CCNA 3 Test Part 2 Multiple Answer

What are two requirements when using out-of-band configuration of a Cisco IOS network device? (Choose two.)

a direct connection to the console or AUX port* a terminal emulation client*

What are two reasons to implement passive interfaces in the EIGRP configuration of a Cisco router? (Choose two.)

to provide increased network security *** to avoid unnecessary update traffic ***

A network administrator is analyzing first -hop router redundancy protocols.What is characteristic of VRRPv3. characteristics of VRRPV3:

*INTEROPERABILITY IN MULTI-VENDOR ENVIRONMENTS *VRRPv3 SUPPORTS USAGE OF IPv4 and IPv6 *IMPROVE SCALABILITY THROUGH USE OF VRRS PATHWAYS

What two license states would be expected on a new Cisco router once the license has been activated? (Choose two.)

- License Type: Permanent * - License State: Active, In Use *

Which two parameters does EIGRP use by default to calculate the best path? (Choose two.)

-MTU* -bandwidth*

What are two requirements to be able to configure an EtherChannel between two switches? (Choose two.)

All the interfaces need to work at the same speed.* All the interfaces need to be working in the same duplex mode.*

What are two features of OSPF interarea route summarization? (Choose two.)

Routes within an area are summarized by the ABR.* ABRs advertise the summarized routes into the backbone.*

Which mode configuration setting would allow formation of an EtherChannel link between switches SW1 and SW2 without sending negotiation traffic?

SW1: on SW2: on*

What two conditions have to be met in order to form a cluster that includes 5 access points? (Choose two.)

The APs have to be connected on the same network segment Clustering mode must be enabled on the APs.*

What are two differences between the Cisco IOS 12 and IOS 15 versions? (Choose two.)

The IOS version 15 license key is unique to each device, whereas the IOS version 12 license key is not device specific.* IOS version 12.4(20)T1 is a mainline release, whereas IOS version 15.1(1)T1 is a new feature release.*

Which two statements are correct about EIGRP acknowledgment packets? (Choose two.)

The packets are sent as unicast.* The packets are unreliable.*

For troubleshooting missing EIGRP routes on a router, what three types of information can be collected using the show ip protocols command? (Choose three.)

any interfaces on the router that are configured as passive* any ACLs that are affecting the EIGRP routing process* the IP addresses that are configured on adjacent routers*

A network engineer is implementing security on all company routers. Which two commands must be issued to force authentication via the password 1C34dE for all OSPF-enabled interfaces in the backbone area of the company network? (Choose two.)

area 0 authentication message-digest* ip ospf message-digest-key 1 md5 1C34dE*

In a large enterprise network, which two functions are performed by routers at the distribution layer? (Choose two.)

connect remote networks* provide data traffic security*

What are three access layer switch features that are considered when designing a network? (Choose three.)

forwarding rate*** Power over Ethernet*** port density***

What are the two methods that are used by a wireless NIC to discover an AP? (Choose two.)

receiving a broadcast beacon frame* transmitting a probe request*