GD&T DRAWING STANDARDS
False
A dimension can be used to define the variation permitted for a feature of size. True False
False
A flag note can only apply to one place on a drawing. True False
False
A general note applies to specific points on a drawing. True False
False
A general notes applies to specific points on a drawing. True False
True
A local note may NOT be shown in the notes section of a drawing.
False
A view title is considered a local Note True False
c. Throughout the US and many other nations
ASME standards are created predominantly in the U.S. Where are they used? a. Mostly throughout the aerospace industry b. Mostly by medical device manufacturers c. Throughout the US and many other nations
True
An engineering drawing can affect the choice of measurement tools. True False
True
An engineering drawing has an impact on the choice of machines used to produce the part. True False
True
An engineering drawing is a legal document. True False
False
General Notes are NOT numbered. True False
False
If a product is designed and manufactured by the same organization, the CAD data does not require tolerance. True False
Use Iso Standard
Mulitple Choice
ASME Y14.5-2009
Multiple choice
B
Multiple choice
False
On an engineering drawing, angular units are typically specified in degrees and in decimal parts of a degree a or in radians. True False
True
On an engineering drawing, the units of linear measurement are specified in the title block or next to each dimensions. True False
d. All of the above
To identify the standard to which a drawingis created, where should the drawing user look? a. Inside the title block b. Around the outside of the title block c. In the NOTES section d. ALL of the above
True
When an angle is less than one degree, a zero should be shown before the decimal point.. True False
c. In the drawing notes
Where is one place the ASME Y14.5-2009 reference may be located? a. In the revision column b. In the bill of materials (BOM) c. In the drawing notes d. Below the front view
Inspection methods
Which of the following is NOT a required component of engineering drawings? a. Tolerances b. Part Documentation c. Material coating d. Inspection methods
Critical functional relationships
Which of the followings is included on an engineering drawing? A. Critical functional relationships b. Manufacturing Process c. Inspection Methods D. None of the above
d. all of the above
Why do CAD require tolerances? a. Because part variation may occur from part deflection during machining b. Because part variation may occur from heat treatment of the part c. Because part variation may occur from clamping sequence. d. All of the above
