Chapter 3 - Sterilization and Disinfection
After removing used instruments from an examining room, immediately rinse them thoroughly under hot running water to remove organic material
false
An autoclave load is dried by cracking open the door approximately 6 inches
false
An instrument should be rinsed after a lubricant has been applied to it
false
Autoclave tape indicates whether an autoclaved item is sterile
false
Autoclave tape turns from white to black, which indicates that the autoclaved item is sterile
false
Daily care of the autoclave includes scrubbing the interior of the autoclave and the trays with scouring powder
false
If a minor office surgery setup is being wrapped, double layer of sterilization paper is often used
false
If an instrument has a movable joint, it should be placed in a slightly closed position when wrapping an instrument
false
Pouches should be placed on an autoclave tray with the plastic side up and the paper side facing down
false
Protective eyewear must be decontaminated using a high-level disinfectant
false
Sanitization involves a series of steps designed to remove all microorganisms and spores from the article
false
Sterilization is the process of destroying all forms of microbial life except for bacterial spores
false
Stethoscopes must be decontaminated using a high-level disinfectant
false
Store the packs in a clean, dustproof area with the most recently sterilized packs placed in front of previously sterilized packs
false
Tap water should be used in the autoclave
false
The agent used to destroy microorganisms on an article depends on the size of the article
false
The autoclave is typically operated at 15 pound of pressure at a temperature of 212 degrees F
false
The purpose of sanitization is to remove all microorganisms and spores from a contaminated article
false
The purpose of the Hazard Communications Standard is to make sure that employees do not use hazardous chemicals in the workplace
false
The wrapping material consists of a substance that prevents steam from reaching the instrument during the sterilization process
false
Warm tap water must be used in the autoclave because it prevents corrosion of the stainless steel chamber of the autoclave
false
A pack that has been in the storage cupboard for 4 weeks should be resterilized
false
A surgical instrument requires a longer sterilizing time than a minor office surgery pack
false
A wire brush should be used to clean the surface of each instrument
false
According to OSHA, gloves do not need to be worn during the sanitization process
false
A bacterial spore consists of a hard, thick-walled capsule the can resist adverse conditions
true
A sterilization indicator strip is placed in the center of the pack next to the instrument
true
After cleaning each instrument, rinse it thoroughly with warm water
true
An MSDS provides information regarding a chemical, its hazards and measures to take to prevent injury and illness when handling the chemical
true
An instrument cleaning agent that has expired loses its potency and should not be used
true
An instrument should be placed in the center of the sterilization wrapping paper with the longest part if the instrument pointing toward the two side corners
true
Before an article can be sterilized in the autoclave, it must first be sanitized
true
Before surgical instruments can be sterilized in the autoclave, they must first be sanitized
true
Ethylene oxide gas is used by medical manufacturers to sterilize disposable items
true
Glutaraldehyde (Cidex) is a high-level disinfectant
true
If a sterilization indicator does not change appropriately, the item is not sterile and must not be used
true
If an autoclaved pack shows any damage, such as holes or tears, the article should be rewrapped and resterilized
true
If the instrument is not completely dry following sanitization, stains may occur on the instrument
true
If the sterilization strips are outdated, they may provide inaccurate results
true
Instruments undergoing sanitization should be decontaminated by disinfecting them in an EPA-approved chemical disinfectant
true
OSHA recommends a 10% bleach solution for decontaminating blood spills
true
Small packs should be placed 1 to 3 inches apart, and large packs should be placed 2 to 4 inches apart in the autoclave to provide for adequate steam penetration
true
Sterilization of articles in the autoclave destroys all microorganisms and spores
true
The Hazard Communications Standard requires that the label of a hazardous chemical include information on how to store and handle the chemical
true
The autoclave packs must dry fully; otherwise, microorganisms can move through the moisture on a wet wrap and contaminate the sterile article inside
true
The best means of determining the effectiveness of the sterilization process are biologic indicators
true
The inside of the autoclave should be wiped every day with a damp cloth
true
The instrument disinfectant container should be labeled with the name of the disinfectant and today's date
true
The manufacturer's instructions specify how to dispose of the instrument cleaning solution
true
The pack should be marked with the date of the sterilization and your initials
true
The proper time for sterilizing an article in the autoclave depends on what is being autoclaved
true
The purpose of wrapping an instrument is to protect it from recontamination during handling and storage
true
The rubber door gasket should be inspected for damage that could prevent a good seal
true
The shelf life of a disinfectant indicates how long a disinfectant retains its effectiveness
true
The wrapper used to autoclave articles should prevent contaminants from getting in during handling and storage
true
Water contained in the water reservoir of the autoclave is converted to steam during the sterilization process
true