CCNA1 FINAL EXAM STUDY GUIDE *EXHIBITS*

A router along the path did not have a route to the destination.

Refer to the exhibit. An administrator is testing connectivity to a remote device with the IP address 10.1.1.1. What does the output of this command indicate? Connectivity to the remote device was successful. A router along the path did not have a route to the destination. A ping packet is being blocked by a security device along the path. The connection timed out while waiting for a reply from the remote device.

The administrator must first enter privileged EXEC mode before issuing the command.

Refer to the exhibit. An administrator is trying to configure the switch but receives the error message that is displayed in the exhibit. What is the problem? The entire command, configure terminal, must be used. The administrator is already in global configuration mode. The administrator must first enter privileged EXEC mode before issuing the command. The administrator must connect via the console port to access global configuration mode.

172.16.19.255

Refer to the exhibit. An administrator must send a message to everyone on the router A network. What is the broadcast address for network 172.16.16.0/22? 172.16.16.255 172.16.20.255 172.16.19.255 172.16.23.255 172.16.255.255

The delimiting character appears in the banner message.

Refer to the exhibit. From global configuration mode, an administrator is attempting to create a message-of-the-day banner by using the command banner motd V Authorized access only! Violators will be prosecuted! V When users log in using Telnet, the banner does not appear correctly. What is the problem? The banner message is too long. The delimiting character appears in the banner message. The symbol "!" signals the end of a banner message. Message-of-the-day banners will only appear when a user logs in through the console port.

FastEthernet0/0 -> packets with destination of 172.17.6.15 FastEthernet0/1 -> packets with destination of 172.17.14.8 FastEthernet1/0 -> packets with destination of 172.17.12.10 FastEthernet1/1 -> packets with destination of 172.17.10.5 Serial0/0/0 -> packets with destination of 172.17.8.20

Refer to the exhibit. Match the packets with their destination IP address to the exiting interfaces on the router. (Not all options are used.)

There is connectivity between this device and the device at 192.168.100.1. There are 4 hops between this device and the device at 192.168.100.1.

Refer to the exhibit. On the basis of the output, which two statements about network connectivity are correct? (Choose two.) There is connectivity between this device and the device at 192.168.100.1. The connectivity between these two hosts allows for videoconferencing calls. There are 4 hops between this device and the device at 192.168.100.1. The average transmission time between the two hosts is 2 milliseconds. This host does not have a default gateway configured.

The no shutdown command was not issued on these interfaces.

Refer to the exhibit. Router R1 has two interfaces that were configured with correct IP addresses and subnet masks. Why does the show ip route command output not display any information about the directly connected networks?? The directly connected networks have to be created manually to be displayed in the routing table. The routing table will only display information about these networks when the router receives a packet. The no shutdown command was not issued on these interfaces. The gateway of last resort was not configured.

Because the IOS includes the login command on the vty lines by default, access to the device via Telnet will require authentication.

Refer to the exhibit. The administrator configured the access to the console and the vty lines of a router. Which conclusion can be drawn from this configuration? Unauthorized individuals can connect to the router via Telnet without entering a password. Because the IOS includes the login command on the vty lines by default, access to the device via Telnet will require authentication. Access to the vty lines will not be allowed via Telnet by anyone. Because the login command was omitted, the password cisco command is not applied to the vty lines.

default gateway address

Refer to the exhibit. The network administrator for a small advertising company has chosen to use the 192.168.5.96/27 network for internal LAN addressing. As shown in the exhibit, a static IP address is assigned to the company web server. However, the web server cannot access the Internet. The administrator verifies that local workstations with IP addresses that are assigned by a DHCP server can access the Internet, and the web server is able to ping local workstations. Which component is incorrectly configured? subnet mask DNS address host IP address default gateway address

The asterisk designates which file system is the default file system.

Refer to the exhibit. What is the significance of the asterisk (*) in the exhibited output? The asterisk shows which file system was used to boot the system. The asterisk designates which file system is the default file system. An asterisk indicates that the file system is bootable. An asterisk designates that the file system has at least one file that uses that file system.

The administrator will be presented with the R1> prompt.

Refer to the exhibit. What will be the result of entering this configuration the next time a network administrator connects a console cable to the router and no additional commands have been entered? The administrator will be required to enter Cisco123. The administrator will be required to enter Cisco234. The administrator will be required to enter Cisco789. The administrator will be presented with the R1> prompt.

flash memory

Refer to the exhibit. From which location did this router load the IOS? flash memory NVRAM? RAM ROM a TFTP server?

