Section 3.1 Cisco Device Access

You need to connect a PC to the router console port to establish a console connection. For each of the parameters listed below, select the appropriate parameter to establish the connection.

Baud rate: 9600 Data: 8 Bit Parity: None Stop: 1 bit Flow control: None

Listed on the right are various connections between networking devices. For each connection, drag a cable type from the left to match it with the connection type.

Connect a workstation to a switch: Ethernet straight-through cable Connect a workstation to a console port on a Cisco device: Rollover cable Connect a hub to a switch: Ethernet crossover cable Connect a router to a switch:Ethernet straight-through cable Connect a switch to a switch: Ethernet crossover cable Connect a workstation to a router: Ethernet crossover cable

You are a field technician for a large company. You have been sent to a remote site to troubleshoot a downed router. When you arrive at the remote site, how will you connect your laptop to the router? (Select two.)

Connect the laptop's Ethernet port to the router's Ethernet port using a crossover cable Connect the laptop's COM port to the router's console port using a rollover cable.

Each connection in the Exhibit is labeled A-G. Drag the cable type from the left that you would use to make each connection type.

Connection A: Ethernet straight-through cable Connection B: Ethernet crossover cable Connection C: Ethernet straight-through cable Connection D: Rollover cable Connection E: Ethernet crossover cable Connection F: Ethernet straight-through cable Connection G: Ethernet crossover cable

You want to establish a console session to a new router using a Telnet session. Which of the following components will you need? (Select three.)

Ethernet cable Ethernet port IP address

Shown here is a diagram of the back of a sample router. If port C is the console port, what type of cable and connector would you use to connect to the console port?

RJ-45 rollover cable

You want to make a console connection to a router using the serial port on a PC. Select the necessary components to make the console connection. Select only the necessary components.

Rollover cable Console port Terminal emulation program