Integrated Science Ch 33

Ace your homework & exams now with Quizwiz!

what is the difference between plains and plateaus?

PLAINS are broad, flat areas that don't rise far above sea level. PLATEAUS on the other hand, are flat areas uplifted more than 600 m above sea level

name and describe the three main types of volcanoes

Shield volcanoes = broad, gentle slopes; erupt thin, runny lava that spreads out over the land, has Basaltic lava has a low viscosity (flows easily) cinder cones = small volcanoes with steep sides, built from various ejected materials, including ash, cinders, glass and lava fragments, and rocks; materials erupt explosively and pile up at a steep angle composite cones = they have steep summits but gently sloping lower flanks; they are built of layers of lava, ash, and mud; Mt. St. Helens

why is folded rock usually produced deep underground?

because deeper underground it is hotter and because it is hotter magma is able to run further which produces folded rock

plains

broad, flat areas of land that don't rise above sea level

how are folded mountains formed?

by the compression and complex folding of layers of rock EXAMPLE: Himalayas

how are landforms such as valleys and canyons produced?

by weathering and erosion, the action of water, wind or ice wearing down and transporting rock

reservoir

a location where water or other material that transfers from place to place in a cyclical manner is stored

runoff

precipitation that is not absorbed by the ground or evaporated and that runs over the earth's surface

what are the three ways the ocean changes as you go deeper?

1. the deeper you go the less light there is -sunlight can penetrate only up to about 200m, so the deep ocean is black 2. temperature decreases with depth -the bottom of the ocean is dense and near freezing; dense, cold water of the ocean bottom mixes very little with water near the surface 3. pressure increases with depth -pressure in the abyssal plains is several hundred times atmospheric pressure

how much of the earth is covered by ocean?

3/4

what is a water table and where is it located?

?... the upper boundary of the saturated zone

fold

a bend in layers of rock

what is a fault?

a break in the rock if the rock on both sides have moved relative to one another

fault

a crack in Earth's crust along which different sections of rocks have shifted

upwarped mountain

a dome-shaped mountain produced by a broad arching of Earth's crust

glacier

a large mass of dense ice formed from snow

fault-block mountain

a mountain produced by normal faulting and the uplifting of blocks of rock

folded mountain

a mountain produced by the folding of rock

volcano

a mountain that is the accumulation of lava or other erupted materials

compression (stress)

a squeezing force on rock

tension (stress)

a stretching force on the rock

what is an aquifer and how does it get replenished?

a zone of rock that groundwater can flow through, high porosity and high permeability, contain enormous amount of groundwater Groundwater continues to collect as precipitation percolates down from the surface, process of recharging is very slow, groundwater is a non renewable resource

Aquifer

a zone of water-bearing rock through which groundwater can flow

saturated zone

an underground region where all the open spaces are filled with water

how does the water cycle work?

as water flows it also changes phase, evaporating and condensing in different parts of the cycle. the sun gives water the energy it needs to evaporate. Gravity supplies the force that pulls water back to Earth's surface as precipitation (rain, snow, sleet, or hail). Gravity's constant pull moves water across Earth's surface downhill toward the ocean. when precipitation falls on the ocean, the water is completed quickly because it evaporates directly back to the atmosphere. precipitation falling on land can take a longer time to complete the cycle because it may become part of a snowpack or glacier and be locked up as ice for many years. or it may soak deep underground through infiltration and be stored as groundwater. eventually, even water stored as ice or groundwater evaporates into the atmosphere or flows through rocks and cracks, ultimately reaching the ocean. the cycle begins again as the ocean's water precipitates

water pollution

chemical, physical, or biological material introduced into water that harms organisms that depend on the water

define and describe precipitation?

rain, snow, sleet, or hail; gravity supplies the force that pulls water back to Earth's surface such as precipitation

what is a reservoir?

each of the places water is stored as it moves through the water cycle (glaciers, oceans, underground storage areas)

plateau

flat areas of land more than 600 m above sea level

What is an abyssal plain?

flattest places on earth because thick accumulations of sediment bury the uneven and rocky oceanic crust; there is less than a 1 ft vertical change for every 1000 square feet of area in the abyssal plains - they are literally flatter than a pancake

what is water in this saturated zone called?

groundwater

how much of the Earth is fresh water and where is most of it found?

less than 3% of the Earth is freshwater and most of it is found as solid ice and snow in the mountains and in polar regions

what is salinity?

measure of the amount of dissolved salts in a given amount of water

Why do mountains exist?

mountains exist because of the movement of tetonic plates

how are fault-block mountains formed?

mountains that form from tension and have at least one side bounded by a normal fault; tetonic forces also pull apart

what is the difference between normal faulting, reverse faulting, and strike-slip faults?

normal faults - indicate that rock has undergone tension, the plates are pulling away from each other reverse faults - typically occur where there has been compression, the rocks are being squeezed together strike slip faults - opposing forces cause plates to move horizontally, large strike slip faults at transform plate boundaries are called transform faults

what is tension?

occurs where masses of rock are pulling away from one another EXAMPLE: at divergent plate boundaries

what is the difference between point pollution and non-point pollution?

point = pollution due to a specific source (wastewater treatment plants) non-point =doesn't come from a single source (salt applied to roadways)

how is a glacier formed?

snow rarely melts in extremely cold places, it piles up year after year, the weight of overlying snow crushes buried snow into ice crystals, a giant mass the size of football fields or even a continent is produced

what is residence time and which reservoir holds water the longest?

the average amount of time that a water molecule spends in each reservoir; oceans hold water the longest (3200 years)

residence time

the average length of time that any given atom will stay in a particular reservoir, such as the ocean or atmosphere

what is the biggest divide in North America and what does it separate?

the continental divide separates the Pacific basin from the Atlantic basin

water cycle

the continuous movement of water in all of its phases among Earth's reservoirs

permeability

the ease with which fluid can flow through rock

how do creationists believe the mid-ocean ridge came to be?

the flood; water came shooting out of the ground and caused ridges

what produces the stresses that fault and fold rock?

the forces that produce folding usually come from the collision of tetonic plates; also, magma sometimes pushes against rock and compresses it

what causes water pollution?

the growth of large-scale factories and the human population explosion

watershed

the land area that drains into a particular stream

why does the ocean not get saltier over time?

the ocean's salinity is constant because salts are removed as quickly as they are added EXAMPLE: heavy rains (freshwater) dilute the ocean salt precipitates out of water when the water becomes saturated biology helps maintain the constant salinity of seawater; marine organisms remove salts from the ocean as well as dissolved gases, and other solutes

porosity

the proportion of rock that consists of pore spaces

what is topography?

the shape of the Earth's surface

continental margin

the transition zone between dry land and the ocean bottom

water table

the upper boundary of the saturation zone

ocean basin

the vast depression on Earth's surface underlain by oceanic crust and filled with ocean water

groundwater

the water that resides in a saturated zone

how are upwarped mountains formed?

they form from magma that wells up under Earth's surface and pushes it outward, over millions of years, the magma under the dome cools to become a solid core, eventually, erosion wears away soft surface rock, and durable igneous or metamorphic rock is exposed as an upwarped mountain

why do Geologists map faults?

to locate these resources (faults affect the distribution of groundwater, minerals, and fossil fuels)

what is compression?

when two tetonic plates collide, massive blocks of rocks are squeezed together


Related study sets

Overview of English Grammar & Usage

View Set

CPSC-431 Final Exam Study Guide Part 1/2

View Set