fill in the blank

When planing thin stock, be sure to use a backing board that is at least __________ inch thick.

3/4

Holes larger than 1 1/4 inches are best cut with a hole saw or a(n) ____________.

circle cut

The rate at which the wood moves through a planer is the ______________.

cutting speed

When cutting a rabbet, adjust the infeed table to an amount equal to the _________ of the rabbet.

depth

When cutting long stock, support the stock with a(n) ____________.

extension stand

For faceplate turning, the faceplate is fastened to the ________________.

head stock spindle

When cutting a tenon on the table saw, set the saw blade to a height equal to the _________ of the tenon.

length

Bits with a(n) ________________ are used to shape the edges of a workpiece.

pilot end

Attaching a(n) ___________ to the rip fence is one of the easiest ways for cutting many pieces to the same length.

stop block

A(n) _________ stick is a stick made in the shop to show predetermined measurements.

story

A(n) ____________ is a pattern used when forming or shaping a workpiece.

template

When cutting a rabbet, adjust the fence to an amount equal to the _________ of the rabbet.

width