it 145 whattttt
Refer to the exhibit. A Layer 3 switch routes for three VLANs and connects to a router for Internet connectivity. Which two configurations would be applied to the switch? (Choose two.)
(config)# ip routing (config)# interface gigabitethernet 1/1 (config-if)# no switchport (config-if)# ip address 192.168.1.2 255.255.255.252
Refer to the exhibit. The student on the H1 computer continues to launch an extended ping with expanded packets at the student on the H2 computer. The school network administrator wants to stop this behavior, but still allow both students access to web-based computer assignments. What would be the best plan for the network administrator?
Apply an inbound extended ACL on R1 Gi0/0.
A client is using SLAAC to obtain an IPv6 address for its interface. After an address has been generated and applied to the interface, what must the client do before it can begin to use this IPv6 address?
It must send an ICMPv6 Neighbor Solicitation message to ensure that the address is not already in use on the network.
What is the order of packet types used by an OSPF router to establish convergence?
Hello, DBD, LSR, LSU, LSAck
When does a switch use frame filtering?
The destination MAC address is for a host on the same network segment as the source of the traffic.
The exhibit shows 3 PCs connected to a switch through Fa0/2, Fa0/3, and Fa0/4 interfaces. The switch is connected to a router through the Fa0/1 interface. The exhibit also shows this partial output from the show running-config command: <output omitted> interface FastEthernet0/1 switchport trunk allowed vlan 10,20,30 switchport mode access switchport nonegotiate ! interface FastEthernet0/2 switchport access vlan 10 switchport mode access switchport nonegotiate ! interface FastEthernet0/3 switchport access vlan 20 switchport mode access switchport nonegotiate ! interface FastEthernet0/4 switchport access vlan 30 switchport mode access switchport nonegotiate Refer to the exhibit. Inter-VLAN communication between VLAN 10, VLAN 20, and VLAN 30 is not successful. What is the problem?
They are not associated with a particular VLAN. In a switched network, they are mostly configured between switches at the core and distribution layers.
