IPv4 Header

Source Address

11. This field is 32 bits in length. It is the sender's IP address.

Fragment Offset

7. This field is 13 bits in length. It indicates (in bytes) where in the packet this fragment belongs. The first fragment has an offset of 0.

20 bytes

Length of IPv4 header

Version

1. This field is 4 bits in length. It indicates the IP header's format, based on the version number. Version 4 is the current version; therefore, this field is set to 0100 (4 in binary) for IPv4 packets. This field is set to 0110 (6 in binary) in IPv6 networks.

Header Checksum

10. This field is 16 bits in length. The checksum does not include the data portion of the packet in the calculation. The checksum is recomputed and verified at each point the IP header is processed.

Destination Address

12. This field is 32 bits in length. It is the receiver's IP address.

IP Options

13. This field is variable in length. The options provide for control functions that are useful in some situations but unnecessary for the most common communications. Specific options are security, loose source routing, strict source routing, record route, and timestamp.

Padding

14. This field is variable in length. It ensures that the IP header ends on a 32-bit boundary.

IHL (Internet Header Length)

2. This field is 4 bits in length. It indicates the length of the header in 32-bit words (4 bytes) so that the beginning of the data can be found in the IP header. The minimum value for a valid header (five 32-bit words) is 5 (0101).

ToS (Type of Service)

3. This field is 8 bits in length. Quality of service (QoS) parameters such as IP precedence or DSCP are found in this field.

Total Length

4. This field is 16 bits in length. It represents the length of the datagram or packet in bytes, including the header and data. The maximum length of an IP packet can be 216 - 1 = 65,535 bytes. Routers use this field to determine whether fragmentation is necessary by comparing the total length with the outgoing MTU.

Identification

5. This field is 16 bits in length. It identifies fragments for reassembly.

Flags

6. This field is 3 bits in length. It indicates whether the packet can be fragmented and whether more fragments follow. Bit 0 is reserved and set to 0. Bit 1 indicates May Fragment (0) or Do Not Fragment (1). Bit 2 indicates Last Fragment (0) or More Fragments to Follow (1).

Time to Live

8. This field is 8 bits in length. It indicates the maximum time the packet is to remain on the network. Each router decrements this field by 1 for loop avoidance. If this field is 0, the packet must be discarded. This scheme permits routers to discard undeliverable packets.

Protocol

9. This field is 8 bits in length. It indicates the upper-layer protocol. The Internet Assigned Numbers Authority (IANA) is responsible for assigning IP protocol values.