Unit 36
Multiple indoor units and one outdoor unit
A typical multi head, ductless split system is configured with
High temperature
Air conditioning is classified as which type of refrigeration?
Comfort cooling
Air conditioning is often referred to as
There is a clearance volume that traps some refrigerant
All of the following are true, regarding the scroll compressor, except
The pressure and temperature of the refrigerant increase
As a freshman, undergoes compressor process
55°F supply air, 75F return air
At or near design conditions, the supply and return temperatures for an air conditioning system are closest to
The temperature of the suction gas
Discharge gas temperature is affected most by
1%
East degree of condenser sub cooling will increase system efficiency by approximately how much
hot, dry climates
Evaporative cooling systems are best suited for which type of climate?
Conduction, infiltration, and radiation
Heat leaks into a structure by which three methods
There will be no net duck losses, while the system is operating in either the cooling or heating mode
If a duck system is on insulated and runs through the condition Space.
One quart
On average, each ton of system capacity has the ability to remove, approximately how much moisture from the air
Either on the roof of a structure or at ground level
Package type air-conditioning units are in intended to be located
Oil
Radial sealing on a scroll compressor is typical accomplished with
Fully hermetic, suction, gas, cooled pumps
Reciprocating compressor is used in residential applications are most likely to be
Reciprocating compressor
The compressor type that relies on pistons moving up and down within cylinders is
Superheated vapor
The refrigerant, that both enters and leaves a properly operating compressor can be described as
Prevent the vapor, refrigerant in the line from absorbing additional unwanted heat
The suction line is insulated to
By both the temperature in amount of air passing through the coil
The temperature of the evaporator coil is affected
Sensible, heat, and latent and heat
The two types of heat transfer that or facilitated by the evaporator are
Evaporator superheat
Thermostatic expansion valves are designed to maintain constant
Slant, A, and H
Three common evaporator coil configurations found on air conditioning systems are
Bleed port
What feature on a thermostatic expansion valve allows the system to pressures to equalize during the off cycle
Package type equipment has no field install refrigerant lines
What refrigerant lines are field installed on the typical package type air conditioning unit
Liquid line and suction line
What refrigerant lines are field installed on the typical split system air conditioning
Moisture content
When sizing, and select the air-conditioning equipment, which of the following must be taken into account
Cool and humid
Which of the following best describes the air that enters the structure from being treated by an evaporator cooler
100°F dry-bulb, 71F wet bulb
Referring to figure 36.18, the 1% design wet bulb and dry bulb temperature for Napa California in the summer are.
Once Craw is stationary and one scroll orbits
Which of the following best describes the squirrels in a scroll compressor
120F
Which of the following is a possible condenser saturation temperature for an R-410a air conditioning system that is operating with an outside ambient temperature of 90°F
There is no clearance volume on these compressors
Which of the following is true regarding the rotary compressor?
The maximum desire discharge line temperature for R-410 a compressor is
175°F