Networking

An author is uploading one chapter document from a personal computer to a file server of a book publisher. What role is the personal computer assuming in this network model? client master server slave transient

client

Refer to the exhibit. A network administrator is configuring access control to switch SW1. If the administrator uses Telnet to connect to the switch, which password is needed to access user EXEC mode? letmein secretin lineconin linevtyin

linevtyin

At a minimum, which address is required on IPv6-enabled interfaces? link-local unique local site local global unicast

link-local

What three blocks of addresses are defined by RFC 1918 for private network use? (Choose three.) 10.0.0.0/8*172.16.0.0/12 192.168.0.0/16 100.64.0.0/14 169.254.0.0/16 239.0.0.0/8

10.0.0.0/8*172.16.0.0/12 192.168.0.0/16

Which term refers to a network that provides secure access to the corporate offices by suppliers, customers and collaborators? Internet intranet extranet extendednet

extranet

A technician has been asked to develop a physical topology for a network that provides a high level of redundancy. Which physical topology requires that every node is attached to every other node on the network? bus hierarchical mesh ring star

mesh

Which two OSI model layers are considered to be included in the top layer of the TCP/IP protocol stack? (Choose two.) internet network presentation session transport

presentation session

What type of communication medium is used with a wireless LAN connection? fiber radio waves microwave UTP

radio waves

Which two services are required to enable a computer to receive dynamic IP addresses and access the Internet using domain names? (Choose two.) DNS WINS HTTP DHCP SMTP

DHCP, DNS

A small business user is looking for an ISP connection that provides high speed digital transmission over regular phone lines. What ISP connection type should be used? DSL dial-up satellite cell modem cable modem

DSL

Which two protocols function at the internet layer? (Choose two.) POP BOOTP ICMP IP PPP

ICMP IP

Match the requirements of a reliable network with the supporting network architecture. fault tolerance, scalability , security Protect the network from unauthorized access. Provide redundant links and devices. Expand the network without degrading the service for existing users.

Protect the network from unauthorized access. -> security Provide redundant links and devices. -> fault tolerance Expand the network without degrading the service for existing users. -> scalability

What is the purpose of ICMP messages? to inform routers about network topology changes to ensure the delivery of an IP packet to provide feedback of IP packet transmissions to monitor the process of a domain name to IP address resolution

to provide feedback of IP packet transmissions

Match the phases to the functions during the boot up process of a Cisco router. Phase 1, 2, 3 locale and load the Cisco IOS software locate and load the startup configuration file perform the POST and load the bootstrap program

locale and load the Cisco IOS software -> phase 2 locate and load the startup configuration file -> phase 3 perform the POST and load the bootstrap program -> phase 1

A network administrator is variably subnetting a given block of IPv4 addresses. Which combination of network addresses and prefix lengths will make the most efficient use of addresses when the need is for 2 subnets capable of supporting 10 hosts and 1 subnet that can support 6 hosts? 10.1.1.128/28 10.1.1.144/28 10.1.1.160/29 10.1.1.128/28 10.1.1.144/28 10.1.1.160/2810.1.1.128/28 10.1.1.140/28 10.1.1.158/26 10.1.1.128/26 10.1.1.144/26 10.1.1.160/26 10.1.1.128/26 10.1.1.128/26 10.1.1.140/26 10.1.1.158/28

10.1.1.128/28 10.1.1.144/28 10.1.1.160/29

Refer to the exhibit. An administrator must send a message to everyone on the router A network. What is the broadcast address for network 172.16.16.0/22? 172.16.16.255 172.16.20.255 172.16.19.255 172.16.23.255 172.16.255.255

172.16.19.255

What is the valid most compressed format possible of the IPv6 address 2001:0DB8:0000:AB00:0000:0000:0000:1234? 2001:DB8:0:AB00::1234 2001:DB8:0:AB::1234 2001:DB8::AB00::1234 2001:DB8:0:AB:0:1234

2001:DB8:0:AB00::1234

Given IPv6 address prefix 2001:db8::/48, what will be the last subnet that is created if the subnet prefix is changed to /52? 2001:db8:0:f00::/52 2001:db8:0:8000::/52 2001:db8:0:f::/52 2001:db8:0:f000::/52

2001:db8:0:f000::/52

What is the usable number of host IP addresses on a network that has a /26 mask? 256 254 64 62 32 16

62

Which keys act as a hot key combination that is used to interrupt an IOS process? Ctrl-Shift-X Ctrl-Shift-6 Ctrl-Z Ctrl-C

Ctrl-Shift-6

What will be the result of failed login attempts if the following command is entered into a router? login block-for 150 attempts 4 within 90 All login attempts will be blocked for 150 seconds if there are 4 failed attempts within 90 seconds. All login attempts will be blocked for 90 seconds if there are 4 failed attempts within 150 seconds. All login attempts will be blocked for 1.5 hours if there are 4 failed attempts within 150 seconds. All login attempts will be blocked for 4 hours if there are 90 failed attempts within 150 seconds.

