Ch 13 Procedure 13-3: Single Braids with Extensions

What is the twenty first step in performing single braids with extensions?

adorn with accessories and ornaments if desired

What is the eighteenth step in performing single braids with extensions?

after the entire head has been braided, remove all loose hair ends from the braid shaft with shears

What is the fourth step in performing single braids with extensions?

apply light botanical oil to the scalp and massage it in and throughout the hair

What is the sixteenth step in performing single braids with extensions?

as you get closer to the hairline, be aware of the amount of extension hair applied there

What is the eleventh step in performing single braids with extensions?

as you move down the braid, keep your fingers close to the stitch so the braid remains tight and straight

What is the seventeenth step in performing single braids with extensions?

continue braiding on opposite side of head, when you reach the crown area, the partings will create a V shape at the top of the crown

What is the twelfth step in performing single braids with extensions?

continue to braid to the desired length- the braid does not need to be secured

What is the thirteenth step in performing single braids with extensions?

create the next part above the previous section on a diagonal part moving toward the ear

What is the ninth step in performing single braids with extensions?

divide natural hair into three equal sections- place folded extension on top of the natural hair on the outside and center portions of the braid

What is the first step in performing single braids with extensions?

drape client for a shampoo, detangle the hair with a wide-tooth comb

What is the nineteenth step in performing single braids with extensions?

if using human hair extensions, apply styling foam and spray hair ends with water to activate the wave in the extensions and/or curl with barrel curling iron to create bounce

What is the twentieth step in performing single braids with extensions?

if using synthetic hair fibers, apply foam to hair ends, then dip hair in hot water for 10-15 seconds, towel dry and/or place client under hooded dryer to dry ends- shape ends to desired length with shears; secure ends with rubber bands if desired

What is the fourteenth step in performing single braids with extensions?

once several sections are complete, alternate the direction of the diagonal to start parting and braiding on the other side of head- complete sections using bricklaying technique

What is the fifteenth step in performing single braids with extensions?

once the back is finished, create a diagonal or horizontal parting above the ear in the front

What is the tenth step in performing single braids with extensions?

once the extension is in place, begin underhand braiding technique, cross outer strands under the center strand, bringing the center strand over tightly each time so the outside strand stays securely in the center

What is the first sixth in performing single braids with extensions?

part a diagonal section in back of head(abt 45 degree-ear to nape), if hairline is extended you may need to start below the ears to the nape- for medium-size braids this section can be 1/4 inch to 1 inch wide- depending on texture and length

What is the third step in performing single braids with extensions?

prepare extension fibers on a drawing board or tray

What is the eighth step in performing single braids with extensions?

select appropriate amount of extension fibers from drawing board or tray(extensions should be proportional to the section) for tapered ends, gently pull extension fibers at both sides so the ends are uneven, then fold fibers in half

What is the second step in performing single braids with extensions?

shampoo, condition, detangle, and separate the hair into four sections- apply blowdry cream then blowdry the hair completely

What is the fifth step in performing single braids with extensions?

use tail comb to part the hair across the crown from eat to ear- clip away the front section

What is the seventh step in performing single braids with extensions?

using vertical parts to separate the base into subsections, creat a diamond-shaped base