C-130J Loadmaster MQF
The fuel unbalance limits between left and right wing is ____.
1,500 pounds
The fuel unbalance limits between tanks of a symmetrical pair ( main or external) is _______
1000 lbs
The height limitations for oversized single items of palletized cargo is ______ inches above the surface of the pallet.
103 inches
The cargo ramp must be opened at least ___ inches to disconnect the ADS arms
12 inches
Seats are provided for up to ___ ground troops or up to ____ paratroopers (-30)
128, 92
Wheeled cargo Axle load flight limits on the tread ways in compartments F through H for C-130J (-30) and compartments E through J for C-130J (short) is limited to _____ pounds inflight.
13,000
What is the PSI range of a main fuel tank boost pump?
15-24
Airspeed limitation with the paratroop doors opening / closing and opened but not locked is _____ knots
150
The maximum FDP ( flight duty period) for a basic aircrew is _____ hours ( ______when both autopilots are inoperable or neither audiopilot can be coupled to the flight director)
16 / 12
The maximum CDT (crew duty time) is _____ hours for a basic aircrew and ______ hours for an augmented crew.
18, 20
If internal tire pressure exceeds 100 PSI, refer to specific procedures in ______.
1C-130J-9, Section 6
For Lucas winch only, a loading team may consist of ___ members as long as the winch operator uses a pendant electrical cable long enough to monitor clearance.
2
Crewmembers will fit and adjust LPU's for overwater flights and will wear them on over water missions below _____. (EXCEPTION; LPU's need not be worn for takeoffs, landings, or approaches)
2,000 feet AGL
Wheeled Cargo Axle loads flight limits in compartments K, L, and M, are limited to ____ pounds on the treadways and _____ pounds between the treadways inflight.
2,500 / 1,200
One unobstructed emergency exit will be available for each ___ passengers / troops
20
When fuel load is unknown, load plan for a _____ percent of MAC zero fuel.
20-22
If battery voltage is between ___recharge ( in Airplane) or replace battery and rerun the battery test.
22VDC and 24 VDC
The ramp locks provide an ultimate restraint for of ____ in the forward direction and ____ pounds in the aft direction when the lock is locked.
25,925, 6,500
Oxygen is supplied from a ___ liquid oxygen converter.
25-liter
The oxygen system used diluter-demand automatic pressure breathing regulators and operates at an indicated pressure of ___ to ___ PSI in a static system under no flow condition. Under continuous breathing condition the pressure should indicate ____ to ____.
270, 455; 270, 340
What is the PSI range of a fuel transfer pump?
28-40
All vehicle winching must be closely coordinated by a loading team of at least ___ members.
3
If a lock does not fully engage the pallet detent within ____ seconds, in transit indications will be sent to the PLCU and MFCD.
3
Wrapped type cables are limited to no more than ___ broken wire per inch, per strand , provided no more than ____ broken wire exist in a ____ -inch length of cable.
3 / 6 / 1
To prevent damage to the airplane rollers when loading palletized / airdrop loads that weigh over 18,000 lbs, ensure that the 40k loader bed is approximately ___ inches higher than the aircraft rollers.
3 1/2
For loadmasters or maintenance ground training that require the use of the ECHS RECP CARGO JETTISON switches, they must always be placed to the ARM position for at least ___ seconds prior to being placed to the RELEASE position. Failure to do this can render the locks ______.
3, unusable
During preloading operations, ensure the nose gear strut does not bottom out. (The nose gear strut is bottoming out if less than ___ of the strut piston is visible.
3/4 inch
Operation of the electronic equipment for longer than ____ minute at temperatures above ____ degrees F without adequate cooling may reduce the life expectancy of those components.
30, 95
Under satisfactory conditions (static line exit), the minimum acceptable emergency bailout attitude is _____ feet above terrain.
400
safety supplements covering loss of life will get to you in _____ hours by message, and those concerning serious damage to equipment ___ days by mail.
48, 10
What is the minimum amount of oxygen required for all flights?
5 liters
It is possible, and permissible to carry a load of up to _____ pounds on the ramp during flight as long as the center of gravity of the loaded aircraft does not fall outside the permissible limits and as long as the restrictions shown in the applicable flight manual are not exceeded.
