Network+ Chapter 8 Quiz

Given a host IP address of 172.16.1.154 and a subnet mask of 255.255.254.0, what is the network ID for this host? a. 172.16.0.0 b. 172.16.1.0 c. 172.16.2.0 d. 172.0.0.0

a. 172.16.0.0

How large is the 802.1Q tag that is added to an Ethernet frame when using VLANs? a. 4 bytes b. 8 bytes c. 12 bytes d. 20 bytes

a. 4 bytes

A /24 CIDR block is equivalent to a 255.255.255.0 subnet mask. a. True b. False

a. True

By default, the native VLAN is the same as the default VLAN. a. True b. False

a. True

IPv6 addressing does not utilize classful addressing, therefore every IPv6 address is classless. a. True b. False

a. True

Network segmentation at Layer 2 of the OSI model is accomplished using VLANs. a. True b. False

a. True

Which of the following statements regarding IPv6 subnetting is NOT accurate? a. IPv6 addressing uses no classes, and is therefore classless b. IPv6 does not use subnet masks. c. A single IPv6 subnet is capable of supplying 18,446,744,073,709,551,616 IPv6 addresses. d. The largest IPv6 subnet capable of being created is a /64.

d. The largest IPv6 subnet capable of being created is a /64.

In order to identify the transmissions that belong to each VLAN, a switch will add a tag to Ethernet frames that identifies the port through which they arrive at the switch. a. True b. False

a. True

In an IPv6 address, what do the first four blocks or 64 bits of the address represent? a. The usable host portion of the network b. The site prefix or global routing prefix c. The broadcast domain for the configured host ID d. The MAC address of the router assigning the host ID

b. The site prefix or global routing prefix

When dealing with a Cisco switch, what is NOT one of the pre-established VLANs? a. VLAN 1 b. VLAN 1001 c. VLAN 1003 d. VLAN 1005

b. VLAN 1001

An interface that manages traffic from multiple VLANs is known by what term? a. access port b. aggregation port c. trunk port d. egress port

b. aggregation port

When using IPv6, what would a /64 network likely be assigned to? a. A regional Internet registry b. A large ISP c. A very large organization d. A smaller organization or business

d. A smaller organization or business

What is NOT one of the ways in which networks are commonly segmented? a. by geographic location b. by departmental boundaries c. by device types d. by device manufacturer

d. by device manufacturer

What command will set the native VLAN on a Juniper switch port? a. switchport trunk native vlan b. switchport set native vlan c. config native vlan d. set native-vlan-id

d. set native-vlan-id

Which of the following terms is commonly used to describe a VLAN configuration in which one router connects to a switch that supports multiple VLANs? a. router-on-a-stick b. branched router c. router overloading d. router-on-a-branch

a. router-on-a-stick

A network with 10 bits remaining for the host portion will have how many usable host addresses? a. 510 b. 1022 c. 2046 d. 4192

b. 1022

An IP address of 192.168.18.73/28 has what network ID? a. 192.168.16.0 b. 192.168.18.64 c. 192.168.18.32 d. 192.168.18.0

b. 192.168.18.64

What subnet mask can be used to segment the 172.16.0.0 network to allow for a minimum of 6 subnets while maximizing the number of hosts per subnet? a. 255.255.248.0 b. 255.255.224.0 c. 255.255.192.0 d. 255.255.128.0

b. 255.255.224.0

A network with a CIDR notation of /26 would have what subnet mask? a. 255.255.255.0 b. 255.255.255.192 c. 255.255.255.224 d. 255.255.255.240

b. 255.255.255.192

What IEEE standard specifies how VLAN information appears in frames and how switches interpret that information? a. 802.1c b. 802.1Q c. 802.1V d. 802.1d

b. 802.1Q

Which of the following suggestions can help prevent VLAN hopping attacks on a network? a. Install an additional switch to isolate traffic. b. Disable auto trunking and move native VLANs to unused VLANs. c. Install a router to process the untagged traffic on the VLAN. d. Use MAC address filtering.

b. Disable auto trunking and move native VLANs to unused VLANs.

A native VLAN mismatch occurs when two access ports that are connected to each other are both tagging traffic with different VLAN IDs. a. True b. False

b. False

All that is needed to provide communication between two VLANs is a DHCP relay agent. a. True b. False

b. False

An unmanaged switch can still support the creation of VLANs, provided there is an interface for configuration. a. True b. False

b. False

Network segmentation decreases both performance and security on a network. a. True b. False

b. False

Only Class B and Class C networks can be subnetted. a. True b. False

b. False

What does the VLAN Trunk Protocol (VTP) do? a. It shares trunking information amongst switches that participate. b. It shares VLAN database information amongst switches that participate. c. It is the protocol used by a trunk port for establishing a trunk with another switch. d. It is the protocol that defines how VLAN tagging is accomplished in an Ethernet network.

b. It shares VLAN database information amongst switches that participate.

With VTP, where is the VLAN database stored? a. On the router responsible for maintaining the VTP database. b. On the switch that is known as the stack master. c. On the switch that is configured as the trunk root. d. On the designated VLAN server for the network.

b. On the switch that is known as the stack master.

If the EUI-64 standard is used, what part of an IPv6 address is affected? a. The first 4 blocks of the address b. The last 4 blocks of the address c. The middle 4 blocks of the address d. All blocks of the address are affected.

b. The last 4 blocks of the address

You are working on a Cisco switch and need to learn what VLANs exist on the switch. Which command will list the current VLANs recognized by the switch? a. get vlans b. show vlan c. list switch-vlans d. show vlandb

b. show vlan

A subnet of 255.255.248.0 can be represented by what CIDR notation? a. /18 b. /20 c. /21 d. /29

c. /21

On a Cisco switch, what would the security association identifier be for VLAN 13? a. 1013 b. 5013 c. 100013 d. 1000130

c. 100013

By default, when using classful addressing, how many bits exist in the host portion of a Class A address? a. 8 b. 16 c. 24 d. 32

c. 24

How many subnets can a /48 site prefix support? a. 256 subnets b. 16384 subnets c. 65536 subnets d. 131072 subnets

c. 65536 subnets

When an 802.1Q tag is added to an Ethernet frame, where is it placed? a. It is inserted between the preamble and the destination address. b. It is inserted between the destination and the source addresses. c. It is inserted between the source address and the Ethernet type field. d. It is appended to the end of the frame.

c. It is inserted between the source address and the Ethernet type field.

Subtracting an interesting octet value from 256 yields what number? a. network ID b. subnet ID c. magic number d. host ID

c. magic number

What is the maximum number of host IP addresses that can exist in a Class B network? a. 1022 b. 8190 c. 32766 d. 65534

d. 65534