ist 475 chaapter 2

Which three IOS troubleshooting commands can help to isolate problems with a static route? (Choose three.) A. ping B. show arp C. show ip interface brief D. show ip route E. show version F. tracert

A. ping C. show ip interface brief D. show ip route

Which type of static route that is configured on a router uses only the exit interface? A. Default static route B. Directly connected static route C. Fully specified static route D. Recursive static route

B. Directly connected static route

Assume the administrator has entered the ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 command. How would an administrator test this configuration? A. Delete the default gateway route on the router. B. Manually shut down the router interface used as a primary route. C. Ping any valid address on the 192.168.10.0/24 network. D. Ping from the 192.168.10.0 network to the 10.10.10.2 address.

B. Manually shut down the router interface used as a primary route.

What two pieces of information are needed in a fully specified static route to eliminate recursive lookups? (Choose two.) A. The AD for the destination network B. The interface ID exit interface C. The interface ID of the next-hop neighbor D. The IP address of the exit interface E. The IP address of the next-hop neighbor

B. The interface ID exit interface E. The IP address of the next-hop neighbor

The network administrator configures the router with the ip route 172.16.1.0 255.255.255.0 172.16.2.2 command. How will this route appear in the routing table? A. C 172.16.1.0 [1/0] via 172.16.2.2 B. C 172.16.1.0 is directly connected, Serial0/0 C. S 172.16.1.0 [1/0] via 172.16.2.2 D. S 172.16.1.0 is directly connected, Serial0/0

C. S 172.16.1.0 [1/0] via 172.16.2.2

What happens to a static route entry in a routing table when the outgoing interface associated with that route goes into the down state? A. The router automatically redirects the static route to use another interface. B. The router polls neighbors for a replacement route. C. The static route is removed from the routing table. D. The static route remains in the table because it was defined as static.

C. The static route is removed from the routing table.

Why would a floating static route be configured with an AD that is higher than the AD of a dynamic routing protocol that is running on the same router? A. To act as a gateway of last resort B. To be the priority route in the routing table C. To be used as a backup route D. To load-balance the traffic

C. To be used as a backup route

What type of route allows a router to forward packets even though its routing table contains no specific route to the destination network? A. Default route B. Destination route C. Dynamic route D. Generic route

A. Default route

What are two advantages of static routing over dynamic routing? (Choose two.) A. Static routing is more secure because it does not advertise over the network. B. Static routing is relatively easy to configure for large networks. C. Static routing requires little knowledge of the network for correct implementation. D. Static routing scales well with expanding networks. E. Static routing uses fewer router resources than dynamic routing.

A. Static routing is more secure because it does not advertise over the network. E. Static routing uses fewer router resources than dynamic routing.

What is the correct syntax of a floating static route? A. ip route 0.0.0.0 0.0.0.0 serial 0/0/0 B. ip route 172.16.0.0 255.248.0.0 10.0.0.1 C. ip route 209.165.200.228 255.255.255.248 serial 0/0/0 D. ip route 209.165.200.228 255.255.255.248 10.0.0.1 120

D. ip route 209.165.200.228 255.255.255.248 10.0.0.1 120