IndiaBix - Flip-Flops and Timers
c
A basic S-R flip-flop can be constructed by cross-coupling which basic logic gates? A. AND or OR gates B. XOR or XNOR gates C. NOR or NAND gates D. AND or NOR gates
c
An astable multivibrator is a circuit that: A. has two stable states B. is free-running C. produces a continuous output signal D. is free-running and produces a continuous output signal
a
If both inputs of an S-R NAND latch are LOW, what will happen to the output? A. The output would become unpredictable. B. The output will toggle. C. The output will reset. D. No change will occur in the output.
d
Latches constructed with NOR and NAND gates tend to remain in the latched condition due to which configuration feature? A. asynchronous operation B. low input voltages C. gate impedance D. cross coupling
d
One example of the use of an S-R flip-flop is as a(n): A. transition pulse generator B. astable oscillator C. racer D. switch debouncer
a
The 555 timer can be used in which of the following configurations? A. astable, monostable B. monostable, bistable C. astable, toggled D. bistable, tristable
b
The equation for the output frequency of a 555 timer operating in the astable mode is: f = 1.43 / (C1 X(R1 + 2R2)) What value of C1 will be required if R1 = 1 kΩ , R2 = 1 kΩ, and f = 1 kHz? A. 0.33 µF B. 0.48 µF C. 480 µF D. 33 nF
a
The truth table for an S-R flip-flop has how many VALID entries? A. 3 B. 1 C. 4 D. 2
a
What is another name for a one-shot? A. monostable B. bistable C. astable D. tristable
b
What is one disadvantage of an S-R flip-flop? A. It has no Enable input. B. It has a RACE condition. C. It has no clock input. D. It has only a single output.
a
What is the significance of the J and K terminals on the J-K flip-flop? A. There is no known significance in their designations. B. The J represents "jump," which is how the Q output reacts whenever the clock goes HIGH and the J input is also HIGH. C. The letters represent the initials of Johnson and King, the co- inventors of the J-K flip-flop. D. All of the other letters of the alphabet are already in use.
b
When both inputs of a J-K flip-flop cycle, the output will: A. be invalid B. not change C. change D. toggle
b
Which of the following describes the operation of a positive edge-triggered D-type flip-flop? A. If both inputs are HIGH, the output will toggle. B. The output will follow the input on the leading edge of the clock. C. When both inputs are LOW, an invalid state exists. D. The input is toggled into the flip-flop on the leading edge of the clock and is passed to the output on the trailing edge of the clock.
a
Which of the following is correct for a gated D-type flip-flop? A. The Q output is either SET or RESET as soon as the D input goes HIGH or LOW. B. The output complement follows the input when enabled. C. Only one of the inputs can be HIGH at a time. D. The output toggles if one of the inputs is held HIGH.