CCNA 2 Exam 1 part 3 of 3
the VLAN assignment and membership for all switch ports
A network administrator issues the show vlan brief command while troubleshooting a user support ticket. What output will be displayed?
It enters the global configuration mode.
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw# configure terminal command?
It allows data to flow in both directions at the same time on the interface.
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# duplex full command?
It returns to global configuration mode.
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# exit command?
It applies an IPv4 address to the virtual interface.
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# ip address 172.18.33.88 255.255.255.0 command?
It applies an IPv6 address to the virtual interface.
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# ipv6 address 2001:db8:a2b4:88::1/64 command?
It disables a virtual or physical switch interface.
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config-if)# shutdown command?
It enters privileged mode.
A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw> enable command?
DHCPACK------->The DHCP server confirming that the address lease has been accepted DHCPREQUEST------->The client accepting the IP address provided by the DHCP server DHCPDISCOVER------>aclient initiating a message to find a DHCP server DHCPOFFER--------->A DHCP server responding to the initial request by a client
Match each DHCP message type with its description. (Not all options are used.)
File Server Explanation: Examining the configuration of switch SW1 shows that interface Gi0/1 is not configured as a trunk. Issuing the interface configuration command switchport mode trunk on this interface will enable communications between PC1 and Server1.
Open the PT Activity. Perform the tasks in the activity instructions and then answer the question. Which message is displayed when 10.10.10.1 is entered into the PC1 Web Browser address bar?
no shutdown Explanation: By default all router interfaces are shut down. To bring the interfaces up, an administrator must issue the no shutdown command in interface mode.
Refer to the exhibit. A network administrator has configured R1 as shown. When the administrator checks the status of the serial interface, the interface is shown as being administratively down. What additional command must be entered on the serial interface of R1 to bring the interface up?
It identifies the VLAN number.
Refer to the exhibit. A network administrator is configuring inter-VLAN routing on a network. For now, only one VLAN is being used, but more will be added soon. What is the missing parameter that is shown as the highlighted question mark in the graphic?
Modify the transport input command.
Refer to the exhibit. The network administrator wants to configure Switch1 to allow SSH connections and prohibit Telnet connections. How should the network administrator change the displayed configuration to satisfy the requirement?
management VLAN
What type of VLAN is configured specifically for network traffic such as SSH, Telnet, HTTPS, HHTP, and SNMP?
management VLAN
What type of VLAN is configured specifically for network traffic such as SSH, Telnet, HTTPS, HTTP, and SNMP?
voice VLAN
What type of VLAN is designed to have a delay of less than 150 ms across the network?
voice VLAN
What type of VLAN is designed to reserve bandwidth to ensure IP Phone quality?
default VLAN
What type of VLAN is initially the management VLAN?
data VLAN
What type of VLAN is used to separate the network into groups of users or devices?
data VLAN
What type of VLAN should not carry voice and network management traffic?
native VLAN
What type of VLAN supports untagged traffic?
a high port density switch
Which solution would help a college alleviate network congestion due to collisions?
Switching packets is faster with SVI. There is no need for a connection to a router.
Which two statements are correct with respect to SVI inter-VLAN routing? (Choose two.)
native
Which type of VLAN is used to designate which traffic is untagged when crossing a trunk port?
