CH4_Net225

Lakukan tugas rumah & ujian kamu dengan baik sekarang menggunakan Quizwiz!

Which statement describes an EtherChannel implementation?

A trunked port can be part of an EtherChannel bundle.

What is an advantage of using LACP?

Allows automatic formation of EtherChannel links

Which three options must match in order to establish an EtherChannel between two directly connected switches? (Choose three.)

Duplex settings Speed of the interfaces VLAN memberships

Which statement is true regarding the use of PAgP to create EtherChannels?

It is Cisco proprietary

Which statement describes a characteristic of EtherChannel?

It is made by combining multiple physical links that are seen as one link between two switches.

What is the purpose of HSRP?

It provides a continuous network connection when a router fails.

Which two protocols are used to implement EtherChannel? (Choose two.)

Port Aggregation Protocol Link Aggregation Control Protocol

An EtherChannel link using LACP was formed between two switches, S1 and S2. While verifying the configuration, which mode combination could be utilized on both switches?​

S1-passive and S2-active

What is a best practice to use before beginning an EtherChannel implementation?

Shut down each of the affected interfaces.

Which PAgP mode combination will establish an EtherChannel?

Switch 1 set to desirable; switch 2 set to desirable

What is a requirement to configure a trunking EtherChannel between two switches?

The allowed range of VLANs must be the same on both switches

Which nonproprietary protocol provides router redundancy for a group of routers which support IPv4 LANs?

VRRPv2

Refer to the exhibit. A network administrator configured routers R1 and R2 as part of HSRP group 1. After the routers have been reloaded, a user on Host1 complained of lack of connectivity to the Internet The network administrator issued the show standby brief command on both routers to verify the HSRP operations. In addition, the administrator observed the ARP table on Host1. Which entry should be seen in the ARP table on Host1 in order to gain connectivity to the Internet?

Virtual IP address and the virtual MAC address for the HSRP group 1

A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode passive. Which command must be used on SW2 to enable this EtherChannel?

channel-group 1 mode active

Fill in the blank. In FHRP operation, two or more routers are represented as a single ________ router.

virtual


Set pelajaran terkait

Cranial Nerves except Trigeminal and Facial: Head and Neck Innervation

View Set

testout final - foundations of cybersecurity

View Set

Religion Module #2: Karl Marx & Capitalism

View Set

Chapt. 4 - Medical Privacy - HIPAA Privacy Rule & Security Rule

View Set

AP Macroeconomics Modules 1, 2 & 3

View Set

UNIT 2- REAL ESTATE LICENSE AND QUALIFICATIONS FOR LICENSURE (CONTENT)

View Set