CDC Z2A753 Volume 1
When using a microstop countersink, each increment of the micrometer adjustment increases or decreases the depth-of-cut by
0.001 inch.
When using a microshaver, you set it how many thousandths of an inch above the skin?
0.002.
What is used to determine the depth of a corrosion pit?
Depth gauge.
What type of chisel is best for cutting V-shaped grooves?
Diamond point.
What type of punch do you use to align fastener holes in two pieces of metal?
Drift.
What is the best file to use on a concave surface?
Half-round.
What type of file is used primarily for sharpening circular saws and edge tools?
Mill.
What type of hammer do you use to do light chiseling?
Riveting.
What layout tool do you use to mark cut lines on metal surfaces?
Scriber.
What type of hammer do you use for double seaming lids?
Setting.
What type of grinding wheel do you use when you're grinding aluminum using a bench grinder?
Silicon carbide.
What type of file do you use to sharpen the blades of cutting tools?
Single-cut.
What type of metal-cutting snips is known as tinner's snips?
Straight.
What makes coin-dimpling superior to the radius-dimpling?
The sliding coining ram of the female die.
Which lever shear can cut sheet metal of unlimited length or width?
Throatless.
What do you adjust to make the contour metal cutting saw blade track properly?
Tilting wheel.
The machine capacity of a rotary punch is found on the
front of each die holder.
The unit of measurement used with a scale is the
gram.
To use the job selector dial on a contour metal cutting saw you must know the
material's composition and thickness.
You can ensure a reciprocating saw is cutting properly by selecting a blade
pitch where at least two teeth will cut at all times.
The flutes on twist drills are necessary because they
provide a means of chip removal.
Rivet holes that will be dimpled using hand-dimpling dies are drilled
to the correct size after dimpling.
The largest twist drill the chuck on a hand drill can normally accommodate is
¼ inch.
What is the maximum bed gap allowed when using a powered disc sander?
⅛ inch.
What is the maximum safe gap between the wheel and the work rest of the pedestal grinder?
⅛ inch.
What type of chisel is best suited for cutting slots and keyways?
Cape.
The included angle of a twist drill used for most metals is
118°.
When you're cutting solid stock aluminum how many teeth per inch are recommended for the hacksaw blade?
18.
How many teeth per inch are recommended on a hacksaw blade used for cutting thick wall tubing?
24.
The included angle of a center punch point should be
90˚.
