1c hoisting

Ace your homework & exams now with Quizwiz!

When a forklift picks up a load on the forks

The center of gravity of the forklift moves forward

Using a short turning radius when traveling at high speeds can cause overturning due to

The forces of momentum

When the load is fully extended overhead?

The forklift itself should not be moved more than necessary, extreme caution should be used, the hydraulic body leveling system should not be adjusted

When the forklift center of gravity goes beyond the stability area?

The forklift will tip over

The Lord will have maximums stability if

The forks tips are inserted until It is against the back rest

The forklift ability to lift a load within its limits safley is reduced if?

The front and is sloping down, the load is too far in front of the front axle, the lift mechanism is not vertical

We're moving a load with a convertible forklift crane

The load in the arm or mast should be as low as possible

What is the most important single factor to the safe operation of forklifts

The operator

Workers in by standards within the danger area of the forklift should be considered the responsibility of

The operator

Which of the following statements is not true? Before you insert the forks under the load to be picked up, they should be?

Tilted back

As the load of a forklift is raised which of the following dangers increase

Tipping loss of steering and the fact of momentum

Which of a forklift four wheel steering capabilities should be used at high speed or on highways

Two wheel steering, front wheels fix straightahead, rear wheels used for steering

Many accidents happen because the operator does which of the following

Uses a forklift with a known defect, travels and unsafe route, carries unsafe loads, uses unsafe operating techniques

Which of the following has or have an effect on the amount of stability a forklift has

Weight distribution, axle length, wheel base

One of the most potentially dangerous times you will encounter is

When the load is fully extended overhead

Carrying the load on the tips of the forks can?

a) Act as an unwanted counterweight in front b) Create an unstable load condition c) Result in the load's falling off the forks

Rear-wheel steering used by many forklifts?

a) Cause both ends of the forklift to swing around when turned b) Can cause the load to fall off the forks if the turn is made too fast c) Causes them to act differently from cars, which have front wheel steering

Picking up a load in excess of the safe limits can

a) Cause forward tipping b) Cause loss of steering c) Cause the forklift's center of gravity to move too far forward

It may be necessary for the operator to be given hand signals by a fellow worker if

a) Depth perception is not good b) The landing point is at extreme heights c) The operator cannot see the location where the load is to be landed

When operating a forklift on a job site where there are other vehicles

a) Keep to the right when traveling in areas with two way traffic b) Stay 20 feet behind a vehicle in front of you

Which of the following fluid levels need to be checked regularly?

a) Oil b) Fuel c) Hydraulic d) Brake

When you are operating a forklift and approach a vehicle or person alongside your path

a) Slow down b) Sound your horn c) Proceed with caution after they have acknowledge your warning

Do not start a forklift unless.

a) The controls are in neutral b) The hand brake is set c) You are sitting in the operator's seat

When traveling on the floor system which is hollow underneath it is important to know

a) The weight of the load and the forklift b) The load capacity of the floor

An operator may pick up and place a load with a forklift if the load is

a) Within the limits the landing point will support b) Within the forklift's rated capacity c) Made up of several small pieces tied or banded together securely

The rated capacity of a forklift can be found

b) On the load chart c) In the manufacturer's manual

Outriggers, or stabilizer's, should

b) Should be set before the load is lifted c) Should be used only to give extra stability

If the load being carried obstructs vision, the operator should?

drive in reverse

Inspection of the forklift is the responsibility of?

operator

When approaching the location where a load will be placed you should

proceed slowly

Jerky movements can be avoided if the operator.

FEATHERS THE CONTROLS

When you are operating a forklift, Which of the following signs indicating immediate danger

Faulty brakes, faulty steering, faulty hydraulic mechanism

Job site conditions are?

IMPORTANT SINCE THEY DETERMINE THE SAFE SPEED AT WHICH A FORKLIFT CAN OPERATE

Material should be stockpiled

In a well drained area

The stability of and unloaded forklift:

Is just as important as that of one caring a load

Which of the following statements about carrying a forklift load low is not true

It increases effects of the jolts from rough terrain

When traveling up or down a ramp, you can place more traction on the front Drive wheels of an unloaded forklift if the forks are

KEPT POINTING DOWNHILL

Forward tipping will occur unless the forklift center of gravity is

On the opposite side of the front axle

Fork trucks in a warehouse environment should?

STAY TO THE RIGHT AND 20 FEET BACK FROM ANOTHER FORK TRUCK TRAVELING IN YOUR DIRECTION.

