CCNA1 - Chapter 4
Refer to the exhibit. The PC is connected to the console port of the switch. All the other connections are made through FastEthernet links. Which types of UTP cables can be used to connect the devices?
1 - rollover, 2 - straight-through, 3 - crossover
A network administrator notices that some newly installed Ethernet cabling is carrying corrupt and distorted data signals. The new cabling was installed in the ceiling close to fluorescent lights and electrical equipment. Which two factors may interfere with the copper cabling and result in signal distortion and data corruption? (Choose two.)
EMI RFI
Which statement describes an extended star topology?
End devices connect to a central intermediate device, which in turn connects to other central intermediate devices.
What are two services performed by the data link layer of the OSI model? (Choose two.)
It accepts Layer 3 packets and encapsulates them into frames. It provides media access control and performs error detection.
What is one advantage of using fiber optic cabling rather than copper cabling?
It is able to carry signals much farther than copper cabling.
What is true concerning physical and logical topologies?
Logical topologies refer to how a network transfers data between devices.
Match the characteristics to the correct type of fiber. (Not all options are used.)
Multimode Fiber: LED as light source several paths of light into the fiber generally used with LANs Single-mode Fiber: only one ray of light into the fiber generally used for campus backbone laser as light source
Refer to the exhibit. Which statement describes the media access control methods that are used by the networks in the exhibit?
Network 1 uses CSMA/CD and Network 3 uses CSMA/CA.
Which type of connector does a network interface card use?
RJ-45
As data travels on the media in a stream of 1s and 0s how does a receiving node identify the beginning and end of a frame?
The transmitting node inserts start and stop bits into the frame.
Fill in the blank. (1)
The term __bandwidth__ indicates the capacity of a medium to carry data and it is typically measured in kilobits per second (kb/s) or megabits per second (Mb/s).
Refer to the exhibit. What is wrong with the displayed termination?
The untwisted length of each wire is too long.
Why are two strands of fiber used for a single fiber optic connection
They allow for full-duplex connectivity.
Fill in the blank.(2)
What acronym is used to reference the data link sublayer that identifies the network layer protocol encapsulated in the frame? __LLC__
Which layer of the OSI model is responsible for specifying the encapsulation method used for specific types of media?
data link
What is contained in the trailer of a data-link frame?
error detection
Which method of data transfer allows information to be sent and received at the same time?
full duplex
A network administrator is designing the layout of a new wireless network. Which three areas of concern should be accounted for when building a wireless network? (Choose three.)
security interference coverage area
Which characteristic describes crosstalk?
the distortion of the transmitted messages from signals carried in adjacent wires
What is indicated by the term throughput?
the measure of the bits transferred across the media over a given period of time
What are two reasons for physical layer protocols to use frame encoding techniques? (Choose two.)
to distinguish data bits from control bits to identify where the frame starts and ends
20. What is the function of the CRC value that is found in the FCS field of a frame?
to verify the integrity of the received frame
What technique is used with UTP cable to help protect against signal interference from crosstalk?
twisting the wires together into pairs
