Julien final review
Media Description: A screen capture of configuration and verification commands is shown as follows:R1# configure terminal Enter configuration commands, one per line. End with CNTL/Z. R1(config)# ipv6 unicast-routing R1(config)# ipv6 dhcp pool ACAD_CLASS R1(config-dhcp)# dns-server 2001:db8:acad:a1::10 R1(config-dhcp)# domain-name netacad.net R1(config-dhcp)# exit R1(config)# interface gigabitEthernet 0/0 R1(config-if)# ipv6 address 2001:db8:acad:1::1/64 R1(config-if)# ipv6 dhcp server ACAD_CLASS R1(config-if)# ipv6 nd other-config-flag R1(config-if)# end R1# R1# show ipv6 dhcp pool DHCPv6 pool: ACAD_CLASS DNS server: 2001:DB8:ACAD:A1::10 Domain name: netacad.net Active clients: 0 R1# Refer to the exhibit. A network administrator is configuring a router as a DHCPv6 server. The administrator issues a show ipv6 dhcp pool command to verify the configuration. Which statement explains the reason that the number of active clients is 0? 1. The default gateway address is not provided in the pool. 2. No clients have communicated with the DHCPv6 server yet. 3. The IPv6 DHCP pool configuration has no IPv6 address range specified. 4. The state is not maintained by the DHCPv6 server under stateless DHCPv6 operation
4. The state is not maintained by the DHCPv6 server under stateless DHCPv6 operation
4. because VLAN 99 needs to be entered as a VLAN under an interface before it can become an active interface 5. because the VLAN 99 has not been manually entered into the VLAN database with the vlan 99 command
Refer to the exhibit. Based on the exhibited configuration and output, what are two reasons VLAN 99 missing? (Choose two.) 1. because there is a cabling problem on VLAN 99 2. because VLAN 99 is not a valid management VLAN 3. because VLAN 1 is up and there can only be one management VLAN on the switch 4. because VLAN 99 needs to be entered as a VLAN under an interface before it can become an active interface 5. because the VLAN 99 has not been manually entered into the VLAN database with the vlan 99 command
