CIT 106 Final Comprehensive

Ace your homework & exams now with Quizwiz!

Which type of traffic is designed for a native VLAN?

untagged

What address and prefix length is used when configuring an IPv6 default static route?

::/0

Which problem is evident if the show ip interface command shows that the interface is down and the line protocol is down?

A cable has not been attached to the port.

Refer to the exhibit. Router R1 has an OSPF neighbor relationship with the ISP router over the 192.168.0.32 network. The 192.168.0.36 network link should serve as a backup when the OSPF link goes down. The floating static route command ip route 0.0.0.0 0.0.0.0 S0/0/1 100 was issued on R1 and now traffic is using the backup link even when the OSPF link is up and functioning. Which change should be made to the static route command so that traffic will only use the OSPF link when it is up?​

Change the administrative distance to 120.

A junior technician was adding a route to a LAN router. A traceroute to a device on the new network revealed a wrong path and unreachable status. What should be done or checked?

Check the configuration of the exit interface on the new static route.

Match the spanning-tree feature with the protocol type.

Cisco implementation of IEEE 802.1D ==> PVST+ Fast converging enhancement of IEEE 802.1D ==> RSTP IEEE standard that reduces the number of STP instances ==+> MSTP Proprietary per VLAN implementation of IEEE 802.1w ==> Rapid PVST+

A network administrator is implementing DHCPv6 for the company. The administrator configures a router to send RA messages with M flag as 1 by using the interface command ipv6 nd managed-config-flag . What effect will this configuration have on the operation of the clients?

Clients must use all configuration information that is provided by a DHCPv6 server.

After sticky learning of MAC addresses is enabled, what action is needed to prevent dynamically learned MAC addresses from being lost in the event that an associated interface goes down?

Copy the running configuration to the startup configuration.

Refer to the exhibit. A network administrator is configuring DAI on switch SW1. What is the result of entering the exhibited commands?

DAI will validate only the destination MAC addresses.

Match the dynamic routing protocol component to the characteristic.

Data structures = tables or databases that are stored in RAM Routing protocol messages = exchanges routing information and maintains accurate information Algorithm = a finite of steps used to determine the best path

What is the best way to prevent a VLAN hopping attack?

Disable trunk negotiation for trunk ports and statically set nontrunk ports as access ports.

Which Cisco solution helps prevent ARP spoofing and ARP poisoning attacks?

Dynamic ARP Inspection

A network engineer is configuring a LAN with a redundant first hop to make better use of the available network resources. Which protocol should the engineer implement?

GLBP

Match the FHRP protocols to the appropriate description.

HSRP - a Cisco proprietary FHRP that provides redundancy through use of an active device and standby device GLBP - a Cisco proprietary FHRP that provides load sharing in addition to redundancy VRRP - an open standard FHRP that provides redundancy through use of a virtual routers master and one or more backups

A technician is configuring a new Cisco 2960 switch. What is the effect of issuing the BranchSw(config)#interface VLAN88 command?

It enters configuration mode for a switch virtual interface.

Which statement describes the behavior of a switch when the MAC address table is full?

It treats frames as unknown unicast and floods all incoming frames to all ports within the local VLAN.

What is an advantage of PVST+?

PVST+ optimizes performance on the network through load sharing.

A network administrator of a college is configuring WLAN security with WPA2 Enterprise authentication. Which server is required when deploying this type of authentication?

RADIUS

Refer to the exhibit. When a packet arrives on interface Serial0/0/0 on R1, with a destination IP address of PC1, which two events occur? (Choose two)

Router R1 will forward the packet out Gig0/1. Router R1 will de-encapsulate the packet and encapsulate it in an Ethernet frame.

Refer to the exhibit. How is a frame sent from PCA forwarded to PCC if the MAC address table on switch SW1 is empty?

SW1 floods the frame on all ports on SW1, excluding the port through which the frame entered the switch.

A small publishing company has a network design such that when a broadcast is sent on the LAN, 200 devices receive the transmitted broadcast. How can the network administrator reduce the number of devices that receive broadcast traffic?

Segment the LAN into smaller LANs and route between them.

Refer to the exhibit. Which interface will be the exit interface to forward a data packet that has the destination IP address 172.18.109.152?

Serial0/0/0

A small coffee shop is offering free Wi-Fi to customers. The network includes a wireless router and a DSL modem that is connected to the local phone company. What method is typically used to configure the connection to the phone company?

Set the WAN connection in the wireless router as a DHCP client.

A network administrator is using the router-on-a-stick method to configure inter-VLAN routing. Switch port Gi1/1 is used to connect to the router. Which command should be entered to prepare this port for the task?

Switch(config)# interface gigabitethernet 1/1 Switch(config-if)# switchport mode trunk

Match the purpose with its DHCP message type. (Not all options are used.)

The DHCPDISCOVER message is used to identify any DHCP servers on a network. The DHCPOFFER message is used by a server to offer a lease to a client. The DHCPREQUEST message is used to identify both the specific DHCP server and the lease that the client is accepting. The DHCPACK message is used by a server to finalize a successful lease with a client.

Refer to the exhibit. Based on the command output shown, what is the status of the EtherChannel?

The EtherChannel is in use and functional as indicated by the SU and P flags in the command output.

Refer to the exhibit. The users on the LAN network of R1 cannot receive an IPv6 address from the configured stateful DHCPv6 server. What is missing from the stateful DHCPv6 configuration on router R1?

The FA0/0 interface is missing the command that informs the clients to use stateful DHCPv6.

