PADI Open Water Diver Final Assessment
Refer to the regulator picture on the right. Each regulator part has a number next to it. Please choose the correct numeric order from the choices below
1. Regulator first stage, 2. regulator second stage, 3. alternate air source second stage, 4. low pressure inflator hose for the BCD, 5. instrument console/gauges/computer
Unless there are laws that say differently, I should stay within _____ of my dive flag
15 m/50 ft
I make two dives in one day and am flying home on a commercial plane. I should wait until my computer says I can fly or _____ hours, whichever is longer
18
As a new PADI Open Water Diver, the recommended maximum depth is _____, or the actual depth I reach in training, If shallower. The maximum depth for all recreational scuba divers, even experienced divers is _____
18 m/60 ft // 40 m/130 ft
If my cylinder of air lasts 60 minutes while I am at the surface breathing normally, assuming all else is the same, how long will it last at 20 m/66 ft breathing normally?
20 minutes
My buddy and I are planning to dive at a site where the water and air temperature are near freezing. We plan to dive to 18 metres/60 for 30 minutes. What dive profile would we use when planning our dive?
22 metres/70 feet for 30 minutes
I am planning to make 2 dives. The first dive is to 18 m/60 ft for 24 minutes. How long would I have to stay on the surface to do these 2 dives safely?
32 minutes
I dive to 18 m/60 ft for 33 minutes. After a 30-minute surface interval, I plan to dive to 17 m/58 ft. What is the maximum allowable time for the second dive?
32 minutes
I am an Advanced Open Water Diver. I plan to do three dives. The first dive is a 25-metre/80-foot dive for 22 minutes followed by a 52-minute surface interval. The second dive is to 20 metres/70 feet for 27 minutes followed by a surface interval of 62 minutes. My third dive is to 18 metres/60 feet. What would be my maximum allowable bottom time for this third dive?
34 minutes
If I am not able to equalize my body air spaces, it may be because I have...
A cold, allergy or another medical problem
I dive to 17 metres/56 feet for 47 minutes. After a 30-minute surface interval I do a second dive to 17 metres/56 feet. Losing track of time, I notice my bottom time is now 25 minutes. According to the General Rules, what should I do?
Ascend (go up) right away to 5 metres/15 feet and stay there for at least 8 minutes before going to the surface, and not dive for six hours
If my computer fails during a dive, I can use my backup computer to continue the dive. If I'm not wearing a backup I should...
Ascend , make a safety stop, and end the dive
Divers who act foolishly at depth due to gas narcosis may start acting normally again if they...
Ascend to a shallower depth
Although it shouldn't have happened, on a dive I fail to watch my SPG and run out of air. If my buddy is close by, my best option is to _____. Another option is to _____, if I'm in shallow water and the surface is closer than my buddy
Ascend using my buddy's alternate air source/make a controlled emergency swimming ascent
I turn a glass upside down, trap the air in it by putting it in water, and then I take the glass down to 10 m/33 ft. The air space would...
Become half the size it was at the surface
If I think I have decompression sickness I should...
Breathe 100% Oxygen and contact emergency medical care
As I descend, my wet suit will...
Compress from water pressure, and I will lose buoyancy and warmth
I feel a mild current at the start of my dive. How should I begin this dive?
Dive against or into the current
I am likely to increase the risk of decompression sickness (DCS) if I...
Dive while tired, cold, sick, thirsty or injured
When making computer assisted dives...
Each diver needs a personal computer
If an object is neutrally buoyant in fresh water, the same object placed into salt water would...
Float
I know I am properly weighted for diving if I...
Float at eye level while holding a normal breath of air and with an empty BCD
If I accidently exceed my computers no stop limits, I should...
Follow the computer's instructions for decompression
The difference between DIN values and yoke valves is that DIN valves...
Have threaded openings to screw the regulator into
If my regulator begins to free flow while underwater, I should...
Hold the regulator without sealing my mouth around the mouthpiece and "sip" the air I need as I ascend
Lung overexpansion injuries can be caused by...
Holding my breath while scuba diving
If my ears or sinuses hurt while I am descending, it usually means...
I am feeling a squeeze and need to equalize
When diving at an altitude above 1000 feet...
I need to follow special procedures and may need to set my computer for the altitude
If I'm diving in cold water or under strenuous conditions...
I should add an extra safety margin and stay will within my computers limits
I am most likely to become confused about which way is up or down...
In midwater
The best place for me to position an alternate air source is...
In the triangle area formed by my chin and the lower corners of my rib cage
It's important that I do not turn off a dive computer between dives because...
It would lose memory of the previous dive and not calculate repetitive dives correctly
Which of the following is not part of proper care for my scuba cylinder?
Keep some air in it
When I look at things underwater they often seem _____ than they look on the surface
Larger and/or nearer
Choose the best answer for the signal shown from the choices provided
Low on air
Choose the best answer for the signal shown from the choices provided
Okay? Okay
How often should I take my scuba cylinder to be visually inspected by my dive center?
Once a year
A group of Advanced Open Water Divers plans to make two dives. The first dive is on a reef in 22 metres/80 feet of water for 20 minutes. The group then remains on the surface for 1 hour. The second dive is on a wreck in 18 metres/60 feet of water, with a planned bottom time of 30 minutes. What will be the ending pressure group after the second dive?
R
The first step I using my dive computer is...
Reading the manufacturer's instructions
I should have cylinders filled at a dive center I trust, not use air that tastes or smalls bad, nor use air from a compressor designed to fill car tires. This is important to...
Reduce the risk of breathing contaminated air
If I were separated from my buddy, the general procedure is to...
Search for a minute and then go up to reunite with my buddy at the surface
Choose the best answer for the signal shown from the choices provided
Share air
A diver at the surface is moving quickly and jerkily, has the mask off the face, the regulator/snorkel is out of the mouth, and the diver does not respond to directions. The diver is...
Showing signs of distress (trouble)
Choose the best answer for the signal shown from the choices provided
Something is wrong
_____ travels faster in water than it does in air. This is why you cannot easily tell where it comes from
Sound
If I work too hard and find it difficult to breathe underwater, I should...
Stop all activity and rest, holding onto something for support if possible
Choose the best answer for the signal shown from the choices provided
Stop, hold it, stay there
I am close to my buddy and realize I am out of air. The best response is to...
Switch to my buddy's alternate air source
I blow up a balloon, tie it off, and take it to the bottom of the swimming pool. What will happen to the balloon and the air inside it?
The balloon will get smaller and the air inside the balloon will be more dense
When planning a diver with a computer, I use the "plan" or "no-stop scroll" mode to determine...
The maximum allowable time limits for depths in 10' increments
There is an injured diver who is out of the water and is not responding to touch or my voice. The first thing to do would be...
To check if the diver is breathing
Most injuries caused by aquatic animals happen because the animals are...
Trying to defend themselves
What the bottom is made of can cause big changes in...
Visibility