Eleven

Which technology supports the stateless assignment of IPv6 addresses? (Choose two) A. DNS B. DHCPv6 C. DHCP D. autoconfiguration

B. DHCPv6 D. autoconfiguration

Which two statements about IPv6 multicast addresses are true? (Choose two.) A. They use the prefix FC80::/8 B. If the lifetime parameter is set to 1, the route is permanent C. They identify a group of interfaces on different devices D. They use the prefix FF00::/8 E. If the scope parameter is set to 5, the route is local to the node

C. They identify a group of interfaces on different devices D. They use the prefix FF00::/8

Which two statements about the tunnel mode ipv6ip command are true? (Choose two.) A. It enables the transmission of IPv6 packets within the configured tunnel. B. It specifies IPv4 as the encapsulation protocol. C. It specifies IPv6 as the encapsulation protocol. D. It specifies IPv6 as the transport protocol. E. It specifies that the tunnel is a Teredo tunnel.

A. It enables the transmission of IPv6 packets within the configured tunnel. B. It specifies IPv4 as the encapsulation protocol.

Which two statements about 1000BASE-T UTP cable are true? (Choose two.) A. It uses four wire pairs B. It is most appropriate for installations up to 1000 feet in length C. It is most appropriate for installations up to 1000 meters in length D. Both ends of the cable can transmit and receive simultaneously E. It uses four wires

A. It uses four wire pairs D. Both ends of the cable can transmit and receive simultaneously

Which two statements about IPv6 address 2002:ab10:beef::/48 are true? (Choose two.) A. The embedded IPv4 address can be globally routed. B. It is used for an ISATAP tunnel C. The embedded IPv4 address is an RFC 1918 address D. The MAC address 20:02:b0:10:be:ef is embedded into the IPv6 address E. It is used for a 6to4 tunnel

A. The embedded IPv4 address can be globally routed. E. It is used for a 6to4 tunnel

When you troubleshoot an IPv4 connectivity issue on a router, which three router configuration checks you must perform? (Choose three.) A. Verify that the router interface IP address IP address is correct. B. Verify that the DNS is configured correctly. C. Verify that the router and the host use the same subnet mask. D. Verify that the router firmware is up-to-date. E. Verify that a default route is configured. F. Verify that the route appears in the Routing table

A. Verify that the router interface IP address IP address is correct. C. Verify that the router and the host use the same subnet mask. F. Verify that the route appears in the Routing table

Which device allows users to connect to the network using a single or double radio? A. access point B. switch C. wireless controller D. firewall

A. access point

Which two benefits are provided by using a hierarchical addressing network addressing scheme? (Choose two.) A. reduces routing table entries B. auto-negotiation of media rates C. efficient utilization of MAC addresses D. dedicated communications between devices E. ease of management and troubleshooting

A. reduces routing table entries E. ease of management and troubleshooting

Refer to the exhibit. Both switches are using a default configuration. Which two destination addresses will host 4 use to send data to host 1? (Choose two.) A. the IP address of host 1 B. the IP address of host 4 C. the MAC address of host 1 D. the MAC address of host 4 E. the MAC address of the Fa0/0 interface of the R1 router F. the MAC address of the Fa0/1 interface of the R1 router

A. the IP address of host 1 F. the MAC address of the Fa0/1 interface of the R1 router

Which three functions are major components of a network virtualization architecture? (Choose three.) A. virtual network services B. policy enforcement C. network access control D. network resilience E. authentication services F. path isolation

A. virtual network services C. network access control F. path isolation

Which IPV6 function serves the same purpose as ARP entry verification on an IPv4 network? A. interface ip address verification B. MAC address table verification C. neighbor discovery verification D. Routing table entry verification

C. neighbor discovery verification

Which command can you enter to verify that a 128-bit address is live and responding? A. traceroute B. telnet C. ping D. show ipv6

C. ping

Drag and drop the networking features of functions from the left onto the planes on which they operate on the right. Select and Place: data encapsulation device access establishes Telnet sessions filtering QoS routing state exchange ___________________ Control plane | | | Data Plane | | |

Control Plane: filtering routing state exchange device access Data Plane: data encapsulation establishes Telnet sessions QoS

Refer to the exhibit. A technician is troubleshooting a host connectivity problem. The host is unable to ping a server connected to Switch_A. Based on the results of the testing, what could be the problem? A. A remote physical layer problem exists. B. The host NIC is not functioning. C. TCP/IP has not been correctly installed on the host. D. A local physical layer problem exists.

D. A local physical layer problem exists.

A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch? A. More collision domains will be created. B. IP address utilization will be more efficient. C. More bandwidth will be required than was needed previously. D. An additional broadcast domain will be created.

D. An additional broadcast domain will be created.

When troubleshooting Ethernet connectivity issues, how can you verify that an IP address is known to a router? A. Check whether the IP address is in the routing table B. Check whether an ACL is blocking the IP address C. Check whether the IP address is in the CAM table D. Check whether the IP address is in the ARP table

D. Check whether the IP address is in the ARP table

Which Type of ipv6 unicast ip address is reachable across the Internet? A. Unique Local B. Compatible C. Link local D. Global

D. Global

What happens when an 802.11a node broadcasts within the range of an 802.11g access point? A. The access point transmits, but the node is unable to receive. B. A connection occurs. C. Both the node and the access point are unable to transmit. D. The node transmits, but the access point is unable to receive

D. The node transmits, but the access point is unable to receive

A network administrator receives an error message while trying to configure the Ethernet interface of a router with IP address 10.24.24.24/29. Which statement explains the reason for this issue? A. This address is a broadcast address. B. VLSM-capable routing protocols must be enabled first on the router. C. The Ethernet interface is faulty. D. This address is a network address.

D. This address is a network address.

Which configuration can you apply to enable encapsulation on a subinterface? A. interface FastEthernet 0/0 encapsulation dot1Q 30 ip address 10.1.1.30 255.255.255.0 B. interface FastEthernet 0/0.30 ip address 10.1.1.30 255.255.255.0 C. interface FastEthernet 0/0.30 description subinterface vlan 30 D. interface FastEthernet 0/0.30 encapsulation dot1Q 30 ip address 10.1.1.30 255.255.255.0

D. interface FastEthernet 0/0.30 encapsulation dot1Q 30 ip address 10.1.1.30 255.255.255.0