Onshape Section 4 test (Revolve and Pattern)

Which feature would you most likely use to create the holes shown in the image?

Circular Pattern

Which check box in the Circular Pattern tool do you select so that the number of instances will always be evenly distributed?

Equal Spacing

A Shell Feature can only be used to create shells with a uniform thickness. Any walls that you want to give different thicknesses to will need to have material added or removed afterward.

FALSE

A temporary axis is automatically created by Onshape for any part that has a circular edge or face.

FALSE

If there is an existing centerline in a sketch, like the one in the sketch shown, then Onshape will automatically pre-select it as the revolve axis of a Revolved feature regardless of its position or orientation.

FALSE

User-created reference planes must reference the default top, left and right planes.

FALSE

When you select multiple edges to Chamfer, a flag is displayed on each edge and each one can be given individual Chamfer dimensions

FALSE

You can only select one face at a time when creating a Shell Feature.

FALSE

Which of the following can NOT be edited while using the Rib tool?

Fillet Radius

Which of the following is NOT a Plane Type in Onshape?

Perpendicular

This feature is an example of a(n) ________.

Revolve

To create the geometry shown in the image, where each wall has equal thickness, in the fewest number of mouse clicks, use the _____ Feature.

Shell

Which option needs to be selected from the Revolve Type drop-down list to revolve the sketch shown evenly on both sides of the sketch plane?

Symmetric

The Hollow option in the Shell tool allows you to create closed, thin-wall models like the images shown here. (Note: Section View used to show inside of cube.)

TRUE

True or False: A Chamfer can be applied to an edge or a face.

TRUE

True or False: It is possible to add material to a part using a Chamfer feature.

TRUE

You can create a plane at an offset distance by selecting a plane or a planar face as the reference.

TRUE

The design intent of this part requires that the sketched circle be vertically aligned to the origin. Does the image shown indicate that this design intent has been achieved?

Yes

Which check box is selected to make sure that patterned instances are created on both sides of the original hole in the middle?

centered