Gemini visuals test

If the system power button is pressed just after a train clears the lift, where will the train stop ?

"C" breaks

The track is divided into how many blocks ?

3

What do photo sensors do?

Control operations of all break sections Represents portion of safety systems Partially controls operations of the lift

If a loaded train is stopped halfway up the lift on B side due to a different situation, what should the control operator on A side do ?

Cycle A side empty and discontinue operation

The ride is in operation when a steady rain shower suddenly develops over the park. What should you do ?

Cycle empty as quickly as possible

What procedure should be followed if a lap bar cannot be locked in the station ?

Do not dispatch the train

What are the responsibilities of the control operator?

Ensure riders are secure in their seats and trains are safely dispatched Observing the monitors and train timer Observing trains on the track for any malfunctions or other situations

The operator hears a loud noise from the lift and observes the chain is not moving. What should they do

Push lift stop and allow the other train to return to the station

If someone reports a guest in a danger zone, operator immediately should,

Push system power

What should the operator do when an attendant gives the hold signal?

Release dispatch button and put both hands in the air

The block status lights will transfer from green to red when the block is

Set-up

What should operator do if a hold is called/ a problem is noticed but it is too late to stop the train in the station?

Shut off lift once train is above photo eyes

When the discrepancy buzzer/light is activated, the operator should

Stop dispatching

What procedure should be followed if a bad wheel is suspected on a train in the station ?

Stop loading train but do not dispatch train until approval from maintenance and management

The control operator receives the signal to dispatch a train but sees a child crying hysterically. What should they do ?

Tell crew to stand by, instruct attendant to check in child to see if THEY want to ride

When the control operator "sets" the trims/ safety brake:

The break is in safety mode

What will occur if the rights and left sides of each block do not agree?

A discrepancy will be registered in the safety system

Unless there is an emergency, the control operator can only answer or make phone calls when

A train is not moving in the station

What should the control operator announce over the PA if it's necessary to unlock restraints after oncoming riders have been seated in the train

Advise both guests and ride associates that restraints have been unlocked on purpose Direct ride associates to recheck seats once restraints are locked

How does the control operator acknowledge an associate crossing through a train?

Announces "crossing" over the PA Put both hands in the air

If "A" block is occupied, the station breaks may be released to dispatch the train:

At any time while the station photo sensors are blocked until the train reaches the entrance to "A" block

Under normal weather conditions with fully loaded what is the normal time you want the train to return from "C" breaks

Between 30-34 seconds

If the photo sensors in the trim/safety breaks are blocked the

Lift stops when the "B set" limit switch is tripped

What activates relays that register blocks as occupied or clear in the rides logic/memory system?

Limit switches

A discrepancy will occur when

Photo sensors are misaligned and does not direct the light beam to a reflector Spider blocks a photo sensor for 5 seconds

What should the control operator do if a ride attendant gives the 2 thumbs down signal?

Press emergency stop

The dispatch interval with 2 trains running on the track is when the

Previous train comes around the turn above the station

What procedure should be followed if a guest reports a lap bar unlocked during the ride but it can be locked in the station?

Tie-off the seat and continue normal operation

A "B" set will occur if a train has not cleared "B" block before the second train approaches the

Top of the lift

What area is not included in the operators defined visual confirmation?

Transfer track

When sending an empty train out onto the course, the control operator must ensure

Trim brakes are open

A "C set" will occur if a second train approaches "C" breaks before the previous train has cleared the

Trim/ safety breaks

A train in the station will cause the next train to stop at

Trim/safety breaks

In case of a power failure what should be done immediately to prevent the possibility of the ride restarting unexpectedly once the power is restored ?

Turn off control power switch and remove the key

What should the control operator do if a ride attendant gives the signal of one hand above the head palm extended

Unlock lap bars

Before rotating into the control operator position, ride associates must first

Verify the danger zone key is in the lock box Sign-in on the controls tracking sheet