13

Refer to the exhibit. What is the maximum TTL value that is used to reach the destination www.cisco.com?? 11 12 13 14

Site 2

Refer to the exhibit. Which IP addressing scheme should be changed? Site 1 Site 2 Site 3 Site 4

306

Refer to the exhibit. A TCP segment from a server has been captured by Wireshark, which is running on a host. What acknowledgement number will the host return for the TCP segment that has been received? 2 21 250 306 2921

secretin

Refer to the exhibit. A network administrator is configuring access control to switch SW1. If the administrator has already logged into a Telnet session on the switch, which password is needed to access privileged EXEC mode? letmein secretin lineconin linevtyin

lineconin

Refer to the exhibit. A network administrator is configuring access control to switch SW1. If the administrator uses a console connection to connect to the switch, which password is needed to access user EXEC mode? letmein secretin linevtyin lineconin

just PC0 and PC1 MAC addresses

Refer to the exhibit. A ping to PC2 is issued from PC0, PC1, and PC3 in this exact order. Which MAC addresses will be contained in the S1 MAC address table that is associated with the Fa0/1 port? just PC0 and PC1 MAC addresses just the PC0 MAC address PC0, PC1, and PC2 MAC addresses just the PC1 MAC address just the PC2 MAC address

just PC0 and PC1 MAC addresses

Refer to the exhibit. A ping to PC3 is issued from PC0, PC1, and PC2 in this exact order. Which MAC addresses will be contained in the S1 MAC address table that is associated with the Fa0/1 port? just PC0 and PC1 MAC addresses just the PC0 MAC address PC0, PC1, and PC2 MAC addresses just the PC1 MAC address just the PC2 MAC address

The default gateway address in incorrect.

Refer to the exhibit. A technician has configured a user workstation with the IP address and default subnet masks that are shown. Although the user can access all local LAN resources, the user cannot access any Internet sites by using either FQDN or IP addresses. Based upon the exhibit, what could account for this failure? The DNS server addresses are incorrect. The default gateway address in incorrect. The wrong subnet mask was assigned to the workstation. The workstation is not in the same network as the DNS servers.

Switch(config)#?

Refer to the exhibit. An administrator wants to change the name of a brand new switch, using the hostname command as shown. What prompt will display after the command is issued?? HR Switch(config)#? Switch(config)#? HRSwitch(config)#? HR(config)#? Switch#

It is the IP address of the Router1 interface that connects the PC1 LAN to Router1.

Refer to the exhibit. Consider the IP address configuration shown from PC1. What is a description of the default gateway address? It is the IP address of the Router1 interface that connects the company to the Internet. It is the IP address of the Router1 interface that connects the PC1 LAN to Router1. It is the IP address of Switch1 that connects PC1 to other devices on the same LAN. It is the IP address of the ISP network device located in the cloud.

192.168.10.128

Refer to the exhibit. Consider the IP address of 192.168.10.0/24 that has been assigned to a high school building. The largest network in this building has 100 devices. If 192.168.10.0 is the network number for the largest network, what would be the network number for the next largest network, which has 40 devices? 192.168.10.0 192.168.10.128 192.168.10.192 192.168.10.224 192.168.10.240

BB:BB:BB:BB:BB:BB

Refer to the exhibit. If host A sends an IP packet to host B, what will the destination address be in the frame when it leaves host A? DD:DD:DD:DD:DD:DD 172.168.10.99 CC:CC:CC:CC:CC:CC 172.168.10.65 BB:BB:BB:BB:BB:BB AA:AA:AA:AA:AA:AA

192.168.11.252

Refer to the exhibit. The network administrator enters these commands into the R1 router:R1# copy running-config tftpAddress or name of remote host [ ]?When the router prompts for an address or remote host name, what IP address should the administrator enter at the prompt? 192.168.9.254 192.168.10.1 192.168.10.2 192.168.11.252 192.168.11.254

PC2 can send a ping to 192.168.1.1.

Refer to the exhibit. Which action will be successful? PC1 can send a ping to 192.168.1.1?. PC1 can send a ping to 192.168.1.254?. PC2 can send a ping to 192.168.1.1. PC2 can send a ping to 192.168.1.254?.

area C

Refer to the exhibit. Which area would most likely be an extranet for the company network that is shown? area A area B area C area D