Penny ch 1

Areas of high pressure and density are referred to as: a. Compressions b. Rarefactions c. Diffractions d. Refractions

A. Compressions

Which of the following is determined by the sound source only? a. Frequency b. Wavelength c. SPL d. Propagation speed

A. Frequency

Density and propagation speed are: a. Inversely related b. Directly related c. Directly proportional d. Unrelated

A. Inversely related

What time is defined as the beginning of one pulse to the beginning of the next pulse and, therefore, includes both the "on" and "off" time? a. PRP b. PD c. DF d. PRF

A. PRP

What is the total amount of attenuation that occurs if a 6.0-MHz sound beam travels through 4 cm of soft tissue? a. 24 dB b. 12 dB с. 6 dB d. 1.5 dB

B. 12db

The prefix "centi" denotes: a. Thousandths b. Hundredths c. Millions d. Hundreds

B. Hundredths

Pressure is typically expressed in: a. Frequency b. Pascals c. Decibels d. Kilograms per centimeter cubed

B. Pascals

The inertia of the medium describes its: a. Attenuation characteristics b. Stiffness c. Density d. Elasticity

C. Density

Which of the following is defined as the number of ultrasound pulses emitted in 1 second? a. PRP b. DF c. PRF d. SPL

C. PRF

The change in the direction of the original sound wave that occurs when sound interacts with two different tissue types that have a dif- ferent propagation speed is referred to as: a. Wavelength b. Scattering c. Refraction d. Absorption

C. Refraction

Which of the following is defined as only the active time? a. DF b. PRF c. Period d. PD

D. PD

Which of the following describes the amount of refraction that occurs at an interface? a. Bernoulli's law b. Poiseuille's law c. Law of reflection d. Snell's law

D. Snells law

What are the units of DF? a. dB b. dB/cm c. Hz d. Unitless

D. Unitless

Which of the following is determined by the sound source and medium? a. Propagation speed b. Frequency c. Period d. Wavelength

D. Wavelength

An increase in PRF would lead to: a. An increase in DF b. decrease in PD c. An increase in the number of cycles d. A decrease in resolution

a. An increase in DF

All of the following are true of power except: a. As amplitude increases, power remains the same b. Power is proportional to amplitude squared c. Intensity is proportional to power d. Power is measured in milliwatts

a. As amplitude increases, power remains the same

As a sound wave travels through the human body, the intensity of the sound wave decreases as a result of: a. Attenuation b. Elevational resolution c. Huygen's principle d. Refraction

a. Attenuation

Density is typically measured in: a. Kilograms per centimeter cubed b. Millimeters c. Watts per square centimeter d. Pascals

a. Kilograms per centimeter cubed

Micro denotes: a. Millionth b. Hundredth c. Million d. Billionth

a. Millionth

The attenuation coefficient in soft tissue is equal to: a. One-half of the operating frequency b. Double the operating frequency c. Frequency times path length d. The total decibels

a. One-half of the operating frequency

Damping of the sound beam: a. Reduces the SPL b. Increases the SPL c. Increases the PD d. Has no impact on SPL or PD

a. Reduces the SPL

Which of the following is described as the ability of an object to re sist compression and relates to the hardness of a medium? a. Stiffness b. Density c. Pressure d. Inertia

a. Stiffness

Which of the following is an appropriate unit of measurement for propagation speed? a. millimeters per microsecond (mm/us) b. watts per square centimeter (W/cm2) c. microseconds (ms) d. kilohertz (kHz)

a. millimeters per microsecond (mm/us)

