ccna1v7 ch. 8-10
Which destination address is used in an ARP request frame?
FFFF.FFFF.FFFF
What property of ARP allows MAC addresses of frequently used servers to be fixed in the ARP table?
A static IP-to-MAC address entry can be entered manually into an ARP table.
What happens when the transport input ssh command is entered on the switch vty lines?
Communication between the switch and remote users is encrypted.
What property of ARP causes cached IP-to-MAC mappings to remain in memory longer?
Entries in an ARP table are time-stamped and are purged after the timeout expires.
A new network administrator has been asked to enter a banner message on a Cisco device. What is the fastest way a network administrator could test whether the banner is properly configured?
Exit privileged EXEC mode and press Enter.
Which statement describes a feature of the IP protocol?
IP relies on upper layer services to handle situations of missing or out-of-order packets.
Refer to the exhibit. Consider the IP address configuration shown from PC1. What is a description of the default gateway address?
It is the IP address of the Router1 interface that connects the PC1 LAN to Router1.
What are two potential network problems that can result from ARP operation?
On large networks with low bandwidth, multiple ARP broadcasts could cause data communication delays., Network attackers could manipulate MAC address and IP address mappings in ARP messages with the intent of intercepting network traffic.
Which interfaces in each router are active and operational?
R1: G0/0 and S0/0/0 R2: G0/1 and S0/0/0
What information does the loopback test provide?
The TCP/IP stack on the device is working correctly.
A computer can access devices on the same network but cannot access devices on other networks. What is the probable cause of this problem?
The computer has an invalid default gateway address.
A router boots and enters setup mode. What is the reason for this?
The configuration file is missing from NVRAM.
What is the effect of using the Router# copy running-config startup-config command on a router?
The contents of NVRAM will change.
What property of ARP causes a reply only to the source sending an ARP request?
The source MAC address appears in the header of the Ethernet frame.
The global configuration command ip default-gateway 172.16.100.1 is applied to a switch. What is the effect of this command?
The switch can be remotely managed from a host on another network.
Refer to the exhibit. The exhibit shows a small switched network and the contents of the MAC address table of the switch. PC1 has sent a frame addressed to PC3. What will the switch do with the frame?
The switch will forward the frame to all ports except port 4.
What property of ARP causes the NICs receiving an ARP request to pass the data portion of the Ethernet frame to the ARP process?
The type field 0x806 appears in the header of the Ethernet frame.
Which statement describes the treatment of ARP requests on the local link?
They are received and processed by every device on the local network.
Which field in the IPv4 header is used to prevent a packet from traversing a network endlessly?
Time to Live
What is a basic characteristic of the IP protocol?
connectionless
Which term describes a field in the IPv4 packet header that contains a unicast, multicast, or broadcast address?
destination IPv4 address
What important information is examined in the Ethernet frame header by a Layer 2 device in order to forward the data onward?
destination MAC address
Which term describes a field in the IPv4 packet header that contains an 8-bit binary value used to determine the priority of each packet?
differentiated services
Which term describes a field in the IPv4 packet header used to detect corruption in the IPv4 header?
header checksum
telnet
insecure remote access
R1(config-if)#
ip address 192.168.4.4 255.255.255.0
Which two types of IPv6 messages are used in place of ARP for address resolution?
neighbor solicitation, neighbor advertisement
Which two functions are primary functions of a router?
packet forwarding, path selection
phase 1
perform post and load up bootstrap
console
preferred out of band access method
What IPv4 header field identifies the upper layer protocol carried in the packet?
protocol
SSH (Secure Shell)
remote access method that uses encryption
Which term describes a field in the IPv4 packet header that contains a 4-bit binary value set to 0100?
version
When transporting data from real-time applications, such as streaming audio and video, which field in the IPv6 header can be used to inform the routers and switches to maintain the same path for the packets in the same conversation?
flow label
Which three commands are used to set up secure access to a router through a connection to the console interface?
line console 0, login, password cisco
phase 2
locate and load cisco ios software
R1(config-line)#
login
Which term describes a field in the IPv4 packet header used to identify the next level protocol?
protocol
aux
remote access via dialup connection
What routing table entry has a next hop address associated with a destination network?
remote routes
R1(config)#
service password-encryption
A network technician issues the arp -d * command on a PC after the router that is connected to the LAN is reconfigured. What is the result after this command is issued?
The ARP cache is cleared
What are two services provided by the OSI network layer?
routing packets toward the destination, encapsulating PDUs from the transport layer
Which term describes a field in the IPv4 packet header that contains a 32-bit binary value associated with an interface on the sending device?
source IPv4 address
Refer to the exhibit. PC1 attempts to connect to File_server1 and sends an ARP request to obtain a destination MAC address. Which MAC address will PC1 receive in the ARP reply?
the MAC address of the G0/0 interface on R1
R1#
copy running-config startup-config
What statement describes the function of the Address Resolution Protocol?
ARP is used to discover the MAC address of any host on the local network.
What property of ARP allows hosts on a LAN to send traffic to remote networks?
Local hosts learn the MAC address of the default gateway.
Which term describes a field in the IPv4 packet header used to limit the lifetime of a packet?
TTL
What will happen if the default gateway address is incorrectly configured on a host?
The host cannot communicate with hosts in other networks.
How do hosts ensure that their packets are directed to the correct network destination?
They have to keep their own local routing table that contains a route to the loopback interface, a local network route, and a remote default route.
What is one advantage that the IPv6 simplified header offers over IPv4?
efficient packet handling
R1>
enable
Refer to the exhibit. A user PC has successfully transmitted packets to www.cisco.com. Which IP address does the user PC target in order to forward its data off the local network?
172.20.0.254
Why is NAT not needed in IPv6?
Any host or user can get a public IPv6 network address because the number of available IPv6 addresses is extremely large.
Where are IPv4 address to Layer 2 Ethernet address mappings maintained on a host computer?
ARP cache
Within a production network, what is the purpose of configuring a switch with a default gateway address?
The default gateway address is used to forward packets originating from the switch to remote networks.
What property of ARP causes the request to be flooded out all ports of a switch except for the port receiving the ARP request?
The destination MAC address FF-FF-FF-FF-FF-FF appears in the header of the Ethernet frame.
What property of ARP forces all Ethernet NICs to process an ARP request?
The destination MAC address FF-FF-FF-FF-FF-FF appears in the header of the Ethernet frame.
Under which two circumstances will a switch flood a frame out of every port except the port that the frame was received on?
The frame has the broadcast address as the destination address., The destination address is unknown to the switch.
phase 3
locate and load startup config file
FastEthernet1/1
packets with destination of 172.17.10.5
FastEthernet1/0
packets with destination of 172.17.12.10
FastEthernet0/1
packets with destination of 172.17.14.8
FastEthernet0/0
packets with destination of 172.17.6.15
serial0/0/0
packets with destination of 172.17.8.20
Which parameter does the router use to choose the path to the destination when there are multiple routes available?
the lower metric value that is associated with the destination network
What is the aim of an ARP spoofing attack?
to associate IP addresses to the wrong MAC address
What are two functions of NVRAM?
to retain contents when power is removed, to store the startup configuration file
