Architecture State Assessment Review 1
What does the acronym AIA stand for? Architectural Institute of America American and International Architects American Institute of Architects Association of International Architects
American Institute of Architects
A label or tag that attaches data to a block is called what? Dynamic blocks Attributed blocks String blocks Wooden blocks
Attributed blocks
A C size sheet is equal in size to two of these sheets laid side by side? A. B. D. None of the above.
B.
What command is used to place a block into a drawing? Insert Add Copy & Paste All the above
Insert
What are the diagonal lines in a section view called? Section Lines Cutting plane lines Horizontal plane lines Straight plane lines
Section Lines
All of the terms below are used to describe the creation of technical drawings except: Drafting, Engineering graphics, CAD (Computer Aided Design) Sketching
Sketching
Where is a removed section placed on a drawing? On another sheet Somewhere else on the sheet Deleted from the sheet On another tab
Somewhere else on the sheet
Which ratio below indicates that a drawing is Full size? 1=1 1/1 1:1 All of the above
All of the above
In what field must a drafter be familiar with floor plans, elevations and construction details? Architectural Civil Mechanical Electrical
Architectural
What do the arrows on a cutting plane line indicate? Direction section is viewed Placement of center lines The top of the sheet None of the above
Direction section is viewed
In what field of technical drawing are isometric techniques most often used to create a pictorial image? Archeology field Architectural field Mechanical field Civil field
Mechanical field
What is a block? One set of a cube Pre-drawn object Group of drawings files None of the above
One set of a cube
In an auxiliary view, the plane of projection is _________ relative to the inclined plane. oblique parallel skewed perpendicular
perpendicular
Sheet size for a Mechanical B size sheet? 17 x 11 18 x 12 841 x 594 36 x 24
17 x 11
In an offset section, the cutting plane line is offset at what angle? 45 degree angle 35 degree angle 90 degree angle 25 degree angle
90 degree angle
What is the angle of an object's vertical lines in an isometric drawing? 90 degree angle 45 degree angle 30 degree angle 60 degree angle
90 degree angle
What is the angle of an object's horizontal lines in an isometric drawing? 60 degree angle 180 degree angle 30 degree angle None of the above
30 degree angle
In what field must a drafter be familiar with roads, bridges, water and waste-water systems, and surveying techniques? Architectural Civil Electronics Mechanical
Civil
What does 1/4"=1'-0" represent on an architectural drawing of a house? That scale of the drawing is 1=4. That 1 foot on the constructed building equals ¼ inch on the drawing. That the house should be built 1/4th scale. That a distance of 100 feet will measure 12.5 inches on the drawing.
That 1 foot on the constructed building equals ¼ inch on the drawing.
An auxiliary view may be needed if the features of an object do not appear true shape in __________? an oblique view an isometric view any of the regular views All of the above
any of the regular views