The typical range of frequency for diagnostic ultrasound imaging is a. 20 to 20,000 Hz b. 1 to 20 MHz c. 2 to 15 kHz d. 12 to 100 MHz

b. 1 to 20 MHz

The DF for CW ultrasound is: a. 1.0% b. 100% с. 20,000 Hz d. 8 Pa

b. 100%

lf the angle of incidence is 40°, what is the angle of transmission at the interface if medium 1 has a propagation speed of 1320 m/s and medium 2 has a propagation speed of 1700 m/s? a. 0° b. >40° C. <40° d. Cannot tell the angle of transmission

b. >40°

The major component of attenuation is: a. Scatter b. Absorption c. Transmission d. Refraction

b. Absorption

Which of the following would have the highest propagation speed? a. Air b. Bone c. Soft tissue d. Water

b. Bone

As imaging depth increases, PRP a. Remains constant b. Increases c. Decreases d. Doubles

b. Increases

What is the change in intensity if the power decreases by half? a. Intensity doubles b. Intensity is halved c. Intensity is one-fourth d. Intensity does not change

b. Intensity is halved

All of the following are true of wavelength except: a. It is determined by both the medium and the sound source b. It is equal to the period divided by the frequency c. It is inversely related to frequency d. It is directly related to period

b. It is equal to the period divided by the frequency

If only the density of a medium is increased, then the: a. Propagation speed will increase b. Propagation speed will decrease c. Propagation speed will stay the same d. None of the above

b. Propagation speed will decrease

The portion of the sound beam where the molecules are farther apart describes an area of: a. Compression b. Rarefaction c. Refraction d. Amplitude

b. Rarefaction

Which of the following requires an oblique interface and a propaga- tion speed mismatch? a. Reflection b. Refraction c. Normal incidence d. Damping

b. Refraction

All of the following relate to the strength of the sound wave except: a. Amplitude b. Wavelength c. Intensity d. Power

b. Wavelength

What are the units for pressure? a. feet, inches, centimeters, or miles b. pascals or pounds per square inch c. kilograms per centimeter cubed d. hertz, kilohertz, or megahertz

b. pascals or pounds per square inch

Which of the following would be considered ultrasonic? a. 10 Hz b. 18 kHz c. 0.5 MHz d. 200 Hz

c. 0.5 MHz

Adding damping to the transducer improves which type of resolution? a. Transverse resolution b. Temporal resolution c. Axial resolution d. Elevational resolution

c. Axial resolution

The percentage of time that the ultrasound system is producino pulses of ultrasound describes the: a. PRP b. PD c. DF d. PRF

c. DF

As imaging depth increases, the PRF must: a. Not change b. Increase c. Decrease d. PRF does not relate to imaging depth

c. Decrease

What term is defined as "the power of a wave divided by the area over which the power is distributed?" a. Amplitude b. Power c. Intensity d. Absorption

c. Intensity

Transducers have material within them that, when electronically stimulated, produces ultrasound waves. This is most likely some form of: a. Tungsten acetate b. Dilithium zirconium c. Lead zirconate titanate d. Barium sulfate

c. Lead zirconate titanate

SPL can be calculated by: a. Multiplying the number of cycles by the frequency b. Dividing the period by the frequency c. Multiplying the number of cycles by the wavelength d. Dividing the number of cycles by the wavelength

c. Multiplying the number of cycles by the wavelength

In clinical imaging, the wavelength typically measures between: a. 1 and 10 Hz b. 1540 and 2000 m/s c. O and 1 d. 0.1 to 0.8 mm

d. 0.1 to 0.8 mm

Which of the following is considered the speed of sound in soft tissue? a. 1.54 m/s b. 0.77 m/s c. 100 mW/cm2 d. 1540 m/s

d. 1540 m/s

The maximum value or minimum value of an acoustic variable minus the equilibrium value of that variable describes the: a. Power b. Intensity c. DF d. Amplitude

d. Amplitude

What is the change in power if the amplitude triples? a. It doubles b. It triples c. It quadruples d. It increases nine times

d. It increases nine time

Which of the following would have the lowest propagation speed? a. Water b. Soft tissue c. Bone d. Lung tissue

d. Lung tissue

Sound is technically a: a. Transverse and longitudinal wave b. Mechanical and transverse wave c. Nonmechanical and pressure wave d. Mechanical and longitudinal wave

d. Mechanical and longitudinal wave

Which of the following is described as the distance over which one cycle occurs? a. PD b. DF c. Period d. Wavelength

d. Wavelength