Ch 9 Advanced Shakespearean Terminology Part 9 Version 9 Section 9 Division 9
Order of the stateful DHVPv6 process
1. DHCPv6 SOLICIT 2. DHCPv6 ADVERTISE 3. DHCPv6 REQUEST 4. DHCPv6 REPLY
Refer to the exhibit. What should be done to allow PC-A to receive an IPv6 address from the DHCPv6 server?
Add the ipv6 dhcp relay command to interface Fa0/0.
What process is used in ICMPv6 for a host to verify that an IPv6 address is unique before configuring it on an interface?
DAD
A network administrator configures a router to send RA messages with M flag as 0 and O flag as 1. Which statement describes the effect of this configuration when a PC tries to configure its IPv6 address?
It should use the information that is contained in the RA message and contact a DHCPv6 server for additional information
A company uses the method SLAAC to configure IPv6 addresses for the workstations of the employees. A network administrator configured the IPv6 address on the LAN interface of the router. The interface status is UP. However, the workstations on the LAN segment did not obtain the correct prefix and prefix length. What else should be configured on the router that is attached to the LAN segment for the workstations to obtain the information?
R1(config)# ipv6 unicast-routing
What are two characteristics of the SLAAC method for IPv6 address configuration? (Choose two.)
The default gateway of an IPv6 client on a LAN will be the link-local address of the router interface attached to the LAN. IPv6 addressing is dynamically assigned to clients through the use of ICMPv6.
After a host has generated an IPv6 address by using the DHCPv6 or SLAAC process, how does the host verify that the address is unique and therefore usable?
The host sends an ICMPv6 neighbor solicitation message to the DHCP or SLAAC-learned address and if no neighbor advertisement is returned, the address is considered unique.
Refer to the exhibit. PC-A is unable to receive an IPv6 address from the stateful DHCPv6 server. What is the problem?
The ipv6 dhcp relay command should be applied to interface Gig0/0.
Refer to the exhibit. A network administrator is implementing the stateless DHCPv6 operation for the company. Clients are configuring IPv6 addresses as expected. However, the clients are not getting the DNS server address and the domain name information configured in the DHCP pool. What could be the cause of the problem?
The router is configured for SLAAC operation.
Refer to the exhibit. A network administrator is configuring a router for DHCPv6 operation. Which conclusion can be drawn based on the commands?
The router is configured for stateless DHCPv6 operation.
Which command should be configured on a router interface to set the router as a stateful DHCPv6 client?
ipv6 address dhcp
IPv6 flag command that enables stateful
ipv6 nd managed-config-flag
IPv6 flag command that enables stateless
ipv6 nd other-config-flag
Refer to the exhibit. Based on the output that is shown, what kind of IPv6 addressing is being configured?
stateless DHCPv6
What message informs IPv6 enabled interfaces to use stateful DHCPv6 for obtaining an IPv6 address?
the ICMPv6 Router Advertisement
A company uses the SLAAC method to configure IPv6 addresses for the employee workstations. Which address will a client use as its default gateway?
the link-local address of the router interface that is attached to the network
Refer to the exhibit. A network administrator is configuring a router as a DHCPv6 server. The administrator issues a show ipv6 dhcp pool command to verify the configuration. Which statement explains the reason that the number of active clients is 0?
The state is not maintained by the DHCPv6 server under stateless DHCPv6 operation.*