All login attempts will be blocked for 150 seconds if there are 4 failed attempts within 90 seconds.

Match the functions with the corresponding OSI layer. Application layer, Presentation layer, Session layer HTTP and FTP end user program functionality compression common format dialog maintenance

Application layer HTTP and FTP end user program functionality Presentation layer compression common format Session layer dialog maintenance

Match the descriptions to the terms. CLI , GUI, Kernel, Shell users interact with the operating system by typing commands enables the user to interact with the operating system by pointing and clicking the part of the OS that interacts directly with the device hardware the part of the operating system that interfaces with applications and the user

CLI -> users interact with the operating system by typing commands GUI -> enables the user to interact with the operating system by pointing and clicking kernel -> the part of the OS that interacts directly with the device hardware shell -> the part of the operating system that interfaces with applications and the user

For Cisco IOS, which escape sequence allows terminating a traceroute operation? Ctrl+Shift+6 Ctrl+Esc Ctrl+x Ctrl+c

Ctrl+Shift+6

What are two features of ARP? (Choose two.) If a host is ready to send a packet to a local destination device and it has the IP address but not the MAC address of the destination, it generates an ARP broadcast. An ARP request is sent to all devices on the Ethernet LAN and contains the IP address of the destination host and its multicast MAC address. When a host is encapsulating a packet into a frame, it refers to the MAC address table to determine the mapping of IP addresses to MAC addresses. If no device responds to the ARP request, then the originating node will broadcast the data packet to all devices on the network segment. If a device receiving an ARP request has the destination IPv4 address, it responds with an ARP reply.

If a host is ready to send a packet to a local destination device and it has the IP address but not the MAC address of the destination, it generates an ARP broadcast. If a device receiving an ARP request has the destination IPv4 address, it responds with an ARP reply.*

What will a Layer 2 switch do when the destination MAC address of a received frame is not in the MAC table? It initiates an ARP request. It broadcasts the frame out of all ports on the switch. It notifies the sending host that the frame cannot be delivered. It forwards the frame out of all ports except for the port at which the frame was received.

It forwards the frame out of all ports except for the port at which the frame was received.

Which statement describes a characteristic of the traceroute utility? It sends four Echo Request messages. It utilizes the ICMP Source Quench messages. It is primarily used to test connectivity between two hosts. It identifies the routers in the path from a source host to a destination host.

It identifies the routers in the path from a source host to a destination host.

What is done to an IP packet before it is transmitted over the physical medium? It is tagged with information guaranteeing reliable delivery. It is segmented into smaller individual pieces. It is encapsulated into a TCP segment. It is encapsulated in a Layer 2 frame.

It is encapsulated in a Layer 2 frame.

What are the two sublayers of the OSI model data link layer? (Choose two.) internet physical LLC transport MAC network access

LLC, MAC

A user reports a lack of network connectivity. The technician takes control of the user machine and attempts to ping other computers on the network and these pings fail. The technician pings the default gateway and that also fails. What can be determined for sure by the results of these tests? The NIC in the PC is bad. The TCP/IP protocol is not enabled. The router that is attached to the same network as the workstation is down. Nothing can be determined for sure at this point.

Nothing can be determined for sure at this point.

Which two statements correctly describe a router memory type and its contents? (Choose two.) ROM is nonvolatile and stores the running IOS. FLASH is nonvolatile and contains a limited portion of the IOS​. RAM is volatile and stores the IP routing table. NVRAM is nonvolatile and stores a full version of the IOS. ROM is nonvolatile and contains basic diagnostic software.

ROM is nonvolatile and contains basic diagnostic software. RAM is volatile and stores the IP routing table.

What is the purpose of the SVI on a Cisco switch? The SVI provides a physical interface for remote access to the switch. The SVI provides a faster method for switching traffic between ports on the switch. The SVI adds Layer 4 connectivity between VLANs. The SVI provides a virtual interface for remote access to the switch.

The SVI provides a virtual interface for remote access to the switch.

Refer to the exhibit. An administrator is trying to configure the switch but receives the error message that is displayed in the exhibit. What is the problem? The entire command, configure terminal, must be used. The administrator is already in global configuration mode. The administrator must first enter privileged EXEC mode before issuing the command. The administrator must connect via the console port to access global configuration mode.

