CISCO - ITN Chapter 4

multi mode fiber

uses LEDs as the light source larger core allows for multiple paths for the light commonly used with LANs.

A network administrator notices that some newly installed Ethernet cabling is carrying corrupt and distorted data signals. The new cabling was installed in the ceiling close to fluorescent lights and electrical equipment. Which two factors may interfere with the copper cabling and result in signal distortion and data corruption? (Choose two.)

EMI RFI​

Which statement describes an extended star topology?

End devices connect to a central intermediate device, which in turn connects to other central intermediate devices.

What is one advantage of using fiber optic cabling rather than copper cabling?

It is able to carry signals much farther than copper cabling.

What acronym is used to reference the data link sublayer that identifies the network layer protocol encapsulated in the frame?

LLC

What is true concerning physical and logical topologies?

Logical topologies refer to how a network transfers data between devices.

Match the characteristics to the correct type of fiber.

Multimode Fiber - LED as light source - several paths of light into the fiber - generally used with LANs Single-mode Fiber - only one ray of light into the fiber - generally used for campus backbone - laser as light source

What are two examples of hybrid topologies?

partial mesh extended star

A network administrator is designing the layout of a new wireless network. Which three areas of concern should be accounted for when building a wireless network?

- security - interference - coverage area

Refer to the exhibit. The PC is connected to the console port of the switch. All the other connections are made through FastEthernet links. Which types of UTP cables can be used to connect the devices?​

1 - rollover, 2 - straight-through, 3 - crossover

Refer to the exhibit. Which statement describes the media access control methods that are used by the networks in the exhibit?

Network 1 uses CSMA/CD and Network 3 uses CSMA/CA.*

Which type of connector does a network interface card use?

RJ-45

uses laser as the light source small core produces a single straight path for light commonly used with campus backbones

Single mode fiber

As data travels on the media in a stream of 1s and 0s how does a receiving node identify the beginning and end of a frame?​

The transmitting node inserts start and stop bits into the frame.

Refer to the exhibit. What is wrong with the displayed termination?

The untwisted length of each wire is too long.

Why are two strands of fiber used for a single fiber optic connection?

They allow for full-duplex connectivity.

The term ____________ indicates the capacity of a medium to carry data and it is typically measured in kilobits per second (kb/s) or megabits per second (Mb/s).​

bandwidth

Which layer of the OSI model is responsible for specifying the encapsulation method used for specific types of media?

data link

What is contained in the trailer of a data-link frame?

error detection

Which method of data transfer allows information to be sent and received at the same time?

full duplex

Which characteristic describes crosstalk?

the distortion of the transmitted messages from signals carried in adjacent wires

What is indicated by the term throughput?

the measure of the bits transferred across the media over a given period of time

What is the definition of bandwidth?

the speed at which bits travel on the network

What are two reasons for physical layer protocols to use frame encoding techniques? (Choose two.)

to distinguish data bits from control bits to reduce the number of collisions on the media

What is a role of the Logical Link Control sublayer?

to mark frames to identify the network layer protocol being carried

What is the function of the CRC value that is found in the FCS field of a frame?

to verify the integrity of the received frame

What technique is used with UTP cable to help protect against signal interference from crosstalk?

twisting the wires together into pairs

What are two services performed by the data link layer of the OSI model? (Choose two.)

- It accepts Layer 3 packets and encapsulates them into frames. - It provides media access control and performs error detection.