5,000 lbs
When primary Fuel management, tanks NO. 1 and NO.4 always contain ____ to ____ pounds more fuel than thanks 2 and 3 except when total usable fuel is less than 6,000 lbs
500 - 1,000
The Lucas winch consists of a winch assembly, a control pendant and two control pendant electrical cables and develops a pulling power of ____ pounds.
6,500
The maximum load that may be imposed on the auxiliary ground loading ramps is ______ pounds per wheel or ____ pounds per axle.
6,500 / 13,000
The maximum continuous APU EGT is ______
680 degrees C
Side nets may be used for restraint without the top net, provided that the side nets are pulled tight and secured by tie down straps. The straps will be connected to the highest level of side rings on or near the top of the cargo. A minimum of ____ straps, _____ longitudinal and ____ lateral, shall be used.
7,4,3
Maximum load allowed per bridge plate is ____.
7,500 lbs
The maximum height of cargo on pallets positions on the cargo ramp shall not exceed _____ inches.
77
Pallet position 7 (-30) for 5 (C/W) is limited to ____ pounds.
8,500
Up to ___ litters with ____ attendants may be configured on the C130J series aircraft (-30)
97 , four
Inflight use of the APU is limited to ____. Do not attempt ____ during flight.
AC generator operation / APU Bleed air.
Make every effort to exchange tie down equipment on a one to one basis. If this is not possible, annotate the ______
AF Form 4069
Simultaneous operation of the cargo ramp and door on the ground is permissible provided ______.
Adequate clearance is maintained.
When the LOCKS switch on the RECP is placed to the LOCKS ALL position, what happens to the aft hold downs and the ramp locks?
Aft hold downs and ramp locks are not affected
If bridge shoring is used beneath wheeled vehicles, use the _____ floor limits instead of the ____ limits to determine allowable floor pressure in PSI.
Agency offering cargo for air shipment
It may be necessary to set the ___ prior to winching heavy loads.
Aircraft Breaks
Ensure that protective devices have been removed and that intakes and exhausts are free of foreign objects before operating _____.
All of the above ( APU - engines, Air conditioning, Anti-icing systems
Normal operation of the electric locks is accomplished through the _____ and _____.
All of the above ( MFCD / PLCU)
Do not wear weapons off the flight line except to and from the:
All of the above ( Other facilities associated with aircrew activities, armory, C2)
Concurrent ground operations: do not load / unload cargo containing ______
All of the above ( explosives, oxygen, flammable gases or liquids)
When manually operating the cargo ramp and door: The cargo door and ramp shall not be operated unless the ____ are in the stowed position. The ______ shall be closed.
Anchor cable aft supports / ground test valve
A non-current unqualified loadmaster may serve as a primary aircrew member on any mission when supervised by a ____ or ____.
Both A and B Instructor or examiner.
When manually driving the locks to the unlocked position the correct sequence of action is:
Both A and C ( manually drive the DIS-ARM ARM actuator to ARM / Manually drive the LOCK UNLOCK actuator to unlock)
Loadmasters will verify that all ___ are clear and unobstructed with locking pins removed
Both A and C (Hatches / doors)
Operating procedures, techniques, etc., that may result in damage to equipment if not carefully followed is known as what?
Caution
(ERO) if downloading to an empty aircraft, a _____ is not required.
DD Form 365-4
It is recommended that primary crewmemers wear nomex gloves during ______, _____ and ______.
Engine start, takeoff, landing
Oxygen on board for takeoff must be sufficient to accomplish the planned flight from the ____ to a suitable recovery base, should oxygen be required.
Equal time point
Lock in the locked position with extraction parachute force applied against them will arm arm or release.
False
Visually inspect the crew entrance door for _____ engagement and that mechanism is against stop bolts.
Hook
If landing with nose gear retracted and main gears down, what do you do with cargo, if applicable?
If cargo can be safely moved, shift it to the most aft limit practicable.
Load shift formula:
LSA x LSW = A/C WT x CG CHANGE IN INCHES
Enter / exit nose wheel for the ____ side only. Do not enter / exit from the ____ side of the nose wheel due to the possible hazard of venting liquid oxygen
Left / right
If axles are _____, the sum of the axle weights must not exceed axle load limits.
Less than four feet apart.