If A forklift tips forward

STEERING CONTROL IS LOST

While a load is being lifted, it should be:

TILTED SLIGHTLY BACKWARDS

The pivot point of a forklift is

The front axle

One of the main safety reasons for checking for proper tire inflation is?

To assure that the forklift will have stability it is designed for, to make sure it has proper traction, to make steering easier

Before raising a load

a) The brakes should be set b) The lifting mechanism should be vertical c) The forklift should be as level as possible

What things determine how fast a hydraulic system moves

a) The distance the controls are moved d) The engine speed

If the gauges do not register normal while the forklift is being operated:

a) Turn off the engine b) Notify your supervisor

When using jumper cables to start a forklift with a low battery

ALWAYS MAKE THE FINAL CONNECTION TO THE FRAME OF THE FORKLIFT WITH THE LOW BATTERY

Specific recommendations on intervals between forklift inspections and maintenance

ARE LISTED IN THE MANUFACTURERS MANUAL

Which of the following statements is true about the jumper cable safety?

Always connect positive to positive and negative to negative, make sure both batteries are the same voltage, make the final connection to the frame of the forklift with the low battery

When traveling on a slope it is necessary to

Approach it straight, do not turn on the hill, do not travel crossways

Consider the load limit of the scaffold landing point:

BEFORE PICKING UP THE LOAD THAT IS TO BE LOADED

Greater dynamic forces are present when you are lifting and moving a load with a?

CONVERTIBLE FORKLIFT CRANE

When crossing railroad tracks or other similar roof sections with a loaded forklift you should

Cross them diagonally

Because the forklifts are designed with the forks in front it is not possible for it to tip backwards

False

The Teeter totter is a simple example of

Leverage

Which of the following affect forklift safety

Leverage, center of gravity, momentum

If the hydraulic system develops elite during operation you should

Lower the Lord, shut off the engine, notify the supervisor

If a stack to load begins to lean or shift while being raised

Lower the load and re-stack it

Driving in reverse requires the operator to use a slower speed because?

MORE REACTION TIME IS NEEDED TO REACH THE CONTROLS WHEN THE DRIVER IS FACING THE OPPOSITE DIRECTION

The type of forklift which is designed primarily to lift a load straight up with a limited amount of tilt movement forward is the

Mast forklift

What foreskin cause a loaded forklift to tip forward when brakes are applied

Momentum

The operator feathers the control when he wants to

Move the load slowly

When May for reverse gear be used to slow or stop a forklift traveling forward

Never

When is it permissible to Carrie riders while you are offering a forklift

Never

When is it safe to operate a forklift from a place other than the operators seat

Never

When it is safe to exceed the load limit of a forklift

Never

An overcapacity load can be lifted if the forklift is?

None of the options

The hydraulic system should be checked by:

OPERATING EACH HYDRAULIC ACTION THROUGH ITS FULL CYCLE

Ramming the hydraulic lift Saunders to the end of their strokes can

Result in jolts which are transferred to the load

When approaching another vehicle stopped in the path of the forklift you are operating you should

STOP AND SOUND YOUR HORN

When you are operating a forklift and approaching a blind corner?

STOP, SOUND YOUR HORN AND PROCEED SLOWLY

When traveling down a Hill or a slope you should

Save the breaks by using the same gear to go down the hill as would be used to go up it

If it is necessary for you to re-stack a load, you should

Set a break before getting off the forklift and turn off the engine

Forklift that are equipped with hydraulic frame leveling or lift mechanism Tilting systems

Should be adjusted before the load is lifted

Safe load limits for a particular forklift?

Should never be excited

Which of the following are essential for safe operation

Smooth starts, smooth stops, smooth turns

If bystanders or fellow workers are in danger from a raise load you should

Sound your horn or ask them to move

Momentum is a force created by?

Starting, stopping, turning

Before the engine is started:

THE CONTROLS SHOULD BE IN NEUTRAL

Before you withdraw the forks from a load that has just been placed you should?

THEY SHOULD BE NEARLY PARALLEL WITH THE GROUND

If you find a fault or suspect an unsafe condition while inspecting or offering a forklift you should?

Tell your supervisor


Related study sets

3280 Patho Exam 2 Unit 3 quizzes

View Set

Ch 33 Assessment and Management of Patients with Allergic Disorders

View Set

1 and 2 Peter: The Apostle and Writer

View Set

Chapter 4 multiple choice questions

View Set

Lesson 6 - The atlantic Slave Trade

View Set

Primerica Life Insurance State Exam RI

View Set

POLS 207 - Chapter 7 - Legislatures

View Set