CCNA 2 - Final Practice - Part 1 of 5
1
What is the administrative distance value that indicates the route for R2 to reach the 10.10.0.0/16 network?
S 192.168.2.0/24 [1/0] via 172.16.2.2
Which route was configured as a static route to a specific network using the next-hop address? S S C S
The router will propagate a static default route in its RIP updates, if one is present.
A network administrator adds the default-information originate command to the configuration of a router that uses RIP as the routing protocol. What will result from adding this command?
They improve network security. They use fewer router resources.
Compared with dynamic routes, what are two advantages of using static routes on a router?
Ultimate route. Level 2 child route.
A network administrator reviews the routing table on the router and sees a route to the destination network 172.16.64.0/18 with a next-hop IP address of 192.168.1.1. What are two descriptions of this route?
The configuration is correct.
A network engineer is examining a configuration implemented by a new intern who attached an IP phone to a switch port and configured the switch. Identify the issue, if any, with the configuration. SW3(config-vlan)#vlan 2222
ip route 172.16.32.0 255.255.224.0 S0/0/0 200
A router has used the OSPF protocol to learn a route to the 172.16.32.0/19 network. Which command will implement a backup floating static route to this network?
2
Assuming that the routing tables are up to date and no ARP messages are needed, after a packet leaves H1, how many times is the L2 header rewritten in the path to H2?
because VLAN 99 needs to be entered as a VLAN under an interface before it can become an active interface because the VLAN 99 has not been manually entered into the VLAN database with the vlan 99 command
Based on the exhibited configuration and output, what are two reasons VLAN 99 missing?
ip route 10.10.0.0 255.255.0.0 209.165.200.225 100
Currently router R1 uses an EIGRP route learned from Branch2 to reach the 10.10.0.0/16 network. Which floating static route would create a backup route to the 10.10.0.0/16 network in the event that the link between R1 and Branch2 goes down?
access
Employees of a company connect their wireless laptop computers to the enterprise LAN via wireless access points that are cabled to the Ethernet ports of switches. At which layer of the three-layer hierarchical network design model do these switches operate?
The state is not maintained by the DHCPv6 server under stateless DHCPv6 operation.
Refer to the exhibit. A network administrator is configuring a router as a DHCPv6 server. The administrator issues a show ipv6 dhcp pool command to verify the configuration. Which statement explains the reason that the number of active clients is 0?
provides access to the rest of the network through switching, routing, and network access policies
What is a characteristic of the distribution layer in the three layer hierarchical model?
::/0
What network prefix and prefix-length combination is used to create a default static route that will match any IPv6 destination?
17.16.100.64
Which highlighted value represents a specific destination network in the routing table? 172.16.100.64/26 [110/791] via 172.16.100.2, 01:32:11, Serial0/0/0
It is automatically updated and maintained by routing protocols.
Which statement describes a route that has been learned dynamically?
Scalability. Speed of convergence.
Which two factors are important when deciding which interior gateway routing protocol to use?
floating static route
Which type of static route is configured with a greater administrative distance to provide a backup route to a route learned from a dynamic routing protocol?
