ACT 143
Technician A says that HVLP spray guns may be siphon feed. Technician B says that HVLP spray guns may be gravity feed. Who is right?
Both A and B
Technician A says that VOC's may be recorded as packaged. Technician B says that VOC's may be recorded as ready-to-spray. Who is right?
Both A and B
Technician A says that a mixing room must be self-ventilated. Technician B says that a mixing room needs to provide spill containment. Who is right?
Both A and B
Technician A says that paint suits are designed to limit exposure to hazardous chemicals. Technician B says that paint suits may be made of paper or nylon and cotton.
Both A and B
Technician A says that spray gun washers need to be fire rated. Technician B says that spray gun washers must be grounded to avoid sparks. Who is right?
Both A and B
Technician A says that the National Rule has precedence over any state or local rule. Technician B says that the National Rule covers all of the United States. Who is right?
Both A and B
A light meter is used to monitor the:
CRI of a spraybooth
A velometer is used to measure the:
amount of airflow in a spraybooth
A particle counter is used to monitor the:
amount of dirt in a spraybooth
Technician A says that HVLP spray guns use high pressure and low volumes of compressed air. Technician B says that a HVLP spray gun must not produce more than 10 psi at the air cap. Who is right?
B only.
Technician A says that prep decks may be regulated as to the functions that can be performed within them. Technician B says that prep decks are designed only for sanding operations. Who is right?
A only
Technician A says that using the shortest possible air hose offers the least amount of air pressure drop. Technician B says that the quick disconnects on supplied-air breathing and working air hoses should be the same style. Who is right?
A only
Technician A says that negative air pressure within a prep deck will cause the curtains to pull in. Technician B says that positive air pressure within a prep deck will cause the curtains to hang straight down. Who is right?
A only.
All automotive refinish facilities must meet the minimum requirements of what rule?
National
Technician A says that a cured product has attained proper adhesion to the underlying material. Technician B says that drying refers to a refinished product that has chemically changed. Who is right
Neither A or B
Technician A says that if spray gun travel speed is too fast, the set-back distance should be decreased. Technician B says that if spray gun travel speed is too slow, the set-back distance should be increased. Who is right?
Neither A or B
Technician A says that triggering a spray gun ON and OFF is done to allow the air compressor time to catch up. Technician B says that triggering ON and OFF is only done on the right side of the panel. Who is right?
Neither A or B
Technician A says that when spraying a dark color, overlap can be reduced to 25%. Technician B says that when spraying a light color, overlap should be increased to 75%. Who is right?
Neither A or B
The paint cup on gravity feed spray guns is located:
on top of the spray gun body
All of these are types of OEM finishes EXCEPT:
saturated color