Maintenance Construction Helper Test

A caliper is shown at number

not shown

Which of the following is best to use to remove large nuts or bolts

open-end wrench

A trisquare is shown at number

16

Which one of the following is commonly used to make scratch marks on sheet metal?

38 (nail set)

Which tool is most commonly used in setting the head of number 34?

39 (center pencil)

The tool that is best to use to make shoulder cuts on a tenon is number

41 (Back Saw)

To make a wood screw flush with the wood surface, it would be best to use tool number

41 (counter sink)

The tool that would be best to use to make a hole 5 1/2 inches in diameter in a wooden floor is number

50 (Key Hole Saw)

For bending reinforcing bars in a foundation, it is usually best to use

a hickey

The tool best used to hold an object to be filed is

a vise

The special type of saw used on a power saw, for cutting material such as cement brick and sheet metal, is called a/an

abrasive cutoff wheel

The wrench that is used in a manner similar yo a screwdriver is a/an

allen wrench

Once a hacksaw has started to bite into a piece of conduit the strokes in cutting should

be short, but change so as to use all of the blade

The craft worker that is most likely to used tool number 26 is the

bricklayer

Figure 59 is a

butt gauge

The tool commonly used for testing the hardness of metal before cutting it with a hacksaw blade is a

carborundum stone

The part of the drill press used to hold the drills is called the

chuck

Which of the following practices is most important in keeping tools from rusting?

coat tools with a little bit of oil

Traps are put in an air compressor line to

collect water

The air receiver on an air compressor in daily use should be blown out

daily

A tool used in plastering, consisting of a two-handled float for finishing is a

darby

Figure 58 is a

flooring chisel

A plastering tool useful as a hand table in order to carry plaster is called a

hawk

When cutting pipe with a manually-operated pipe-cutter, the direction or directions the cutter should be rotated around the pipe

is clockwise, only

The tool used to determine whether a pipe is plumb is a

level

The chief difference between trowels used for plastering and trowels used for cement finishing is that the plastering trowel is generally

lighter and longer

Combination, duckbill, and long nose are names used to identify

pliers

of the following, the best tool to use ton smooth the inside of the cut-off en of a pipe is a/an

reamer

Figure 39 is a

rip saw

Of the following, the best type of saw to use to cut a 3-foot long, 2x6 down to a 3-foot long, 2x4 is a

rip saw

Of the following, the other tool you will most likely need when using a star drill in concrete is a

rotary hammer

A rat-tail file is

round

Shovels used for mixing concrete by hand should have a

round point

Figure 34 shows a

scratch awl

Which of the following is the best hammer to use for pounding a damaged signpost anchor into the ground?

sledge

Figure 38 is a

sliding bevel

A pipe wrench is least likely to be used for loosening a pipe

tee

Which of the following tools would most likely be used to repack a brick mortar joint? A/an

tuck pointer

The size of a chisel is determined by the

width

The offset screwdriver is most suitable for

working in tight corners