Cisco 2 Quiz 6.4.4
Which two protocols are link aggregation protocols?(Choose two)
-PagP -802.3ad
When a range of ports is being configured for EtherChannel, which mode will configure LACP so that it initiates the EtherChannel negotiation?
Active
Which function is provided by EtherChannel?
creating one logical link by using multiple physical links between two LAN switches
When a range of ports is being configured for EtherChannel, which mode will configure PAbP so that it initiates the EtherChannel negotiation?
desirable
What are three advantages of using EtherChannel technology?
-Configuration tasks can be done on the etherChannel interface -There is no need to upgrade links to faster connections to increase bandwidth. -A spanning tree recalculation is not required when a single link within the channel goes down.
Which two mode combinations would result in the successful negotiation of an EtherChannel?
-desirable; desirable -active; passive
Which two load balancing methods can be implemented with EtherChannel technology?
-source IP to source IP -source MAC to destination MAC
WHen the EtherChannel is implemented, multiple physical interfaces are bundled into which type of logical connection?
Port Channel
When a range port is being configured for the EtherChannel by the use of PAGP, which mode will form the bundled channel only if the port receives PAGP packets from another device?
auto
Which statement is true about EtherChannel technology?
EtherChannel uses existing switch ports
An etherChannel link using LACP was formed between two switches, S1 and S2. While verifying the configuration, which mode combination could be utilized on both switches?
S1-passive and S2-active
A network administrator is configuring an EtherChannel link between two physical ports on a switch. Which statement describes the result when one of the physical ports fails?
The EtherChannel continues transmitting data with reduced bandwidth.
What will happen if a network administrator puts a port that is part of an EtherChannel bundle into a different VLAN than the other ports in that bundle?
The EtherChannel will fail
Which three interface parameters must match for an EtherChnnael to form?
native vlan, trunking mode and allowed vlans
When a range of ports is being configured for EtherChannel, which mode will configure LACP on the port only if the port receives LACP packets from another device?
passive