Quiz - Module 12 - Implement Virtualization with Hyper-V and Azure

An Operating System (OS) has already been installed on a Hyper-V Virtual Machine hard disk. In the BIOS settings of the VM, which one of the following should be first on the Startup/Boot order list so that the VM will not attempt to boot from a CD?

IDE

Which type of hypervisor, or the virtualization software component that creates and monitors the virtual hardware environment, is typically found in a production system?

Type 1

Which one of the following is NOT correct about the Firmware settings of a generation 2 VM?

You cannot set the boot order on a generation 2 VM

The difference between an external and internal virtual switch is that when connected to an internal switch the _______ doesn't have a connection to the physical network switch.

host virtual NIC

NIC teaming supports _______ and ________ to share the bandwidth equally among four VMs.

load balancing, fault tolerance

Azure VMs are built with three categories of disk storage. Among them, ______ are stored on the system hosting the VM itself.

temporary disks

Four VMs are connected to an external virtual switch that is mapped to a 1 Gbps physical NIC on the host computer. What should the minimum and maximum bandwidth settings be in the Bandwidth Management section of the VM Network Adapter settings to share the bandwidth equally?

0, 250

Which one of the following statements is NOT correct about a pass-through disk?

A pass-through disk is a virtual disk in the offline state 'that is attached to the host

Which one of the following statements is NOT correct?

A virtual machine needs to be shut down before you can change its network connection from an internal switch to a private switch

Which one of the following is most correct about modifying a virtual disk?

After expanding a virtual disk, you may extend the volume to use the additional space

Which virtual switch should a VM connect with if the VM will be used as any other network-attached device on the physical network?

An external virtual switch

In a production environment, a VM starts with the host computer only if the VM was running when the host or Hyper-V service was last running. Which Automatic Start Action of the VM settings should be enabled?

Automatically start if it was running when the service stopped

The IT staff need the ability to recreate the condition of a running VM for troubleshooting purposes. How should they configure the Checkpoints settings of the VM?

Check Enable checkpoints and then Standard checkpoints

Which of the Azure VM data disk options is best for applications that require high-performance data access?

Premium SSD

Which NIC teaming method doesn't require NICs that are members of Teaming to be connected with the same switch?

Switch Independent