Refer to the exhibit. PC-A and PC-B are both in VLAN 60. PC-A is unable to communicate with PC-B. What is the problem?

The VLAN that is used by PC-A is not in the list of allowed VLANs on the trunk.

Refer to the exhibit. Inter-VLAN communication between VLAN 10, VLAN 20, and VLAN 30 is not successful. What is the problem?

The access interfaces do not have IP addresses and each should be configured with an IP address.

Refer to the exhibit. The administrator wants to enable port security on an interface on switch S1, but the command was rejected. Which conclusion can be drawn?​

The interface must be initially configured with the switchport mode access command.

An administrator has configured a DHCPv4 relay router and issued these commands: Router(config)# interface g0/0 Router(config-if)# ip address 10.0.1.1 255.255.255.0 Router(config-if)# no shutdown Router(config-if)# exit Router(config)# ip dhcp pool RELAY Router(dhcp-config)# end The clients are not receiving IP parameters from the DHCPv4 server. What is a possible cause?

The ip helper-address command is missing.

A network administrator is configuring a WLC to provide WLAN access to users in an office building. When testing the newly created WLAN, the administrator does not see the SSID from a wireless device. What is a possible cause?

The new WLAN needs to be enabled.

Refer to the exhibit. How was the host route 2001:DB8:CAFE:4::1/128 installed in the routing table?

The route was automatically installed when an IP address was configured on an active interface.

What is a result of connecting two or more switches together?

The size of the broadcast domain is increased.

What are two characteristics of Cisco Express Forwarding (CEF)? (Choose two.)

This is the fastest forwarding mechanism on Cisco routers and multilayer switches. Packets are forwarded based on information in the FIB and an adjacency table.

What is a potential issue when using the WLC to upgrade and deploy the latest firmware image to all APs?

Users will not be able to use the WLAN.

Refer to the exhibit. The configuration shows commands entered by a network administrator for inter-VLAN routing. However, host H1 cannot communicate with H2. Which part of the inter-VLAN configuration causes the problem?

VLAN configuration

Which combination of WLAN authentication and encryption is recommended as a best practice for home users?

WPA2 and AES

What is the reason for disabling SSID broadcasting and changing the default SSID on a wireless access point?

Wireless clients must then have the SSID manually configured to connect to the wireless network.

Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 What does the 5 at the end of the command signify?

administrative distance

On which port should Dynamic ARP Inspection (DAI) be configured on a switch?

an uplink port to another switch.

Which term describes the role of a Cisco switch in the 802.1X port-based access control?

authenticator

Which three components are combined to form a bridge ID?

bridge priority, extended system ID, and MAC address.

Match the DTP mode with its function. (Not all options are used.)

dynamic desirable = actively attempts to convert the link to a trunk dynamic auto = passively waits for the neighbor to initiate trunking nonegotiate = requires manual configuration of trunking or nontrunking trunk = permanent trunking mode

What are two switch characteristics that could help alleviate network congestion? (Choose two.)

fast internal switching large frame buffers

Which command will start the process to bundle two physical interfaces to create an EtherChannel group via LACP?

interface range GigabitEthernet 0/4 - 5

Which command would create a valid IPv6 default route?

ipv6 route ::/0 2001:db8:acad:2::a

What type of VLAN is configured specifically for network traffic such as SSH, Telnet, HTTPS, HTTP, and SNMP?

management VLAN

What are the two methods that a wireless NIC can use to discover an AP? (Choose two.)

receiving a broadcast beacon frame transmitting a probe request

An employee connects wirelessly to the company network using a cell phone. The employee then configures the cell phone to act as a wireless access point that will allow new employees to connect to the company network. Which type of security threat best describes this situation?

rogue access point

Refer to the exhibit. Match the description with the routing table entries.

route source protocol = D (which is EIGRP) destination network = 10.3.0.0 metric = 21024000 administrative distance = 1 next hop = 172.16.2.2 route timestamp = 00:22:15

Refer to the exhibit. The routing table for R2 is as follows:Gateway of last resort is not set10.0.0.0/30 is subnetted, 2 subnetsC 10.0.0.0 is directly connected, Serial0/0/0C 10.0.0.4 is directly connected, Serial0/0/1192.168.10.0/26 is subnetted, 3 subnetsS 192.168.10.0 is directly connected, Serial0/0/0C 192.168.10.64 is directly connected, FastEthernet0/0S 192.168.10.128 [1/0] via 10.0.0.6 What will router R2 do with a packet destined for 192.168.10.129?

send the packet out interface Serial0/0/1

Refer to the exhibit. A network administrator is troubleshooting a problem with EtherChannel. What command was used to produce the exhibited output?

show interfaces fastethernet 0/11 etherchannel

Refer to the exhibit. DLS1 is connected to another switch, DLS2, via a trunk link. A host that is connected to DLS1 is not able to communicate to a host that is connected to DLS2, even though they are both in VLAN 99. Which command should be added to Fa0/1 on DLS1 to correct the problem?

switchport trunk native vlan 66

In what situation would a Layer 2 switch have an IP address configured?

when the Layer 2 switch needs to be remotely managed


Related study sets

Microbiology Chapter 3 HW, Microbiology Chapter 4 Part 2 HW, Microbiology Chapter 4 Part 1 HW

View Set

Exam 3 Study Guide (Ch. 9, 13, 14, 16)

View Set

Anatomy- Chapter 7 Quizlet (actual test questions)

View Set

U.S. History chapter 4-9. Unit quiz 2

View Set

Diffusion, Osmosis and Active Transport

View Set

Health Chapter 1 : Field Underwriting Procedures

View Set