SolidWorks: lesson 9
अब Quizwiz के साथ अपने होमवर्क और परीक्षाओं को एस करें!
What special piece of sketch geometry is useful, but not required for a revolve feature?
Centerline.
What features did you use to create the candlestick?
Revolved boss, swept boss, and extruded cut.
Unlike an extruded feature, a swept feature requires a minimum of two sketches. What are these two sketches?
Sweep section and sweep path.
What information does the pointer provide while sketching an arc?
The arc radius, arc angle in degrees and information to the sketch geometry.