S & R CH. 14-16 Part 2

Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 What does the 5 at the end of the command signify?

administrative distance

Refer to the exhibit. The routing table for R2 is as follows: Gateway of last resort is not set 10.0.0.0/30 is subnetted, 2 subnetsC 10.0.0.0 is directly connected, Serial0/0/0C 10.0.0.4 is directly connected, Serial0/0/1192.168.10.0/26 is subnetted, 3 subnetsS 192.168.10.0 is directly connected, Serial0/0/0C 192.168.10.64 is directly connected, FastEthernet0/0S 192.168.10.128 [1/0] via 10.0.0.6 What will router R2 do with a packet destined for 192.168.10.129?

send the packet out interface Serial0/0/1

What network prefix and prefix-length combination is used to create a default static route that will match any IPv6 destination?

::/0

On which two routers would a default static route be configured? (Choose two.)

-stub router connection to the rest of the corporate or campus network -edge router connection to the ISP

An administrator issues the ipv6 route 2001:db8:acad:1::/32 gigabitethernet0/0 2001:db8:acad:6::1 100 command on a router. What administrative distance is assigned to this route?

100

Refer to the graphic. Which command would be used on router A to configure a static route to direct traffic from LAN A that is destined for LAN C?

A(config)# ip route 192.168.4.0 255.255.255.0 192.168.3.2

Refer to the exhibit. This network has two connections to the ISP, one via router C and one via router B. The serial link between router A and router C supports EIGRP and is the primary link to the Internet. If the primary link fails, the administrator needs a floating static route that avoids recursive route lookups and any potential next-hop issues caused by the multiaccess nature of the Ethernet segment with router B. What should the administrator configure?

Create a fully specified static route pointing to Fa0/0 with an AD of 95.

What is a characteristic of a floating static route?

It is configured with a higher administrative distance than the original dynamic routing protocol has.

Refer to the exhibit. Which default static route command would allow R1 to potentially reach all unknown networks on the Internet?

R1(config)# ipv6 route ::/0 G0/1 fe80::2

Refer to the exhibit. The network engineer for the company that is shown wants to use the primary ISP connection for all external connectivity. The backup ISP connection is used only if the primary ISP connection fails. Which set of commands would accomplish this goal?

ip route 0.0.0.0 0.0.0.0 s0/0/0 ip route 0.0.0.0 0.0.0.0 s0/1/0 10