R missile main warhead defaults at power-up for anti-armor with the fuze selection of _____.

SQ (Discrete code of 1755)

Name the three RF missile modes.

STBY, Pre-Launch, and Post-Launch.

Transfer alignment occurs in the _____ missile mode.

STBY.

The AGM-114R LOFT constraints box is being driven in the crewmembers display by the _______ or _________.

Stored coordinate data at (R6) or SEL LOS

With the TRAIN mode selected and the missile system is actioned, the missile constraints box will display a ______ centered in the box.

T

Maximum autonomous designation range is limited by the ____.

TADS ability to maintain the total laser spot on the target.

RF missile icons have a ______ instead of a straight line at the seeker.

V. (SAL MSL Line)

Which MPD page allows the aircrew to electronically arm the M299 missile launcher?

WPN UTIL

2nd TARGET INHIBIT selection is used for engagements against _______ targets only.

stationary