When operating the ramp and door manually, the position 2 on the ramp control dial _____.
Lowers the ramp.
When ____, the axillary ground loading ramps may be left installed and secured for flight.
Mission requirements dictate.
During a ground evacuation: if hot breaks are suspected or a main wheel well fire exists, chock the ____ only.
Nose gear
Which emergency exits should be opened for a gear up landing?
Over head except hatches, side exits and paratroop doors
do not jettison _____ or perform non-personnel airdrops with the paratroop door rail sections removed. EXCEPTION:
Pallets - platforms / non-CVR single stick CDS Airdrops
Park diesel powered vehicles with automatic transmissions in ____ and those with manual transmissions in ____.
Park / Neutral
Notes amplifying checklists procedures or limitations may be added to the checklist in ___.
Pencil
Loadmaster checklist items identified as asterisk___ prior t flight after a prolonged stop over (crew rest) or after a crew change for a different mission profile. Items required to accomplish a specific mission ___ after a crew change.
Shall be inspected / will be inspected
How much restraint will be provided if a bolt is loose or missing in a restraint rail?
Shall not be used for cargo restraint.
The words ___ and ___ are used to indicate a mandatory requirement.
Shall, Will
The alarm bell signal for ditching or crash landing is _____ rings to prepare for ditching or lash landings and _____ ring to brace for impact.
Six short rings / one long sustained.
Prior to raising the ramp ensure ______?
That the ramp locks are retracted and the ramp seal area is clear.
The alarm signal to prepare for bailout is what?
Three short rings
There are two methods to secure the main landing gear in the event that the drag pin does not engage or the shelf bracket is broken. The method is _____. The alternate method is _____.
Tiedown chaines / using the MLG emergency tie down assembly
( SMOKE DETECTOR / FIRE DETECTION TEST) Pressing the MASTER WARNING switch light after the ACAWS appears in order to silence the audio will not interrupt the test.
True
At remote locations, two of the four chocks may be used for loading only as a last resort for safety.
True
During engine running onloads or when planned ground times require, a combined load C/B may be used if a validated load plan is presented, and the aircraft is loaded per the load plan.
True
Ensure the Nose Landing Gear is not chained and NLG pin is installed prior to onloading / offloading
True
If the battery voltage is readable but flickering when the aircraft is on battery only power, the displayed battery voltage is correct.
True
MFCD operation is suspended when the locks switch is moved from the NORM and LOCKS ALL.
True
Minimum Equipment list policy. Equipment / systems not listed in table 4.1 through table 4.21 shall be considered required for flight without exception.
True
The Lucas winch will automatically sit off and apply the cable break if the cable load exceeds the maximum pulling capacity.
True
There is no requirement to keep the ramp on the ramp support once the ramp actuators are preloaded.
True
Use extreme care when opening fuel tank caps or flapper valves to verify fuel quantity. Trapped fuel under pressure could spray from the tanks and cause injury.
True
With the vehicle positioned in the aircraft, the operator will remain at the controls until after the initial fore and ft restraints have been applied.
True
tobacco use in all forms, including electronic nicotine delivery systems, is prohibited on all aircraft.
True
The ____ is responsible for making each item of cargo and all vehicle - cargo with the correct gross weight and center of balance point.
agency offering cargo for an air shipment
Do not activate the ____ until the area around the ___ is / are clear of people and equipment.
air deflector doors / Doors
The weight limitations chart (primary fuel management) may be used to determine what 3 criterial
airspeed-maneuver limitations / maximum - minimum fuel or gross weight / and or maximum cargo weight.
When using cables to pull loads up the ramp, attach the cables _____ on the load to help reduce cable tension.
as low as possible
on entering the airplane, if fumes are present and are suspected of being flammable or toxic, _____.
do not continue with preflight check until the fumes are investigated and eliminated.
A roller station is defined as the ______.
lateral alignment of 4 rollers on a fuselage station.
Forklift operations on the auxiliary loading ramps, on the cargo ramp, or inside the cargo compartment for other than _____ unloading / offloading are prohibited.
prime mover related
Maintain a _____ when the hook us within 10 feet of the winch sleeve.
remote
Why will the nose wheels not be chocked for loading/offloading operations?
rocking of the fuselage during loading causes the the nose wheels to move back and forth slightly.