The administrator must first enter privileged EXEC mode before issuing the command.

A technician with a PC is using multiple applications while connected to the Internet. How is the PC able to keep track of the data flow between multiple application sessions and have each application receive the correct packet flows? The data flow is being tracked based on the destination port number utilized by each application. The data flow is being tracked based on the source port number utilized by each application. The data flow is being tracked based on the source IP address used by the PC of the technician. The data flow is being tracked based on the destination IP address used by the PC of the technician.

The data flow is being tracked based on the source port number utilized by each application.

An Internet television transmission is using UDP. What happens when part of the transmission is not delivered to the destination? A delivery failure message is sent to the source host. The part of the television transmission that was lost is re-sent. The entire transmission is re-sent. The transmission continues without the missing portion.

The transmission continues without the missing portion.

A network administrator enters the service password-encryption command into the configuration mode of a router. What does this command accomplish? This command encrypts passwords as they are transmitted across serial WAN links. This command automatically encrypts passwords in configuration files that are currently stored in NVRAM. This command provides an exclusive encrypted password for external service personnel who are required to do router maintenance. This command enables a strong encryption algorithm for the enable secret password command. This command prevents someone from viewing the running configuration passwords.

This command prevents someone from viewing the running configuration passwords.

A network administrator enters the service passwordencryption command into the configuration mode of a router. What does this command accomplish? This command encrypts passwords as they are transmitted across serial WAN links. This command prevents someone from viewing the running configuration passwords. This command enables a strong encryption algorithm for the enable secret password command. This command automatically encrypts passwords in configuration files that are currently stored in NVRAM. This command provides an exclusive encrypted password for external service personnel who are required to do router maintenance.

This command prevents someone from viewing the running configuration passwords.

What best describes the destination IPv4 address that is used by multicasting? a single IP multicast address that is used by all destinations in a group an IP address that is unique for each destination in the group a group address that shares the last 23 bits with the source IPv4 address a 48 bit address that is determined by the number of members in the multicast group

a single IP multicast address that is used by all destinations in a group

What type of communication rule would best describe CSMA/CD? access method flow control message encapsulation message encoding

access method

An IPv6 enabled device sends a data packet with the destination address of FF02::2. What is the target of this packet? all IPv6 enabled devices across the network all IPv6 enabled devices on the local link all IPv6 DHCP servers all IPv6 configured routers on the local link

all IPv6 configured routers on the local link

Which message delivery option is used when all devices need to receive the same message simultaneously? duplex unicast multicast broadcast

broadcast

What is a basic characteristic of the IP protocol? connectionless media dependent user data segmentation reliable end-to-end delivery

connectionless

In addition to the cable length, what two factors could interfere with the communication carried over UTP cables? (Choose two.) crosstalk bandwidth size of the network signal modulation technique electromagnetic interference

crosstalk, electromagnetic interference

If data is being sent over a wireless network, then connects to an Ethernet network, and eventually connects to a DSL connection, which header will be replaced each time the data travels through a network infrastructure device? Layer 3 data link physical Layer 4

data link

What important information is examined in the Ethernet frame header by a Layer 2 device in order to forward the data onward? source MAC address source IP address destination MAC address Ethernet type destination IP address

destination MAC address

What is the objective of a network reconnaissance attack? discovery and mapping of systems unauthorized manipulation of data disabling network systems or services denying access to resources by legitimate users

discovery and mapping of systems

When a network administrator is trying to manage network traffic on a growing network, when should traffic flow patterns be analyzed? during times of peak utilization during off-peak hours during employee holidays and weekends during randomly selected times

during times of peak utilization

Refer to the exhibit. A user issues the command netstat -r on a workstation. Which IPv6 address is one of the link-local addresses of the workstation? ::1/128 fe80::30d0:115:3f57:fe4c/128 fe80::/64 2001:0:9d38:6ab8:30d0:115:3f57:fe4c/128

fe80::30d0:115:3f57:fe4c/128

What three services are provided by the transport layer? (Choose three.) flow control encryption of data path determination connection establishment error recovery bit transmission data representation

flow control connection establishment error recovery

In an Ethernet network, when a device receives a frame of 1200 bytes, what will it do? drop the frame process the frame as it is send an error message to the sending device add random data bytes to make the frame 1518 bytes long and then forward it

process the frame as it is

What PDU is associated with the transport layer? segment packet frame bits

segment

Which two automatic addressing assignments are supported by DHCPv4? (Choose two.) local server address subnet mask default gateway address physical address of the recipient physical address of the sender

subnet mask default gateway address