A Mod 15 IP Static Routing HW Homework in Homework

Which IPv4 static route statement is true?

Using the exit interface only is common in a point-to-point configuration

What type of static route is created when the next-hop IP address and exit interface are specified?

fully specified static route

What network address and subnet mask combination would be used to create a default static route that matches any IPv4 destination?

0.0.0.0 0.0.0.0

What is the purpose of a floating static route?

It allows an alternate connection to be used when the preferred link fails

What is a characteristic of a default static route? ​

It identifies the gateway IP address to which the router sends all IP packets for which it does not have a learned or static route

Which IPv6 static route would serve as a backup route to a dynamic route learned through OSPF?

Router1(config)# ipv6 route 2001:db8:acad:1::/32 2001:db8:acad:6::2 200

A network administrator configures a router by the command ip route 0.0.0.0 0.0.0.0 209.165.200.226. What is the purpose of this command?

To provide a route to forward packets for which there is no route in the routing table

A network administrator uses the command ip route 172.18.0.0 255.255.0.0 S0/0/1 to configure a floating static route on a router. That route will function as a backup route to reach the EIGRP learned network 172.18.0.0/16. After this configuration, the EIGRP route is removed from the routing table even though EIGRP is still functioning properly. Why is the static route not functioning as intended?

The administrative distance value is not high enough on the static route

A network administrator is configuring a route to forward packets to a specific web server. What type of route should be configured by the administrator?

a host route

Which type of static route that is configured on a router uses only the exit interface?

directly connected static route

Which two methods can be used to identify the next hop in a static route?

exit interface destination IP address

Which type of static route typically uses the distance parameter in the ip route global configuration command?

floating static route

What is the correct syntax of a floating static route?

ip route 209.165.200.228 255.255.255.248 10.0.0.1 120

Which static route statement shows a recursive IPv6 static route?

ipv6 route 2001:db8:cafe:1::/56 2001:db8:1000:10::1

Why would a floating static route be configured with an administrative distance that is higher than the administrative distance of a dynamic routing protocol that is running on the same router?

to be used as a backup route

How is the destination network in an IPv6 static route identified?

using an IPv6 prefix and prefix length