Network Layer: Chapter 6

अब Quizwiz के साथ अपने होमवर्क और परीक्षाओं को एस करें!

Which key combination allows a user to abort setup mode?

ctrl+c

During the boot process, where will the router bootstrap program look for the IOS image by default?

flash

Which feature on a Cisco router permits the forwarding of traffic for which there is no specific route?

gateway of last resort

If there are two or more possible routes to the same destination, the ______ is used to determine which route is used in the routing table.

longest match

Which portion of the network layer address does a router use to forward packets?

network portion

What are two functions that are provided by the network layer? (Choose two.)

providing end devices with a unique network identifier directing data packets to destination hosts on other networks

Which two files are loaded into RAM by the router when it boots? (Choose two.)

startup configuration IOS image

What is the command netstat -r used for?

to display the host routing table

During troubleshooting procedures, from which location will most Cisco routers load a limited IOS?

ROM

How does the network layer use the MTU value?

The MTU is passed to the network layer by the data link layer

Within a production network, what is the purpose of configuring a switch with a default gateway address?

The default gateway address is used to forward packets originating from the switch to remote networks

Which value, that is contained in an IPv4 header field, is decremented by each router that receives a packet?

Time-to-live

Which router bootup sequence is correct?​

1 - perform the POST and load the bootstrap program 2 - locate and load the Cisco IOS software 3 - locate and load the startup configuration file or enter setup mode

A packet arrives at a router interface. The router goes through a series of steps to determine where the packet should be forwarded. Place the steps of the router forwarding process in the correct order. (Not all options are used.)

1 -> examine packet header 2 -> determine destination network 3 -> examine routing table 4 -> identify exit interface to destination from route entry 5 -> move packet to forwarding interface

Which IPv4 address can a host use to ping the loopback interface?

127.0.0.1

Refer to the exhibit. Using the network in the exhibit, what would be the default gateway address for host A in the 192.133.219.0 network?

192.133.219.1

A packet leaving PC-1 has to traverse __________ hops to reach PC-4.​

3


संबंधित स्टडी सेट्स

Topic A: Configure and Use Linux

View Set

Chapter 21: The Immune System: Innate and Adaptive Body Defenses

View Set

Essentials of Investments: Chapter 10

View Set

2.5 Roadways and Their Unique Risks

View Set

Ch4 Analysing the marketing environment.

View Set

Final COMP 530 - Operating Systems

View Set