SECTION 5 UNITS 1 & 2
The jaws of ____ chucks are advanced and retracted independently of each other and allow for fine-tuning the position of the workpiece for maximum accuracy.
independent
A(n) ____ tool post consists of a T-nut, clamping stud, and a multi-sided tool block with either removable or integral toolholders.
indexable
A ____ is mounted in a bearing cartridge and freely rotates with the workpiece while the mounting shank stays stationary.
live center
The ____ tool post consists of a T-nut, clamping stud, and tool post.
quick-change
____ have holes in their centers to match the size and shape of the workpiece to be held.
Collets
____ tool posts and holders have been largely replaced since they do not offer as much rigidity as newer toolholding methods.
Rocker-type
____ collets are very accurately ground cylindrical sleeves.
Spring
____ collets are used to grip on short workpieces whose diameters are too large to fit within the envelope of standard spring collets
Step
The lathe ____ is located on the right side of the headstock and is the foundation of the entire machine.
bed
The ____ supports the lathe cutting tool and provides the tool with the movement needed to perform machining operations.
carriage
The jaws are closed and opened by inserting a special wrench called a ____ into a socket on the chuck.
chuck key
The ____ slide sits atop the saddle and provides cutting-tool movement perpendicular to the ways.
cross
A(n) ____ is a specially designed plate that is mounted on the spindle nose.
drive plate
A ____ is mounted to the headstock spindle and is generally made of cast iron with a series of slots machined into its face.
faceplate
The apron also contains the ____ lever that is used to switch between longitudinal and cross feed.
feed change
The ____ is a bar that spans the length of the bed and contains gear teeth.
feed rack
Most ____ chucks move independently of each other, and each has its own adjusting screw.
four-jaw
On a ____ lathe, a small portion of the lathe bed can be removed to allow larger-diameter workpieces to be machined.
gap bed
Just under the headstock is another gear train called the quick-change ____.
gear box
The ____ is located at the upper left side of the engine lathe.
headstock
A(n) ____ chuck is a device used to clamp a workpiece in the lathe spindle by applying pressure on multiple sides.
jaw-type
The ____ is a very long threaded rod supported by bearings at both ends.
leadscrew
The sliding motion of the saddle is parallel to the ways and is called ____ feed.
longitudinal
A ____ is a special precision cylindrical shaft that can be inserted through the center bore of the workpiece to secure it for machining.
mandrel
The ____ is an H-shaped casting that slides back and forth on the ways.
saddle
The ____ is the part of the machine that holds and rotates work during machining.
spindle
The headstock ____ is used to attach various workholding devices to the spindle.
spindle nose
A ____ clamps directly to the lathe's ways and acts as a brace to surround and support the workpiece.
steady rest
A belt drive lathe transmits power from the motor to the spindle by means of belts and what is known as a ____.
step cone pulley
The ____ of the lathe is determined by the biggest diameter workpiece that can be mounted in the spindle without touching the ways.
swing
The ____ can be used to secure workholding accessories to help support the workpiece in many operations.
tailstock
The jaws of ____ chucks advance and retract simultaneously.
universal
The top of the lathe bed contains precision-ground flat and v-shaped rails known as the ____.
ways