CM2215 Module 2
According to 29 CFR 1926, fall protection must be used if someone can fall ____ feet or more.
6
OSHA conducts focused inspections to allow for ______.
Better use of resources
The best method to keep employees safe from hazards is to ______ them.
Prevent
Warning lines can be used as fall restraints as long as they are no closer to the edge than ____ feet.
10
On temporary stair handrails, the minimum clearance between the rail and wall shall be ____ inches.
3
When stopping a fall, a PFAS shall bring an employee to a complete stop and limit the maximum deceleration to ______ feet.
3.5 feet (42 inches)
According to 29 CFR 1910, fall protection must be used if someone can fall ____ feet or more.
4
The top rail of a guard rail system must be ______ inches in height ±3"
42
A Fall Arrest Anchor Point must be capable of supporting ______pounds per attached worker.
5,000 lbs
Guard rails used for fall protection can be made from _____.
All of the above
Injuries are ______ abnormal conditions or disorders.
Any
To qualify for a focused inspection, the OSHA inspector must also find a / an ______.
Competent person
If the OSHA inspector does not feel a company qualifies for a focused inspection, he will do a ______ inspection.
Comprehensive
In the past, all construction inspections were ________ in scope.
Comprehensive
The Focused Inspection Initiative policy applies only to the ______ industry.
Construction
If a hazard cannot be prevented, the second best method to keep employees safe is to ______ the hazard as soon as possible.
Eliminate
Building a sound proof wall around loud equipment is an example of a ______ exposure control method.
Engineering
The preferred method for exposure control is utilizing a/an ______ technique.
Engineering
If a hazard cannot be prevented or eliminated, then ______control might be utilized.
Exposure
In order for an injury to occur, there must be a hazard and _______ to the hazard.
Exposure
If a company qualifies for a focused inspection, the OSHA inspector will typically look for _______hazards.
Focus four
To qualify for a focused inspection, the OSHA inspector must find project safety coordination by the ______.
General contractor
A hazard is anything that can cause a/an ____.
Injury
The three (3) components of a Personal Fall Arrest System are the anchor point, __________, and harness.
Lanyard
The goal of OSHA's construction inspections is to _________in the safety and health of employees at the work site.
Make a difference
OSHA conducts focused inspections only at construction companies because ____. Select all that apply.
Of the changing nature of the jobsite, Comprehensive inspections take too long
Wearing safety glasses around equipment is an example of ______ exposure control methods.
PPE
Safety is an acceptable level of ______.
Risk
To qualify for a focused inspection, the OSHA inspector must also find an adequate ______.
Safety and Health Plan
A/an _______ is acceptable fall protection.
Safety net
