section 10 lesson 6
Utilities normally generate ? .
3 phase AC power
How much power in kilovolt-amperes is delivered to a 3-phase transformer when the line voltage applied is 480 volts and the line current is 12 amps? (Round the FINAL answer to two decimal places.)
9.98 kVa
In a 3-phase circuit, power varies during a cycle but never falls to zero.
true
Magnetic force is used to rotate the coils in a generator.
false
Transformers are usually used to step up voltage at the point of use.
false
A ? produces energy when a rotating coil cuts through magnetic flux.
generater
A(n) ? is a machine that converts mechanical energy into electrical energy by means of electromagnetic induction.
generator
? is a method of synchronizing generators.
lights-out
The ? is the current flow through the lines to a load.
line current
The ? is the voltage measured line-to-line.
line voltage
What was the primary transmission line problem that led up to a sequence of events that eventually caused the East Coast power blackout on August 14, 2003?
sagging line shorted
A(n) ? is a device that indicates whether two AC sources to be connected in parallel are in the correct phase relationship.
synchroscope
A landfill generator runs on the methane gas created by decomposing trash.
true
A stronger magnetic field, more turns, and faster rotation produce a higher voltage from a generator.
true
In the three-lights-out method, a lamp is connected as a load across each phase of the two sources, A to A, B to B, and C to C.
true
The most efficient way to send electric power over transmission lines is at the lowest current possible.
true
The power in a single-phase circuit drops to zero ? every cycle.
twice
Which factors determine the amount of voltage produced by a generator? I. The number of turns II. The speed of rotation of the rotor III. The strength of the magnetic field IV. The load on the generator
1, 2, 3
If the line voltage is 480 volts as shown, the winding voltage is ? .
277V
In North America, power is generated at a frequency of ? .
60hz
The ? is the current flow through the individual windings.
winding current
The ? is the voltage measured across the windings.
winding voltage
In an electric generating power plant, all generators must be connected in ? .
parralel